Question about Cars & Trucks

1 Answer

My isuzu giga truck with a 6WA1 engine while running on the road the steering wheel suddenly lock up. what is the cause of the lock up?

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 450 Answers

Have seen mechanical issue inside steering box (balls that run on worm drive of input shaft jam due to wear) that causes steering to lock up, it means replacing the steering box

Posted on Jan 13, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

warlock61
  • 659 Answers

SOURCE: 2004 Ford F250 Superduty Truck Steering problems

I have had this same problem after thorough checking it ended up being a bad steering box. after replacing the box it was fine

Posted on Nov 22, 2008

  • 17 Answers

SOURCE: Steering wheel locks up at times while driving. Can I take the pin out?

try switching out the coulmn lock and check steering box and linkage

Posted on Sep 03, 2009

  • 2 Answers

SOURCE: My BMW 325i's steering wheel is locked and the car wont start.

Your steering column most likely is defective and you should be able to get this fixed under warranty. BMW discontinued this part in 2007. Its might go off if you put the key in the ignition and wait 5-10 minutes, but only maybe.

Posted on Dec 18, 2009

sscullys
  • 984 Answers

SOURCE: I have a 2004 ford f-150 off road 5.4 liter. My

If this is a 2004 Heritage ( old body style ) and the transfer case is known to lock in ( check with truck jacked up, shift into 4WD and try to turn front drive shaft ), the next item to look at is the vacuum disconnect motor for the front axle. This is on the front axle, and will move when shifted into 4WD
3b8c336.jpg


It is item #10, on this parts diagram
b48b167.gif
If you do not have movement in this, check the vacuum lines with a vacuum pressure gauge, to see if vacuum is being applied ( Pink line is 2WD w/ vacuum is operation, Blue line is 4WD w/ vacuum operation ). If no vacuum at the lines, check them back to the vacuum shift solenoids
b684463.jpg
4ef54b0.jpg

Posted on Jan 04, 2010

tripletauto
  • 1450 Answers

SOURCE: 1986 chevy c10 truck. pulled steering wheel to

THE horn piece should turn with the wheel lock plate. if it does not then something is not installed properly

Posted on Apr 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Giga 6wa1 engine. What are the causes of power loss?


sounds like a fuel problem check filter an pump

Nov 16, 2015 | Isuzu Cars & Trucks

1 Answer

4 wheel drive will not switch from 4 high 4x4 to 2 wheel drive


on dirt? off road or on the road (pavement)

on ice?

do say what the tires are touching. we cant see you drive.

this car has parttime 4wd, its not AWD nor full time 4wd.

sorry, its PT. and the rules for PT always apply.



Part time is not for dry ice free pavement, at all.

if you do this, it winds up the drive line and causes the gears to lock. and worse.

the lost operators guide explained all that.



and needs to back up to unlock the front axle locks.

one more pain.

4WD S model, which used manual hubs, get out and turn dial.



so if doing all this wrong, on dry ice free pavement???

move car to shoulder that has dirt ./sand or gravel on 1 or 2 right wheels, then shift out of 4wd to 2H

or damage the transfer case you will.

like this guy did.

turn steering only slightly off center to get to curb, or it gets worse.







http://www.rubicon-trail.com/4WD101/driveline-bind.html





symptoms of bad drivers.....using 4wd, PT.

steers gard

funny sounds (of death)

gears lock up in transfer case or even in the manual trans.

or far worse.

May 10, 2015 | 1995 Isuzu Rodeo

1 Answer

Steering wheel Lock When Driving


If you can still turn the wheel when this happens, the problem is usually with the power steering pump or the steering rack. First step would be to check the engine serpentine belt to make sure it is not slipping - if there is any sign of cracking or wear, replace it. If it seems loose, check the belt idler - it may be warn out and sticking.

Jul 02, 2017 | 2004 Chevrolet Malibu

1 Answer

1996 Rodeo steering wheel wont lock & wont start unless cranked all the way to the left


More that most likely it is caused bu faulty ignition. Sometimes easy to repair, or it will have to be replaced.

Feb 16, 2012 | 1996 Isuzu Rodeo

1 Answer

It is hard for me to steer while driving in my 2002 isuzu axiom


What you need to do:
1. Wheel Alignment done
2. Steering serviced, maybe power steering motor is not working. Do you hear rattle in steering while going over uneven road? if yes then whole steering assembly (rack n pinion) may need to be replaced.

May 07, 2011 | 2002 Isuzu Axiom

2 Answers

Isuzu 3.0 TD 2005 - Steering wheel makes squeking sound when turning steering wheel to both sides. Quiet on strait roads. Sounds like plastic rubbing when turning steering wheel. Sprayed lubricant on...


Disconnect steering column down by brake pedals and turn wheel with steering disconnected.....if squeak is still there its in the upper steering column bearings...squirt silicon spray down the top tube [below the steering wheel] until it runs out thru the tube lower bearing.
P.S dont forget to reconnect the steering!!!

Apr 06, 2011 | 2004 Isuzu Rodeo

2 Answers

1998 Isuzu Rodeo The key will not turn in the ignition. I can get it in and out. the steering wheel cant turn. What are my options to trouble shoot or repair


Try moving the Steering Wheel, put a little muscle into it. Some vehicles have a steering column lock that prevents the key from being turned if in the locked position

Feb 25, 2011 | Isuzu Rodeo Cars & Trucks

3 Answers

Wandering steering on Isuzu Bighorn


Why, of course, Get an alignment because your front end is too much in the positive caster. Don't let anyone tell you it's the nature of the beast. Good Luck. Ask for the before and after settings to be put on your receipt._Ned_

Nov 18, 2009 | 1992 Isuzu Trooper

3 Answers

Cannot get key to turn in jeep. Have already driven it numerous times today, suddenly can't move steering wheel or gear shift and key will not turn. Help!


Try turning the steering wheel (hard) right and left while turning the key. Steering lock , and ignition lock work in conjunction with each other.

Nov 06, 2009 | 2004 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...