Question about Suzuki Cars & Trucks

1 Answer

Car electronic ignition circuit

Why does 2007 suzuki sx4 electronic ignition lock up? Lights come but won't unlock the ignition assembly. Tried with key in but still the same, wouldn'y turn. Eventually fixed by rocking the car in gear but don't know why that would have any effect. Battery is still the original. Should it be replaced?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Suzuki Expert
  • 473 Answers

THe steering wheel can cause the lock cylinder to hang up - try to turn it left and right while trying to remove the key - it helps.

Posted on Oct 21, 2013

  • Rod Taylor
    Rod Taylor Oct 21, 2013

    Will see how I go if it happens again. Thanks for that.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2005 honda civic ignition tumbler

Take it to a locksmith. You don't want to risk pulling it down yourself especially where the immobiliser harness is concerned, in addition Honda tumblers are really hard to source, the defectives ones will have to be removed. You need an experienced locksmith to do this.

Posted on Aug 03, 2008

boysor2933
  • 293 Answers

SOURCE: keyless remote not working on my suzuki sx4

Try replacing the battery of your keyfob.

Posted on May 28, 2009

  • 58 Answers

SOURCE: Mercedes Benz c220 ignition will not turn.

Did you try jacking up the car at the front then wiggle the steering as you turn the key? Did you try a spare key? Spray inside the mechanism with WD40. Try putting the key in at different depths and turning.
The lock cylinder is a replace only item.

Posted on Feb 03, 2010

  • 24 Answers

SOURCE: 2007 suzuki sx4 emission control light on. 17000 miles

maybe the sensor is faulty, only having 17k miles on it i'm guessing that is what it is, get it looked at or changed

Posted on Feb 05, 2010

  • 1 Answer

SOURCE: ignition key will not turn, 2007 Nissan Murano

I am having same trouble with 2006 Murano. Ignition will not turn electronically. Manual key won't turn either.

Posted on Mar 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is evap actuator valve located on 2007 Suzuki sx4 2.0 ?


evap actuator valve
fuel evap system.
or HVAC, evap core. (expansion valve or aka, evap valve)
try to start a topic saying system
first
like fuel
or HVAC.

or 10 times better lead off with SYMPTOMS?

Apr 16, 2015 | 2007 Suzuki SX4

1 Answer

I have my key stuck in the ignition of my 2007 Buick Lacross. How do I get it out.


Sounds like the battery or the ignition switch has gone bad. The key won' release until the shift lock solenoid is energized to allow the key to turn all the way back.

Feb 23, 2015 | 2007 Buick LaCrosse CXL Sedan

1 Answer

How can I manually open the hatchback on my Suzuki sx4 2007? Why won't the fob work?


Is there a hood release by the drivers side? Like one for a regular trunk?

Oct 15, 2014 | 2007 Suzuki SX4

1 Answer

2004 Suzuki Gran Vitara Keyless entry


Try this

2004 XL7

1. Remove key from ignition switch.

2. Close all doors.

3. Open drivers door

4. Insert key and turn to ON position and within 10 seconds turn
key off and remove key.

5. Within 20 seconds Close and open drivers door 3 times.

6. Insert key and turn to ON position and within 10 seconds turn
key off and remove key.

7. Locks should now lock and unlock automatically to confirm you
have entered programming mode.

8. Press the UNLOCK button on remote and locks should cycle to
confirm programming.

9. Repeat step 8 on each additional remote.

10. Exit vehicle with keys and remote, close door test remote(s)

Jun 01, 2014 | 2007 Suzuki XL-7

1 Answer

2012 suzuki sx4 fuel pump on with ignition off


very dangerous.
and is caused by a double failure
the Fuel pump relay is bad and the power to it is stuck on.
very bad.
my online FSM has no schematics. its too new.
you need a real fsm or get help;
$4 day pass, see the pump, relay and power feed there.

https://suzukipitstopplus.com/Products/10305-2012-sx4-service-manual.aspx

these new cars with 14 computers are hard to diagnose.
the PCM sends a command to shut down pump, and can be ignored
the conundum is, did it send the command, did it get lost on the CANbus network or was the relay module asleep.
welcome to the digital age....

on the older Sx4, the key switch (ign. key) kills power to the pump relay and even if the relay welds closed, the pump will go down
key off, on new cars, even the key sends out commands. on the network (canbus)
im trying to build some cheap tools for this.... to see if the commands
were even sent.
is your car still under warranty? Suzuki is chapter 11.. so finding
dealers is a problem, in usa and now canada.
id sell it. but that's me.

Feb 06, 2014 | 2012 Suzuki SX4 SportBack 4dr Hatchback...

1 Answer

Cruise control stopped working when abs and flashing auto and check engine lights came on 2007 suzuki sx4


have the vehicle scanned for trouble codes[s] and when you have check engine codes remote start and some vehicles cruise will not work

Aug 15, 2017 | Suzuki SX4 Cars & Trucks

1 Answer

Ignition key will not turn, 2007 Nissan Murano


I am having same trouble with 2006 Murano. Ignition will not turn electronically. Manual key won't turn either.

Apr 10, 2009 | 2007 Nissan Murano SE

1 Answer

Redo code for 2007 Pilot key


ok get in the car, close the door, make sure all doors are closed.... put the key in the ignition, turn the key to on but without starting the car (lights on dash light up only) press and release the key lock button, turn key to off, without removeing the key.. turn to on without starting the car (dash lights up only) press and release the key lock button again, turn the ignition off, without removeing the key then turn back on (lights on dash on only without starting the car, press and release the key lock button , turn off the ignition without removeing the key, ..turn on the ignition once more without starting the car , press and release the key lock button and u should hear the door lock cycle ....leave the key in the ignition ... now press the lock button or unlock button on the other remotes one at a time if u have them.....u should hear the lock cycle indicateing all remotes are programmed.... kind of tricky to explain but you will get it, the sequence of turnin the key in the ignition on and off is only done with that one first key,,, remember after the door lock cyles press the lock or unlock button on the other remote fobs if if any...and ur done..may take u a few trys.. let me know how it worked out.

Apr 06, 2009 | 2007 Honda Pilot

1 Answer

Need radio code fro 2007 suzuki sx4 SN 0005283


Well the only way to get codes is by stopping in to Suzuki on the service drive and ask someone to get and put the code in and they will

Jan 30, 2009 | 2007 Suzuki SX4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...