Question about Cars & Trucks

2 Answers

Blinker lights not working on my dodge ram 1500 1996. Emergency lights work fine and fuse isn't the problem. No arrows turn on when turning the blinkers on but the emergency lights are working fine. Can anyone tell me what I should do?

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 51 Answers

If you can find one cheap enough and are confident that you can do the work, replace the multifunction switch.
It's the switch that you use to operate the blinkers.

Posted on Oct 21, 2013

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 103 Answers

I bet your blinker flasher is not working. Most likely it uses two flashers, my Intrepid did. Somewhere (probably near the fuse box) and likely under the dash you will see a board with relays and stuff plugged in. You will also see two round things, those are most likely the flashers. Swap them if they are the same, then your hazard lights won't but your blinkers will, at least until you get to the store to get a replacement.

Posted on Oct 21, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: Blinker issues

Probably the signal flasher or fuse or both.Should be a map in owners manual or on cover under dash, or under hood.

Posted on Jan 14, 2009

  • 59 Answers

SOURCE: turn signals and back up lights dont work.

Test the circuit board wires on the back side of your taillights where the bulbs go in to see if power is going there with the blinker on, if yes replace the circuit board (quite common with these trucks). If there is no power back there check your flasher relays for each turn signal, assuming they dont click off and on when you tip the turn lever. if all else fails, head for the multifunction switch behind your steering wheel inside the column that your turn signal/wiper/cruise control lever is connected to.

Posted on Mar 15, 2009

  • 4 Answers

SOURCE: 1989 chev blazer s-10 turn signals not working

junk it i got on to and i hate it

Posted on Apr 16, 2009

  • 122 Answers

SOURCE: Have light / blinker issue:

Sounds like wrong bulbs in some sockets

Posted on Feb 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a diagram for how to find the flasher in a 1999 dodge stratus..it's not in the fuse boxes


Simple method without mystery:
  1. Turn blinker flashers on;
  2. Listen for clicking;
  3. Find source of clicking. It is the flasher. :)
NOTE: Emergency flashers and blinkers usually use a separate flasher unit, but one is close to the other. If your blinkers do not work but your emergency flashers do, find the emergency flasher unit by finding the source of clicking, then locate the blinker flasher nearby. They will ALWAYS be underneath the dashboard on the driver side.

May 11, 2015 | 1999 Dodge Stratus

1 Answer

Why would the flashers work on a dodge ram but not the blinkers


If the blinker light is turning on but not blinking the most likely cause would be the turn signal relay. The hazard and turn signals have a seperate relay so this may be why one is working and the other not working. I do not have a diagram but I can tell you that both of those relays are directly in the fuse panel right under the steering column. I hope I was able to help

Jan 31, 2012 | 1996 Dodge Ram 1500 Club Cab

1 Answer

I have replaced all my blinker light bulbs and allthe fuses. Put in new flasher fuses and pulled blinker arm and replaced with kit. And the break lights and and blinkers still don't work


on the brake lights, check to be sure the switch located at the top of the brake pedal isn't stuck, you can Jumper the switch to see if that works,

Jul 22, 2011 | Dodge 400 Cars & Trucks

4 Answers

I have a 2006 dodge caravan and the rear turn signals will not work. fronts work fine, headlights and fog lights work fine. I checked all fuses and bulbs and none are burnt out. the turn lights on the dash...


Hello Durant.
Your rear signal lamps are turned on by the body control module (BCM).
You could have some broken wires from the BCM to the rear signals or the BCM isn't providing power to them. The BCM must be getting a signal input because the front ones are functional.
If you want to trace the wires here are the colors you are looking for.
Left rear wire is white/dark green.
Right rear wire is white/brown.
You may need to have your BCM scanned to verify.
If you would like more information to solve this yourself ask me.

Mar 27, 2010 | 2005 Dodge Caravan

1 Answer

2007 Ram 1500, the engine will not turn over after backing into


if turns over hit the reset button on the feul
if not there is a fuse under the hood check all fuses

Feb 13, 2010 | 2007 Dodge Ram 1500 Quad Cab Sport

2 Answers

My left break and blinker light don't turn on. I have a 2003 dodge neon. can this be a fuse and if it is which one is it?


If the left front light works,then you don't need a fuse you need a bulb for the left rear light.

Oct 22, 2009 | Dodge Neon Cars & Trucks

1 Answer

Turn Signals work intermitently on 2000 Dodge Ram 1500 Pickup


My turn signals worked fine until last night when I ran my battery down and had to get a jump. I realized right away that my turn signals suddenly didn't work. My theory hasn't been tested, but I am going to unhook my battery cables and reconnect again to see if that does anything. If not, I'll check out the steering wheel and that big square thing by the fuses. Thank you for all the posts and I was so happy to find this web page!

Dec 05, 2008 | 2000 Dodge Ram 1500 Truck

1 Answer

Blinker dont work flasher and other lights work


The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.

Oct 23, 2008 | 1995 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...