Question about 1998 Honda Civic

2 Answers

What does it mean when testing the main relay if the yellow with black strip goes from 10 to zero when the key is turned on? 1998 honda civic

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 162 Answers

What you are looking for is 12v coming out of the yellow and green wire. That wire is going to the pump. If you do to have that check for power at blue and white while cranking. If no voltage there while cranking check fuse 31 7.5a. Check for constant power at white and black wire. Black wire should be constant ground.

Posted on Oct 20, 2013

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

It is providing a ground to allow the relay to operate.

Posted on Oct 20, 2013

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 60 Answers

SOURCE: resetting 1998 honda civic remote control

ok here is the porcedure that i have for it

Remember , these steps must be preformed within 5 seconds of eachother also all doors should be closed, radio and lights turned off

im not sure what you mean by a bypass, you can always just not use the remotes and go into the body control computer and turn off keyless entry

1) Unlock Doors
2) Turn ignition key to "ON" position (II)
3) Press the "LOCK" or "UNLOCK" button on the remote
4) Turn the ignition key to the "OFF" position (0, I)
5) Turn the ignition key to the "ON" position
6) Press lock or unlock
7) Turn key to off position
8) on position
9) lock or unlock
10) off position
11) on position
12)lock or unlock - doors should cycle to indicate successful programming. If you only have one remote, turn ignition to off or don't touch anything. if you have 2+ remotes, go to 13:
13) lock on each transmitter that you need to program

*Steps 2-12 must be performed within 5 seconds of each other. Step 13 can be performed within 10 seconds of step 12.

Posted on Nov 22, 2008

  • 22 Answers

SOURCE: honda civic vtec 1995 - 1998 engine wiring diagram

Go to your local library and ask the Librarian to get you on-line to the Automotive Repair Reference Center, and then to the EBSCO database...you will find all of your wiring diagrams there.

Posted on Oct 07, 2009

  • 1146 Answers

SOURCE: My honda civic 1998 model fuel pump failed and I changed it

The PGM Main relay is outboard of the glove box. You can see it if you get the glove box out of the way, but to remove it, you need to pop the triangular shaped plastic trim off of the end of the passenger side of your dash. The relay is held in place with one 10mm bolt and the electrical connector.

Posted on Oct 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why doesn't this 2000 Honda civic lx turn over when everything else works inside the car?


Honda Civic Coupe Questions - car will not start. battery ok ...

www.cargurus.com > Questions > Honda > Civic Coupe

CarGurusJul 9, 2008 - Get someone to turn it over and see if it is getting spark. ... i have the same issue with my 1993 civic lx it has a 1.5 sohc non-vtec i changed ... comes wen the 2nd click of the main relay it doesn't occurs until after few minutes, few .... My 2000 Honda Civic Ex Vtec will not start, has a new tps, new throttle body, ...

Part 1 -How to Troubleshoot a No Start (1.6L Honda Civic)

troubleshootmyvehicle.com > Honda > 1.6L
Dec 31, 2012 - Difference Between a No Start and a No Crank Condition. ... can cause your 1.6L Honda Civic (Civic del Sol) to Crank but Not Start. ... In other words, the engine doesn't turn over at all. ... 1995, 1996, 1997, 1998, 1999, 2000.

98 Honda civic won't crank (PushStart) - YouTube

? 4:11
https://www.youtube.com/watch?v=X5W7OqjKB8I
Oct 21, 2013 - Uploaded by SkzDaniel
Honda Civic won't start or crank with the clutch but goes on when you push start it. ... 2000 Honda Civic LX with new battery and starter. Still will ...

2000 Honda Civic LX with new battery and starter. Still will ...

? 6:34
https://www.youtube.com/watch?v=p7KAO__nM1s
Aug 21, 2013 - Uploaded by Robert SnyperMD
2000 Honda Civic LX with new battery and starter. Still will not start. ... Crank, No Start Diagnosis Honda Coil test. - Duration: 11:17. by ...

Jan 05, 2016 | Honda Cars & Trucks

1 Answer

Where is the fuel pump relay on 1998 honda civic


its built into the main relay located at the drivers side kick panel , most of them are grey

Oct 20, 2013 | 1998 Honda Civic

1 Answer

1998 honda civic. fuel pump when key is turned on registers 10. volts then immediately drops to zero. did a tune up the day before. cap,rotor,plugs,oil and filter. drove 15-20 miles then died. checked fuel...


You should have close to 12 volts and then it drops to 0. That is the ecu priming the fuel system. Once you start yu should have 12v constant to the same wire. If your fuel pump is functioning ok, scan ur ecu for trouble codes. If there are no codes look into your coil and your icm in the distributor. Very commo for failure. Once the car dies, remove any spark plug wire on the plug side and put a plug into the end of it. Put the electrode of the plug close to a bolt on the valve cover and get someone to start the car, see if the plug is sparking. If it is you have a problem with fuel delivery, may not have injection pulse. You may also have a main relay failure

Oct 20, 2013 | 1998 Honda Civic

1 Answer

Low voltage fuel pump


check out for fuel pump relay or loose contacts

Oct 20, 2013 | 1998 Honda Civic

2 Answers

My 1998 Honda Civic will not turn over. The battery is good but when I try to start it I hear no sound. What could be the problem?


If you turn the key and you don't even hear a click, first I would check to see if you move the shifter from park through the PRNDL and back (assuming it is an automatic). If that solves the problem, it is a bad or misaligned neutral safety switch (as far as I know, it is not common on Honda's, but it is a quick test). Then, I would check the ignition switch and the main relay. The starter could be the issue, but usually they still click when they go bad. I believe that that generation of Honda Civic had some issues with the ignition switch. I have been told that the main relays of the 92-95 had problems that may have carried over to a limited amount of the next generation.

Aug 19, 2011 | 1998 Honda Civic

2 Answers

What fuse goes to the radio


Underdash, in the Fuse/Relay Box (cavity 26, 10 AMP), more details in the Service Manual Honda Civic (page 199 for Electrical) and Sound System Circuit Diagram in page 367.

i hope helped with this. Good luck.

Nov 12, 2009 | 1998 Honda Civic

1 Answer

My honda civic 1998 model fuel pump failed and I changed it


The PGM Main relay is outboard of the glove box. You can see it if you get the glove box out of the way, but to remove it, you need to pop the triangular shaped plastic trim off of the end of the passenger side of your dash. The relay is held in place with one 10mm bolt and the electrical connector.

Oct 20, 2009 | 1998 Honda Civic

1 Answer

1998 honda accord. obdII code 1167. what does this code mean is wrong?


this means you have an O2 sensor, heater circuit malfunction bank no. 2 sensor no.3 this should be the one on your exhaust system, under the vehicle around the catalytic converter. to test the heater circuit, you can use an ohm meter, unplug the connector and it should look like a/b top 2, c/d bottom two, check c/d with your ohm meter it should read 10 to 40 ohms, if it checks out ok, possibly the voltage is not reaching the sensor, check the connector to the sensor (yellow/black+) (green blue-) there should be voltage with the battery turned on, if there is not check th e main relay. Good luck, I hope this takes car of it.

Oct 01, 2009 | 1998 Honda Accord

2 Answers

Resetting 1998 honda civic remote control


ok here is the porcedure that i have for it

Remember , these steps must be preformed within 5 seconds of eachother also all doors should be closed, radio and lights turned off

im not sure what you mean by a bypass, you can always just not use the remotes and go into the body control computer and turn off keyless entry

1) Unlock Doors
2) Turn ignition key to "ON" position (II)
3) Press the "LOCK" or "UNLOCK" button on the remote
4) Turn the ignition key to the "OFF" position (0, I)
5) Turn the ignition key to the "ON" position
6) Press lock or unlock
7) Turn key to off position
8) on position
9) lock or unlock
10) off position
11) on position
12)lock or unlock - doors should cycle to indicate successful programming. If you only have one remote, turn ignition to off or don't touch anything. if you have 2+ remotes, go to 13:
13) lock on each transmitter that you need to program

*Steps 2-12 must be performed within 5 seconds of each other. Step 13 can be performed within 10 seconds of step 12.

Nov 11, 2008 | 1998 Honda Civic

Not finding what you are looking for?
1998 Honda Civic Logo

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...