Question about Cars & Trucks

1 Answer

I have a mazda mx3 93 and it won't start not even a click I but in a new starter and battery and it still won't start

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,760 Answers

Wow!! replacing all those parts and not doing the starter relay too (located near battery ) follow red wire from, battery to it

a simple 5 dollar voltage test light from any auto parts store is a great tool to help with problems like this . saves u from replacing lots of parts only the bad ones

Posted on Oct 20, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 24 Answers

SOURCE: 2004 A 8L won"t start

starter wont click because there's not enough "juice" to turn it over. this isnt because of the battery as you have just replaced it. it is due to a bad alternator recharging the battery as you drive. if it were only a fuse it would be the solenoid in the starter. but if it had started after you installed the battery then its not the solenoid. solution: buy a refurbished alternator and

Posted on Apr 24, 2009

swoop611
  • 488 Answers

SOURCE: 91 Buick Roadmaster wont start....... Baffeling

If the engine will not turn over using the starter then it cannot be the fuel pump. If the car has a factory inhibitor system installed, the chances are that it is this system that is preventing the car from starting. You may not have to press a button on the key fob either, it may have a transponder built into the key fob which transmits it's data at switch on.If you don't have the correct key or a key without a keyfob then the anti-theft system will NOT be disabled and the car will not start. There is no easy answer for this as you need the correct keyfob or you need to purchase and have programmed, the new keys.. If this is not the issue, let me know and I will describe further procedures for your issues..

Posted on Dec 07, 2009

  • 202 Answers

SOURCE: Mazda 3 -2006 will not start. Put in a new

check -clutch switch - ignition switch -ignition lock -neutral safety switch -starter relay starter hope this can help

Posted on Apr 18, 2010

sisadsl
  • 1508 Answers

SOURCE: 1998 Toyota Camry --- car intermittenly won't

When the bushes in a starter get worn, it can cause the armature to rub on the magnetic poles (poleing) This can cause the starter turn slow or not at all
The sintered metal bushes are like bearings. Not to be confused with carbon brushes which are the electrical connectors.
When a starter clicks, it is the solenoid you can hear.supplying power through the brushes.

A starter that is poleing,often stops in a place where it isnt rubbing, and works fine the next start.
There can be other problems with a starter , perhaps one of the brushes is sticking, or the solenoid.
When it happens a tap with a hammer on the starter or solenoid, while a friend turns the key, is enough to get it working( this isnt a fix but might get you started in an emergency)

There is also the possibility of a loose or dirty cable connection, from when the new battery was installed

Posted on May 09, 2010

  • 3640 Answers

SOURCE: i have a 2000 mazda protege just replaced starter

check the ignition coil, if the coil fails car will not start!! it provides the maximum voltage for the ignition system. but be sure starter solenoid is ok. have a great day!! if this is a 1.8 then get in touch with dealership it may be on the recall list. give vin number! (the 1.6 and 2.0 this recall has no effect on you). the recall is for 99 thru 2000.

Posted on Oct 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What would cause my 86 mazda b2000 to not start or even turn over, it's got a new starter on it & I've been told it could be an electrical problem, when I try to start it I can hear a click noise


If the battery is in good shape with a full charge, and all that happens is a click when trying to start, suspect a battery cable issue. Make sure the cables are clean and tight at the battery as well a tight at the starter. Make sure the ground cable from the battery to the engine is clean and tight supplying a good ground as well

Mar 02, 2016 | 1986 Mazda B-Series

1 Answer

1988 Mazda RX7 won't start, just clicks


check battery and connection.could be starter try to tap the starter.tune up.

Mar 09, 2013 | Cars & Trucks

1 Answer

Z28 starter won't start.


security system, ignition switch, neutral safety switch

Jun 29, 2012 | 2002 Chevrolet Camaro

1 Answer

1989 MAZDA MPV NO CRANK NO START STARTER TESTS GOOD.


Assuming you've checked the battery for a possible short and both the battery and the starter for loose connections, no click sounds like a faulty starter solonoid, which could work intermittently.

Jan 06, 2012 | 1989 Mazda MPV

1 Answer

Car won't start. New battery installed recently. Only clicks when trying to start.


one single click any time you turn the key usually indicates a bad solenoid on the starter. A new starter will typical get you going.

A series of rapid clicks when you try to start usually indicates a weak battery. There could also be a bad connection at the terminals on the battery or even a poor connection at the starter.

If you get a single click and everything goes dead for a couple of seconds than you definitely have a bad connection at the battery.

Let me know what you find or if you have any questions.

Dec 28, 2011 | 2007 Chevrolet Tahoe

1 Answer

Just replace my battery and starter on a 2001 mazda protege and it still does not start just clicks what can be the problem


Since they are new you need to carefully check the connections at the battery, the starter, and the ignition switch and look for damage wiring. Rare, but new batteries can be bad, check your voltage resting (should be about 12.6+) and cranking/clicking (above 10.4), If either are low, you have a bad connection, bad battery or bad starter, even if new.Measure at the battery and at the starter positive connection to see if you have a clamp or cable issue.

Oct 04, 2011 | 2001 Mazda Protege

1 Answer

My darango won't start, replaced that alternator and relays. starter is still good. but it won't even click over.


this could be as simple as a bad battery have you tryed to jump start it? if you try and that dosent work make sure you have power going to the starter with jumper cables on the battery. it should at the very least make a clicking sound while trying to start it check the battery posts also make sure they are clean and if it does click give it a minute and try starting it again.[ dont take the cables off the battery while waiting] the fact the starter doesent even click when you try to start it tells me no power to it or bad starter remember just because its new dosent mean it works i cant tell you how many times i have put somethig on a car and had to take it back off because it didnt work from the boxx new. and make sure the starter wires are tight and clean. if no clicking and you have power to starter then starter is bad.. i hope this helps..

Jun 04, 2011 | 2006 Dodge Durango

1 Answer

My 99 mitsubishi galant won,t start battery is brand new and it still won't start it clicks like the battery is dead I even tired jumping starting land it still won't start


either you have a bad connection to your battery or,, you have a bad starter. no other solution. if it clicks when you try to start it and the batterys fully charged,you're getting fire to the starter and it's trying to start,but the starter bendix isn't kicking out.which means it's a bad starter. thank you for choosing fixya.com

Mar 27, 2011 | Mitsubishi Galant Cars & Trucks

2 Answers

1993 mazda navajo will not start, all i get is click click i have a new battery and have checked all cables


With my 93 Navajo I have experienced:
  • Dirty connection(s)
  • Starter solenoid
  • Positive cable - hidden corrosion inside cable jacket
  • Negative cable
And always test the battery, even if relatively new.
kpfrlewajveq0aaaaasuvork5cyii%3d

Sep 03, 2009 | 1993 Mazda Navajo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...