Question about 2006 Chrysler Town and Country

1 Answer

Heating system is not working correctly , a little heat is coming out, turns cold,but has A/C.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Check the pollen filter if fitted if not does air come through at all if only slowly then pipe is blocked if always cold check coolant levels in radiator

Posted on Oct 20, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 Lincoln MKS Heated Seat on driver's side stopped working (Light in button turns off on its' own)


The most common cause of this problem is that the drivers seat heater grid is open or burned out. That is based on 25 years as a Ford dealer technician.

Feb 27, 2017 | Lincoln Cars & Trucks

1 Answer

No heat in the car


Change back to the correct t-stat, the main air door thermistor that goes from hot to cold is stuck or going bad or some cases the dash temp control is going out.

Dec 02, 2013 | 2005 Nissan Altima

1 Answer

Heating system do not work. It started a couple of weeks ago. When set at 70, it produced no warm air. cold air would come from the vent/duct. when increasted to about 76, it would produce heat. Now it do...


I have the exact same problem. Started occasionally blowing cold air. Now I can't get the hot air to come through. Could it be a flapper door that open and closes depending on the tempurature setting?

Jan 04, 2011 | 2006 Lincoln Mark LT

2 Answers

The heater only blows cold air,the radiator is full,thermastat is working and the engine temp is within normal ranges.


I've had this problem. 2000 GMC uses a closed coolant system. Meaning takes and returns coolant from and to the Reserve Bottle and has little air in the engine and heater systems.
If everything appears ok but no heat. "Air Lock" is the most likely cause. (With interior heater set to full heat) Solution; 1. Make sure water pump works. 2. Drain about 1/2 engine coolant into container. 3 Remove both heater hoses from engine side and flush heater core in both directs through heater hoses with garden hose. 4. Reattach heater hoses in correct locations. 4. Refill engine with coolant. 5 Start engine and run for 2 min., use caution when topping up coolant.
6. Most 2000 GMC have twist off caps with plugs located mid way on heater hoses. with engine cold, start engine these caps may be loosened to allow trapped air to escape. Do not attempt with engine hot due to hot coolant injuries. This may take more than one attempt to remove all air from heat system. 7. Lastly most 2000 GMC water pumps have a bleeder plug,( 3/8" square driver plug) located on the water pump. With egine cold this plug should be removed to remove any air. Reinstall plug with thread sealant.
Hope this helps cheers

Dec 09, 2010 | 2000 GMC Jimmy

1 Answer

Very little heat from heater truck can be running for long time very little heat comes out


You HVAC unit is not getting the heat from your engine coolant. A valve is stuck or there is blockage in the heat exchanger core. I'm assuming you fan and vent divertors/Controls are working correctly. Does AC work?

Jun 13, 2010 | 2000 GMC Sierra

1 Answer

Soon as i turn on my heat my cooling fans come on first


It sounds like you do need a thermostat with your heat shut off and the gauge will raise a little then the car doesn't have that heat drawn from it indicating that you most likely do need a thermostat. As far as the fans coming on immediatly that could be a different problem it is most likely the coolant temperature sensor that tells the fan's when to come on. If this sensor says the coolant is hot the fans will come on immediatly. These are seperate problems as the coolant temperature sensor does not have anything to do with the cabin heating system. You should first check the level of your coolant is full, This could also cause your cabin heating system to perform poorly, and may have adverse effects to the engine cooling system. (fans)

Dec 31, 2009 | 1995 Nissan Maxima

2 Answers

New heatercore but no heat flushed system out but still no heat the dash gets hot but very little heat comes out when on for awhile the fan works just blows cold air


Did you run engine from cold, with heater on when you refilled the system? Try again, rad cap off, with heater on, and let engine get up to operating temperature, make sure you have good flow through rad ,leave cap off, until rad fan comes on to cool returning coolant to rad at least twice. Give engine a little extra rev, for 5 seconds or so, every once in a while to make sure flow getting through heater core, and add coolant as necessary. See if that helps, as it may just be an airlock in system. If your cooling system has any bleed screws incorporated, crack them once in a while as well.

Nov 05, 2009 | 2000 Oldsmobile Bravada

1 Answer

Low Heat on 1999 Mercury Cougar


I had the same problem with my 199 cougar 2.0 4 cyl.
The problem was air in the cooling system.

I had to bleed the air out of the system, and now the heat
works much better.

I put a flushing tee between the back of the thermostat and
the heater core, and made sure that water flowed out of there.
Then I disconnected the small hose from the top of the coolant
resevoir, and poured water into it using a funnel until the coolant
level started to rise in the coolant resevoir. Then started the car, left the radiator cap off, and let it come up to temperature (thermostat open)
then over a period of about 5 minutes, periodically "goosed" the engine to clear any remaining air bubbles.

The heat is MUCH better now.

Oct 17, 2009 | 1999 Mercury Cougar

1 Answer

Cold air blows instead of hot once heat is engaged


Check the coolant level in the car first off and make sure it is at the correct level and you have plenty in the reservoir. Find the little bleeder screw on the thermostat housing should take an 8mm wrench to open. Start the car and turn the heat on high while the car is running open the bleeder screw and watch for the air to come out leave it open until it pushes out solid coolant without air bubbles in it. Make sure to keep the coolant level up while doing this, the heat should start working. Once all the air comes out shut the bleeder screw.

Oct 04, 2009 | 2000 Oldsmobile Silhouette

2 Answers

Car will not heat up


Did you "bleed " the system when you filled it with coolant ? You have to put in a some coolant and water.1/2and 1/2 mixture, Make sure it is the right coolant. All color coolant works fine.Rune the vehicle for a while . Turn off the vehicle and let it cool. Turn the radiator cap and a hiss of air will come out. Use a Rag . Be careful not to burn yourself. The pour some more coolant and water . And repeat the process until radiator is full. Some cars have a bleeder valve that you turn counter clockwise with a screwdriver near the thermostat housing or near the radiator hose .

Jan 09, 2009 | 2001 Dodge Neon

Not finding what you are looking for?
2006 Chrysler Town and Country Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...