Question about Cars & Trucks

1 Answer

Starter Removal on a 2.2 liter motor in a 93' dodge shadow

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 20,706 Answers

Most cars
pull neg battery term.
remove easy to remove things in the way then
1:solenoid wires off.
2: unbolt starter, it falls out. if this dont play
try
alldata.com

Posted on Oct 20, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: 1993 Dodge shadow died while being driven, won't restart

try the transmision you may have to replace it

Posted on May 26, 2009

polarcycle
  • 1392 Answers

SOURCE: Where is the engine fusebox located on a 3.0 liter

There is a fuse box under the dash on the drivers side. You only have fuseable links under the hood. If one blows, you may be able to have someone solder in a new link.

Posted on Aug 14, 2009

  • 160 Answers

SOURCE: starter removal on a 1990 toyota 4 runner. Where

it is not fun w/o lift look behind passenger wheel you will need to raise front end remove wheel ,remove skid pan,and of course battery ends if 4wd I highly reccomend a lift good luck and please rate this

Posted on May 05, 2010

  • 15 Answers

SOURCE: I cant find the starter

Starter is located in the back of the engine attached to the transmission, it is held in with 2 bolts and 1 nut on a stud... disconnect the battery before you start or else you might get some good sparks... getting to it can be a real knuckle buster... good luck.

Posted on Jul 23, 2011

emissionwiz
  • 77169 Answers

SOURCE: automatic transmission serial number location for 1994 dodge shadow 2.5 liter engine 3 speed

It is on a tag on the outside of the transmission case, you will need to raise the car to see the tag.

Posted on Feb 12, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What's your problem?why does my 93 dodge shadow smoke so bad


Could be a worn engine or faulty PCV valve.
3.0 V6 engines were known for cylinder rings and block problems. No easy fix for that.

Jun 26, 2012 | 2004 Honda Accord

1 Answer

I cant find the starter in my 93 dodge shadow?


Starter is located in the back of the engine attached to the transmission, it is held in with 2 bolts and 1 nut on a stud... disconnect the battery before you start or else you might get some good sparks... getting to it can be a real knuckle buster... good luck.

Jul 23, 2011 | 1993 Dodge Shadow

1 Answer

Tools needed to remove starter on 94 dodge spirit 3.0 liter V6


Regular socket wrench set, wrench set, screwdriver, etc.: REMOVAL & INSTALLATION Fig. 1: These three attaching bolts hold the starter motor to the engine/transaxle assembly - all models 86722051.gif
  1. Disconnect the negative (-) battery cable. Raise and safely support the front of the vehicle on jackstands. Remove the engine undercovers, if so equipped.
  2. Remove the 3 bolts attaching the starter to the engine/transaxle. CAUTION
    Be careful when removing the starter motor mounting bolts, the motor can be quite heavy. Personal injury could result if the starter motor falls from its mounting position.
  3. Remove the heat shield and its clamp, if so equipped.
  4. Remove the two electrical wire connector terminal nuts and remove the wiring connector from the starter.
  5. Remove the starter from the vehicle. To install:
  6. Clean all wire terminals of dirt, grease or corrosion.
  7. Attach the electrical wire connectors and secure with the mounting nuts. Tighten the starter solenoid B+ nut to 80 inch lbs. (9 Nm) and the solenoid wire-to-starter nut to 55 inch lbs. (6 Nm).
  8. Install the heat shield if one was removed.
  9. Hold the starter motor in place, then secure in place with the 3 attaching bolts. Tighten the bolts to 40 ft. lbs. (54 Nm) for all vehicles except Premier and Monaco. Tighten the attaching bolts to 20 ft. lbs. (27 Nm) for Premier and Monaco.
  10. Install any undercovers which were removed from the vehicle.
  11. Lower the vehicle.
  12. Connect the negative (-) battery cable. Fig. 2: After disconnecting the starter's electrical wiring, remove the 3 mounting bolts . . . 86722p15.jpg
    Fig. 3: . . . then the starter motor can be lowered from the underside of the vehicle 86722p16.jpg
prev.gif next.gif

Sep 24, 2010 | 1991 Dodge Spirit

1 Answer

Starter removal


I have given the step wise instructions for how to remove the starter:

1. Disconnect the cable from the negative battery terminal or the remote ground terminal.
2. Raise the vehicle and support it on jackstands.
3. Remove the engine protection cover from below the engine compartment.
4. Remove the air filter housing.
5. On vehicles equipped with automatic transaxles, remove the transmission control module (TCM) from its mounting and position it out of the way. Note: DO NOT disconnect the electirical connector from the TCM.
6. Remove the starter motor upper mounting bolt.
7. Clearly label and disconnect the wires from the terminals on the starter motor solenoid.
8. While supporting the starter motor, remove the lower mounting bolt and withdraw the starter motor from the vehicle.

Installation is the reverse of removal.

Aug 18, 2010 | 2001 Dodge Stratus

1 Answer

Where is the engine fusebox located on a 3.0 liter 93' Dodge Shadow


There is a fuse box under the dash on the drivers side. You only have fuseable links under the hood. If one blows, you may be able to have someone solder in a new link.

Aug 14, 2009 | 1993 Dodge Shadow

2 Answers

I need a belt routing diagram for a 93 dodge shadow


OK I'M ASSUMING YOU HAVE THE V6, IF SO YOU NEED TO FOLLOW THIS DIAGRAM: 5P023 (Diagram number) -AND THE FOLLOWING LINK WILL TAKE YOU TO A PDF THAT YOU CAN SCROLL DOWN AND FIND THAT DIAGRAM:
http://oskin.ru/pub/chrysler-dodge/manuals/Mopar%20Catalogs/2003_Mopar_Belts_Hoses.pdf

Jun 28, 2009 | Dodge Shadow Cars & Trucks

1 Answer

1993 Dodge shadow died while being driven, won't restart


try the transmision you may have to replace it

May 26, 2009 | 1993 Dodge Shadow

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...