Question about 2006 Volkswagen New Beetle

1 Answer

The Coolent warning light in blue stays on for a long period after starting and then comes back on again for certain lengths of time during longer journeys. Sometimes it also flashes on and off. We topped up the tank but this has not made any difference.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 100 Answers

Sounds as if your thermostat may be stuck in the open position, causing it to run too cool. The car runs optimally at a certain temp if the PCM (computer) sees a temp lower than it should be the light comes on. Or the temp light is just plain faulty (crossed wires,bad ground etc)

Posted on Oct 20, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 181 Answers

SOURCE: blue light stays on in my 2000 beetle sometimes flashes

Not certain, but you may be referring to the blue light that indicates when the water temperature in the cooling system is "cold". It's typically blue when the car first starts, then changes color when the water temperature rises. If the light remains blue the water temperature isn't heating up, and you may want to have the cooling system flushed and checked. Depending upon the cars mileage, it may be time to flush the cooling system anyway.

Posted on Jun 22, 2009

keemo68
  • 1263 Answers

SOURCE: A couple of problems - Headlights, airbag, temperature

did you go through all the checks i suggested?

Posted on Aug 29, 2008

  • 12 Answers

SOURCE: Temperature warning light coming on,on a 1992 Volkswagen Golf GTI

The thermostat will show what the guage shows. the seal on the coolent bottle can be checked for tightness. so it could be a faulty sensor?

Posted on Apr 28, 2009

  • 57 Answers

SOURCE: My ABS, brake and oil lights keep coming on at the

Its exactly the abs module! and its keeping the ecu from communicating with the rest of the car, when you remove the module your tac will come back alive and the oil light will turn off. There is way to trick the ecu to thinking the abs module is working but it involves taking out the module, it is fairly simple. My email address is superbikevoodoo@yahoo.com, email me, and I will give you pictures and instructions on what to do. Its really easy, your abs and break light will go off along with the beeping!

Posted on Dec 11, 2009

  • 25 Answers

SOURCE: Blue coolant light comes back on and flashes? why

The light should be for a low level sensor in your coolant reservoir. Check your coolant level (when vehicle is cold), if fluid level is ok then the sensor is probably the culprit.

Posted on Mar 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sport


Hi Maury, Seems you have a number of different problems at the same time. The grinding sound when pushing the clutch pedal would seem to be the clutch thrust release bearing, which is located inside the bell housing and requires the removal of the gearbox to replace. The warning lights should come on each time the ignition is switched on and then they should extinguish after a few seconds. The illumination of these lights is a fail safe system to show that all warning systems are active. The radio will go off during the period when the starter is engaged as a relay shunts all power to the starter during that procedure. The starter motor uses more power from the battery than any other system. The manufactures have taken this into consideration when designing the circuitry and decided as many others have, to adopt the operation. If when starting from cold this does not happen and the radio plays, it is indicating either excessive drawing of power by the starter and may also be the cause of the grinding noise you experience? Regards John

Jul 21, 2013 | 2000 Jeep Wrangler

1 Answer

Ive just bought my audi a4 S.E 1.8 petrol 1998.. with 164k...when i bought it the abs lightt was on and also the brake warning indicator light comes on and stays on flashing,and at the same time the abs...


as the mot only says the "brakes work"to a certain efficiency,(the tester does NOT check the depth/thickness of the pads),chances are your pads/discs are in need of replacement.the pads have sensors in them for wear depth, so when checking the pads,front AND rear the abs sensors can be cleaned,and if done by a seat/skoda/vw/audi dealer they can put it on the diagnostic computer to give you a definative answer (this is cheaper than guessing) I replace the pads myself but get the car "diagnosed"when any red light shows.

Jan 31, 2011 | Audi A4 Cars & Trucks

1 Answer

MY air baglight is going on in my 2002 taho, the dealer ship claims they can't find anything wrong with it, but it's going on for a reson


{: ) Normally, the airbag light will come on when you start your vehicle, and it will flash for a few seconds. Then the light should go out. This means the system is ready. This is the initial system check.
What is not normal is if it stays on after the system check or when the airbag lights come on while you are driving. That means a trouble was detected by the system and will request the airbag light on.Your airbag system may not function properly during this period.
However, if the conditions that set the fault no longer exist at one point or during a certain period, the system will automatically clear the warning light. This will also mean that your airbag system will work normally as expected.
If the dealer coudn't retrieve a code or unable to duplicate your concern, and find the system to be working as designed, certainly they will have to release your car. If you are the only witness and the problem still persists as you believe, your feedbacks on your next possible visit can be of great help in their diagnosis.
You can note down some other symptoms or instances of what actually transpired before or when the airbag light came on. For example, as when you move or adjust your seat, or when you put something underneath the seats, when you pulled the seatbelt, when you moved the steering wheel and pressed on the horn, or like when your rearview display is not normal, when you open the liftgate or hood, or does it come also with another warning light or message, and anything. The technician can only do shop tests, and he can't drive your car for so many days trying to duplicate the concern. It's always you with your vehicle most of the time, and driving on different road conditions.

Jan 20, 2011 | 2007 Chevrolet Tahoe

1 Answer

Warning light "check ride control"


all warning lights come on during start up. its a test to insure all lights are working. if the light stays on longer than it should you may have a leak in the system somewhere. you can check for leaks with a spray bottle filled with soapy water. on top of the compressor and at the top of the airbags are a common area for leaks.

Oct 04, 2009 | 1995 Lincoln Continental

1 Answer

Intermittent electrical fault Saab 9-5


Check connectors,pins grimping force,bad contact between pins in main plug connector(abs unit)or connectors near pilar A left.
Good luck!

Sep 29, 2009 | 2000 Saab 9-3 Viggen

1 Answer

Warning lights on dash come on after runing it a short period on


some sort of sensor ie..lambda probe.maf sensor .mas sensor..best bet to get it pluged in for diagnosis an fault codes this is the only way to find out the real fault hope this helps..

May 21, 2009 | 1990 Isuzu Trooper

1 Answer

Enhanced Traction System Warning Light (TRAC OFF)


i have the same problem, dealer says its the trac sensor on one of the front hubs . to fix the problem you have to replace the wheel bearing assembly. you cant buy just the sensor, dealer wants 400.00 do it yourself for 100.00 or less shop for parts on line or cover the light with black tape it will not hurt anything

Jan 26, 2009 | 2001 Oldsmobile Alero

1 Answer

1997 BMW 318iS manual coupe - fuel warning light stays on


The last comment added to thread should work OK.

Jan 07, 2009 | 1997 BMW 318

1 Answer

Engine Management light


you will need to have the codes pulled it could be many other sensors or problems being detected

Sep 23, 2008 | 2002 Hyundai Accent

Not finding what you are looking for?
2006 Volkswagen New Beetle Logo

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...