Question about 2010 Dodge Journey

2 Answers

Horn won't stop honking dodge journey - 2010 Dodge Journey

Posted by Anonymous on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Replace horn switch under air bag part no 05189428AC

Posted on Aug 03, 2014

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Horn pad contacts to sensative replace horn contact
Douglas Jeep Venice Florida

Posted on Aug 23, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 534 Answers

SOURCE: 1992 Dodge Ram 50: Horn honks all by itself.

Check the horn actuating contact at the centre of the steering wheel. It may be damaged or mis-aligned.
Also check the carbon contact that runs on the slip ring under the steering wheel (associated with steering wheel horn actuate switch) It may be damaged or mis-aligned.

If none of the above are faulty, you should look for a possible intermittent short to ground on the horn actuation control wiring.

Posted on Jun 12, 2009

  • 77 Answers

SOURCE: I have a 1997 dodge ram 4x4. The two round parts

its possible the horn itself burned out after being on for so long.

Posted on Nov 01, 2009

johnjohn2
  • 5763 Answers

SOURCE: My horn hasn't worked in over 8 months and now all

This sounds like a bad horn relay or the horn pads is bad,i would start by disconnecting the horn pad,caution with airbag,but if you remove the steering wheel cover and dissconnect horn button wires and then drive if horn still blows then you havea bad relay, if it doesnt blow anymore then the pad is bad ,

Posted on Jun 08, 2010

  • 1565 Answers

SOURCE: I have a 1996 dodge

In most cases this problem is caused by the rotating ribbon circuit contact under the steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to disarm the airbag system can result in an unexpected Airbag deployment and possible serious personnel injury disconnect the battery 30 minutes prior to start of work

Posted on Oct 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the horn because it keeps going off


open the hood and look in the under hood electrical fuse relay center should be a relay that is marked horn or you can pull the fuse marked horn.must likely its the air bag on steering wheel.it coukd be the alarm but you would have to take to shop or get a book to help you, good luck

Jun 03, 2015 | 2000 Dodge Stratus

2 Answers

1997 dodge caravan horn started honking when it stopped van wont stay running.


Security engaged, Lock and unlock doors with key until horn stops.

Feb 09, 2014 | 1997 Dodge Caravan

1 Answer

The horn in my 1999 dodge stratus keeps honking


the reason it is doing that is either the pad on the steering wheel is shorting as if you are pressing on it, or the clockspring under the steering wheel is shorting to ground. there is a horn relay in your fusebox inside the cabin; you could disable it there by pulling out the relay. don't pull the fuse because it carries other circuits as well. I couldn't find the exact relay position, but just feel them with your finger while someone honks the horn; the one that's clicking with the horn activation is the one to pull out. I can get you the layout of the fusebox but you really don't need it for that.

Mar 04, 2013 | 1999 Dodge Stratus

1 Answer

2005 magnum RT horn starts honking on its own and car won't start


alarm its self goosed may have to take it to an auto electrition to disconect the old alarm

Aug 24, 2012 | 2005 Dodge Magnum

1 Answer

I just replaced my turn signal switch in my 82 not 84 rampage. it works fine but when I replace the steering wheel, the horn honks and won't stop.when I look at the switch, I don't know how it...


I don't have a diagram, but if I understand what you're saying, there is a copper ring at the top of the steering column, visible before you install the steering wheel. The copper pin is connected to the horn button. The intent being that when you press the horn button, it completes the ground from the steering wheel through the horn button, through the pin, to the copper ring.
If this is correct, there should be no contact between the steering wheel and the copper ring other than the pin. Check to see if there may have been a spacer (washer, etc) below the steering wheel on the steering shaft that holds it just far enough away from the copper ring so that only the copper pin makes contact.

May 01, 2017 | Dodge Rampage Cars & Trucks

1 Answer

My horn hasn't worked in over 8 months and now all of a sudden when I'm driving it just keeps honking and won't stop on my 1999 dodge caravan


This sounds like a bad horn relay or the horn pads is bad,i would start by disconnecting the horn pad,caution with airbag,but if you remove the steering wheel cover and dissconnect horn button wires and then drive if horn still blows then you havea bad relay, if it doesnt blow anymore then the pad is bad ,

Jun 08, 2010 | 1998 Dodge Caravan

1 Answer

1992 Dodge Ram 50: Horn honks all by itself.


Check the horn actuating contact at the centre of the steering wheel. It may be damaged or mis-aligned.
Also check the carbon contact that runs on the slip ring under the steering wheel (associated with steering wheel horn actuate switch) It may be damaged or mis-aligned.

If none of the above are faulty, you should look for a possible intermittent short to ground on the horn actuation control wiring.

Jun 12, 2009 | 1992 Dodge Power Ram 50

1 Answer

When I lock the door on my 99 dodge durango with the keyless remote the horn won't honk. But if I push the panic button the horn does honk. How can I get the horn to honk when I lock the doors?


Look in your manuel, there are steps to change the Key less remote setting to customize it the way you'ld like the car Key less system to work.
Good luck and hope this helps, if your still having problem. Just drive the Dodge dealer and ask the Service adviser to help you out, he or she would be more then happy to reprogram the key less system for you.

May 13, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
2010 Dodge Journey Logo

Related Topics:

2,977 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...