Question about Hyundai Santa Fe
I have just replace the battery of hyundai santa fe 2011 and the starter light on dash doesnt want to go off
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?
Posted on Oct 28, 2008
The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.
Posted on Apr 06, 2009
This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.
Posted on May 22, 2009
you may have damaged the ABS sensor or wire to the sensor up front check the wire that runs from the inner finder well and make sure it connected to the ABS sensor on the spindle
Posted on Jul 15, 2009
Tips for a great answer:
Feb 16, 2017 | Hyundai Cars & Trucks
on Oct 24, 2013 | Hyundai Cars & Trucks
Jan 02, 2017 | 2005 Hyundai Santa Fe
Mar 16, 2016 | 2011 Hyundai Santa Fe
May 08, 2015 | 2006 Hyundai Santa Fe
Feb 19, 2015 | 2011 Hyundai Santa Fe
Jun 25, 2014 | 2004 Hyundai Santa Fe
Sep 21, 2009 | 2001 Hyundai Santa Fe
Jul 24, 2009 | 2003 Hyundai Santa Fe
27 people viewed this question
Usually answered in minutes!