Question about Cars & Trucks

Open Question

What is the Immobilizer brake code for my 2001 Honda Accord?

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 11 Answers

SOURCE: need radio code for 2001 honda accord lx

*** Please click the "Was this helpful" Yes thumbs up! ***

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ingnition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ingition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6 buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

-----------------------------------------------------------------------------------
So what happened to begin with?
See also: http://automobiles.honda.com/information/frequently-asked-questions.aspx?Question=2

If the power from your battery to the Honda radio is interrupted the Anti-Theft feature kicks in, the radio is rendered inoperable and the screen reads 'CODE'. You must enter in the Anti-Theft Radio Unlock Code (usually 5 digits) to make it operational again. You know that much by now.

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need brake five digit brake code to start my car. Its a 2001 2.3 accord


Only from a Honda dealer by the look of it as they are VIN number specific.
http://automotiveandcommerciallocksmith.blogspot.ca/2012/07/emergency-engine-start-procedure-for.html#!/2012/07/emergency-engine-start-procedure-for.html

To start the engine without a programmed ignition key,
you need these items:
• Immobilizer key blank (master or valet)
(Refer to the parts catalog for the P/N, and search by
VIN for the correct blanks.)
• Key code for the vehicle
• Suitable key cutter
• Immobilizer Brake Code (This code is available on
the iN Immobilizer Code Inquiry.)


Need brake five digit brake code to start my car Google Search

Jan 26, 2017 | 2001 Honda Accord

1 Answer

2001 honda accord slight grinding sound when turning right to left


Have the front brakes inspected, sounds like the brake pads are metal to metal.

May 19, 2016 | 2001 Honda Accord

2 Answers

Radio code


No one on the internet will have your radio code
It is a security feature & you own the vehicle & don't
know it
See a dealer & ask the question,how do you get or retrieve
the radio code & then put it in the system

Jul 18, 2013 | 2001 Honda Odyssey

1 Answer

2004 honda acoord keys locked out key6 light flashes on dash how do i reset


The green key light on the dash is your immobilizer system. If it flashes at you while you are cranking (no start). This means the key that you are using is not programmed to the immobi control unit. Try using another key. if all other keys are lost you'll have to get it down to you local honda dealer. it takes a special honda scan tool to program these keys to the control unit. If you don't want to spend money on a tow truck, ask you dealer about the Brake Code. This is a code specific to each vehicle. If your keys are lost/stolen you can input this Brake Code into the control unit by using your e-brake (special procedure). this will give you 10 free starts to get it to your dealer. (limp-in mode).
-hope this helps

Jan 16, 2010 | 2004 Honda Accord

2 Answers

I have green key flashing on dashboard but wont start


Check Fuse #9 under the hood its for DLC Power and Immobilizer System (10 Amp).

Look at the TDC wire harness. Sometimes the wire isnt put back in the holder on the rear edge of the timing cover. Then the harness gets sawed in half by the alternator belt.

Other Honda user had this problem on his 2005 Accord, after letting it sit battery disconnected for 20 minutes it was just fine. Inmobilizer for the lose.

My guess is your immobilizer kicked in because your battery in your key is dead.

So, I dont warranted if this process work...
Here is a better understanding of how a immobilizer works; each key has a code imprinted on it, no battery of any type just a random code. When you go to start the car the immobilizer computer sends a signal to the key. If the signal it receives back from the key matches one of the 5 keys it keeps in its memory, it sends a "OK start" message to the PCM starting the car. If it doesn't see the "OK start" signal it doesn't start and the green key light in the dash flashes. In short there is no way to reset it.

Try another key. If not, there is a way to bypass it shortly to get the car to a Honda dealership for reprogramming of a key or key replacement. Your Prelude may also have a problem with one of these components. It will need to be hooked up to a Honda scan tool and checked for immobilizer codes.Let me know if you have any questions. I'm a 6 year factory Honda tec.

I will try and answer all I can.Here is how to use the "pcm brake code" You weill need to call your local dealership and give them you vin # to get the code.To start the engine, follow this procedure:
1. Cut a temporary key using the key code and anon-transponder key blank.
2. Turn the ignition switch ON (II) with thetemporary key.
3. Enter the first digit of the immobilizer brake codeby pressing and releasing the e-brake pedal the samenumber of times as the digit. For example, if thefirst digit is 4, press and release the e-brake pedal 4 times.
4. Turn the ignition switch to Lock (0) and then backON (II).
5. Repeat steps 3 and 4 to enter the second, third,fourth, and fifth digits of the code. You have up to30 seconds to enter each digit.
6. After you enter the fifth digit, the immobilizerindicator on the dash will blink five times,meaning you can now start the engine with thetemporary key.While the engine is running, the immobilizerindicator will stay on. If the engine isn't started with in 10 minutes, you'll have to reenter theimmobilizer brake code. You'll also have to reenterthe code if the engine is shut off for more than 10 minutes.This also workes for any Honda immobilizer system. However you need to use the brake pedal. Only preludes you used the e-brake.

Good luck.

Nov 13, 2009 | 1996 Honda Civic

1 Answer

Program my Honda accord Key


I've not heard of Brake Codes working on the 3rd or 4th generation Rolling Code Sidewinder Keys. There is simply no reason to, since a Honda Tech can simply access the Immobilizer System through the HDS (Honda Diagnostic System Laptop) with the Daily Access Security code providec by the Honda System. He can even reflash (reprogram) the ECM using this Daily Code.

In a case like this, normally Honda will have the Accord towed in and do a "All Keys Lost" reset with a new set of keys. This will also prevent your "Lost keys" from being used in the future by who ever may find them.

If you ever buy a used Honda at a Honda Dealership, most likely they also did a complete Key code reset just in case to protect you.

Apr 10, 2009 | 2006 Honda Accord

1 Answer

Honda accord 2001


check for faulty brake light switch by brake pedal

Apr 07, 2009 | 2001 Honda Accord

1 Answer

The back up lights on my 2001 honda accord 2dr. 4cyl. automatic


Hello there

You need to replace your brake switch, located under the brake pedal.

hope this helps.

thanks

Mar 17, 2009 | 2001 Honda Accord

1 Answer

2001 Honda Accord Will not start do not think its the elec sys


then its nothing to do wid immobilicer.,check battery strength,maybe your generator is draining all the power

Jan 05, 2009 | 2001 Honda Accord

1 Answer

Brake light


DOES IT INSTALL FROM THE TRUNK?

Jan 04, 2009 | 2001 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

285 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...