Question about 2007 Honda CR-V

Open Question

Replace rear washer nozzle 99 civic hatchback

Posted by Anonymous on

3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1070 Answers

SOURCE: access rear wiper motor on a 2000 Honda Civic hatchback,2342301/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800bf924
Try this web site and see if this can help you get at it.

Hope this helps.

Posted on Mar 13, 2009

  • 486 Answers

SOURCE: 1996 honda civic hatchback, I


Posted on Mar 01, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to washer nozzle replace on 2006 honda civic

if nozzel is block.
get a pin and poke it into nozel holes
it will unblock.

Nov 26, 2016 | 2006 Honda Civic

2 Answers

How doi replace a rear washer nozzel

Not much information to work with namely the make and model of the vehicle and why you think you need a new nozzle. If it is not squirting there are several possibilities. First I would listen for the pump. It can be under the hood or in the rear side panel depending on your model. Consult the car manual. If the pump is working and the resevoir has fluid in it the next things it could be a pluged nozzle or a disconnected hose. A straight pin or hat pin should be small enough to insert into the nozzle to check for a plug. If the pin is too big then a wire from a stiff wire brush may work to dislodge a plug. If you are able to move something in the nozzle try to use the washer to see if it squirts. If it does squirt it will likely plug back up again if you don"t clean the slug out of the nozzle. To do this you may need to remove the inside door panel to get to the hose connection and back flush the nozzle. At this point you can remove the hose from the nozzle and check the flow by operating washer. If you get flow through the hose you will need to clean the nozzle. If there is no flow you will need to check it at the pump or trace the path of the hose to find a break in the hose.

Feb 04, 2015 | Cars & Trucks

1 Answer

2002 town & country rear washer does not work

replace the washer pump theres one for front and one for rear

Feb 18, 2014 | 2002 Chrysler Town & Country

1 Answer

99 honda civic, hard to start after sitting for awhile. Want to know what causes it? Hatchback civic

does it crank at least? possible issues.. Battery, starter, fuel pump, clogged fuel filter, spark plug and spark plug wires, distributor, igniter..

Oct 25, 2013 | Cars & Trucks

1 Answer

Hatchback windshield washer nozzle location

on the third gen integras its on the roof of the car. it looks like a little nub. im guessing its on all gen integras

Jul 06, 2010 | 1991 Acura Integra Hatchback

2 Answers

2007 Hatchback: Windshield Washer Freezes

there is no problem just drain the system down run the ****** dry then place winter washer in it as it only freezes at -40 not 0 so there is still water in the system or there is summer fluid in there

Jan 03, 2010 | Nissan Xterra Cars & Trucks

1 Answer

19991 civic hatchback. Getting hot air but no

There is a blower motor under the dash, behind glovebox. Loosen 3 retaining screws holding motor housing, drop motor housing and blower motor unit. Replace blower unit. The problem involves the blower resistor. This piece must be replaced but might be easier to replace the entire blower motor unit.

Dec 30, 2009 | 1991 Honda Civic

1 Answer

Need to replace the hatchback!

you got the right idea.the hatch is easy. the bumpers are a pain only because the hardware rusts. use something like PB Blaster to help loosen them up. Good luck, and don't forget the rating.

Jan 12, 2009 | 1989 Honda Civic

1 Answer

1995 Honda Civic Hatchback Rear window

It is possible to change this window on your own. But it is a pain in the ***. So im gonna tell you the easiest thing to do is either go to a junkyard and buy the whole hatch which is relatively cheap. Or you can just call any general glass repair shop and they will come fix this for around $125to 200 bucks. If it were me i would go to the salvage yard.

Sep 04, 2008 | 1995 Honda Civic

Not finding what you are looking for?
2007 Honda CR-V Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides