Question about 2002 Honda CR-V

Open Question

Looking for PCV valve location on 2008 Honda CRV

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

blueextc3221
  • 15935 Answers

SOURCE: PCV valve for 2004 Hona CRV

PCV Valve Operation: 0900823d80049deb.jpgA vacuum-controlled metering device that regulates the flow of crankcase fumes in the positive crankcase ventilation system by allowing more flow at high speed than at low speed, and acts as a system shutoff in case of engine backfire to prevent an explosion in the crankcase.
Depending on your engine size, the PCV is a different style and slightly different location.

Usually they are mounted in a hole on your valve cover.... connected by a vacuum tube.
Some are mounted with threads into the engine block (usually by the oil filter)

On the '04 Crv - it is nearly inaccessible behind the AC compressor and beneath what looks like an old vacuum advance. Most PCV valves today do not need to be replaced, unless there is actual valve failure, which I have not seen happen. I would not be concerned about replacing it.

Thanks for using FixYa - a FixYa rating is appreciated!!

Posted on Feb 21, 2009

Molson02536
  • 3854 Answers

SOURCE: location of a pcv valve on a 2005 honda accord

You have to remove the "ignition cover", ie. the plastic cover that says 3.0L, you will see a hose coming from the passenger front corner of the intake manifold, that is one of the two PCV hoses, the other one is on the rear driver corner of the intake manifold.

Follow the first hose downwards and you will find the PCV valve just below some other tubings, it sits fore/aft, i.e. lengthwise to the car. I hope this helps good luck

Posted on Apr 08, 2009

philschneide
  • 448 Answers

SOURCE: where is the pcv valve located on a 1999 honda

Under hood, center, upper engine area, top of engine, MOUNTED IN THE VALVE COVER (probably has a rubber hose connected to it, coming from a place further back toward the firewall) It usually is removed by simply pressuring it upward out of the rubber gromet that it resides in.
Hope this lets you find it.

Posted on Oct 27, 2009

Testimonial: "u guys are great! I'll be back with more stuff. hopefully one day I can be among you answering these questions! thanks a million!"

  • 449 Answers

SOURCE: location of Idle control valve on 04 CRV

It's not a easy job but I'm pretty sure you had one of those problems where the idle surges if this is the case take out the air intake tube that leads to the throttle body, get a can of carburetor fluid and spray around the throttle body. You will need someone to start the car and hold the gas peddle to 2500 rpm while you do this the car will shut of when you do this, restart the car and repeat the process until half of the can is used up. Now check your antifreeze level fill if needed and reset you check engine light. Now you can take the idle air back and get your money.

Posted on Nov 17, 2009

localwonder
  • 6784 Answers

SOURCE: were is pcv valve located on 1989 honda accord lx

You PCV will be located on the center, rear engine area. It is just below the intake manifold, between the block and intake manifold. The valve is housed in the vacuum hose that runs halfway into the engine.

Posted on Jan 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of pcv valve on 2008 ford taurus 3.5


On 3.5L engines, the PCV Valve is located on the rear valve cover (see pictures bellow). Please note: the PCV valve must be replaced if it's removed. Access to the valve is easier if you remove the upper intake manifold. However, this is not absolutely necessary and if you are already a little mechanically inclined you can do it the way you would replaced any other PCV valve.

    -A 19mm open wrench will make your life a lot easier if the PCV valve is a bit tight. It is in an awkward spot to apply pressure.

    -Disconnect the electrical connector from the valve. There is a small pin or locking device on the wire that you will have to slightly depress for the connector to release.

    -Disconnect the hose from the valve and turn the hose clockwise so that you have a bit of room to work with.

    -Turn the PCV valve counterclockwise and remove from the valve cover. Pay close attention to the position of the valve at the point when it is to be removed. The new PCV valve will go in at that same position. Why is this important? It is possible to install the PCV valve facing in the opposite direction. Once the PCV valve in and locked it in place, it damages the locking mechanism. Therefore, if you remove it you will have to throw it away and purchase a new one.

    -You just saved $130 - $150 to have the PCV replaced at the dealership...

location-pcv-valve-2008-ford-taurus-3-5-cgnwdhiy0mxwbb3xg5zhzgxj-5-0.jpg

Apr 07, 2013 | 2008 Ford Taurus SEL

1 Answer

Where is the pcv valve on a 2003 honda civic?


It will be located on or near of the valve covers .. Its looks like this (B)



2_8_2012_4_06_39_am.jpg

Feb 08, 2012 | 2003 Honda Civic

2 Answers

Where is pcv valve located on 1989 honda accord lxi


Locate the air box on the top center of the engine towards the back. The PCV valve is located on the rear, underside of the air box. Although on some Accord models, a small air box bracket may be present, which will block view and access to the PCV valve plugged into the intake manifold. If by chance the bracket is there, then remove the retaining nuts, holding it to the air box side with the ratchet and a socket. Reach onto the intake manifold with a pair of needle nose pliers, and gently pull the PCV hose and valve out of the grommet of the intake manifold. Hope this helps!!!

Oct 20, 2011 | 1989 Honda Accord 4 Door

1 Answer

Looking for locatio of PCV valve on 2001 Accord EX 3.0?


it should be located in the rear valve couver pushed into a rubber gromet with a hose running from it to the intake tube going to air box if not there then in the front valve couver same deal with a gromet and a hose running to the intake tube going to the air box. thats were 90 percent of ur pcv valves are located on most car trucks and suv's. im not real fimilyer with the 3.0 honda moter but i hope this helps

Aug 01, 2009 | 1992 Honda Accord

1 Answer

PCV Valve location


It should sit in your valve cover. On the passenger side (if I remember correctly). It should be right on your valve cover with a line that attaches to the top of it.

May 05, 2009 | 2008 Hyundai Veracruz

2 Answers

Location of a pcv valve on a 2005 honda accord


The general location mentioned is correct. However, unlike most PCV valves there is no hose connection to the valve. There is a single bolt that attachs the PCV valve to the valve cover. Loosen the bolt, then remove the PCV valve from the valve cover. It is inserted inside the valve cover. Very different from most PCV valves as far as attachment method to the valve cover.

Apr 08, 2009 | 2005 Honda Accord

3 Answers

PCV valve for 2004 Hona CRV


PCV Valve Operation: 0900823d80049deb.jpgA vacuum-controlled metering device that regulates the flow of crankcase fumes in the positive crankcase ventilation system by allowing more flow at high speed than at low speed, and acts as a system shutoff in case of engine backfire to prevent an explosion in the crankcase.
Depending on your engine size, the PCV is a different style and slightly different location.

Usually they are mounted in a hole on your valve cover.... connected by a vacuum tube.
Some are mounted with threads into the engine block (usually by the oil filter)

On the '04 Crv - it is nearly inaccessible behind the AC compressor and beneath what looks like an old vacuum advance. Most PCV valves today do not need to be replaced, unless there is actual valve failure, which I have not seen happen. I would not be concerned about replacing it.

Thanks for using FixYa - a FixYa rating is appreciated!!

Feb 21, 2009 | 2004 Honda CR-V

1 Answer

Location of the PCV valave in the 2002 Honda CRV


pcv valve should be located on the valve cover..but some new vehicles don't have one it is built into the valve cover itself..

Dec 01, 2008 | 2002 Honda CR-V

1 Answer

PCV Valve


The PCV valve is located directly under the fuel rail on the driver's side, right behind your valve cover. Should be very easy to spot if you know what it looks like and you're looking right in that location.

Hope this helps :)

May 17, 2008 | 1993 Honda Civic 4 Door

Not finding what you are looking for?
2002 Honda CR-V Logo

Related Topics:

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...