Question about Cars & Trucks

1 Answer

I bought my 2005 Chrysler Pacifica in March of this year. I really loved it at first then the problems started. First something with the front end started clicking when I turn. Now its getting pretty cold outside, and I tried to turn on the heater and nothing. Its on, but will not blow out any air at all.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    A rookie expert who has answered 20 questions on their first day.


    An expert who has answered 20 questions.

  • Contributor
  • 41 Answers

There is a difference of whether you are not getting any hot air or nothing is coming out of the vent at all. If you are getting absolutely no air, chances are the blower motor resistor went bad. Luckily, it is not too difficult to get to. It should be under the glove box right next to or very close to the blower motor on the passenger side. It could be right behind the glove box, but it is in that general area. You can't miss it. It should have several wires going to it and then 2 wires from it to the blower motor itself.

I hope that helps.

Posted on Oct 20, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 68 Answers

SOURCE: 2007 Chrysler Pacifica heater blows cold air - A/C

Hello, seems like your thermostat may be stuck open. After the vehicle been running more than 10min feel the upper radiator hose it should be hot to the touch and if not a new thermostat is needed.

Posted on Mar 27, 2010

  • 8522 Answers

SOURCE: help 2005 chrysler pacifica heater and defroster

Your blend door actuator may have packed up. My manual says you have dual controls--true? If yes, is it cold on both sides?

Remove the silencer from beneath the driver side end of the instrument panel and take a look at the actuators. #4 and #6 are for the blend doors. Can you see if the little axle is rotating when you change the temp setting? If you can't tell, take one off and see if you can rotate the door by hand and get warm air to come out. If not, perhaps you have air in the cooling system. Check your coolant level and refill if needed. Then let's have a discussion about where your coolant may be leaking. OK?
Fig. Wire harness connector (1), mode door actuator (2), screws (3), drive blend door actuator (dual-zone) (4), heater core (5), blend door actuator (6) jturcotte_596.gif

Posted on Dec 22, 2010

  • 360 Answers

SOURCE: I have a 2005 Chrysler Pacifica. While driving I

The pop you referred to was mostly likely a radiator hose rupturing.

The steam would be indicative of a sudden, massive loss of coolant.

Do Not drive until problem is remedied.

Could also have been a radiator tank letting go, but I'd put my money on a hose.

Hoses are a LOT LESS COSTLY, and generally easier to replace.

Good luck!

Posted on Dec 30, 2010

  • 16022 Answers

SOURCE: 2005 Chrysler Pacifica clicking in front end forward or reverse with steering wheel turned and rolling. Tried tsb washers between axles and hubs.can anyone help?

cv joint

Posted on Oct 10, 2012

  • 2101 Answers

SOURCE: I have a 2004 Chrysler Pacifica and the heater doesn't work. It blows only cold air or outside temp air out of vents when heater turned on. No matter how high Iturn the temp up.

your blend door motor is stuck or it may need to be replaced. the blend door controls the temp from heat to a/c

Posted on Nov 18, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I install a vehicle speed sensor in a 2006 chrysler pacifica 3.5L

here is the link for the part you need.

Simple as pie. Once you have the part in hand, You will see where it plugs in near the intake. Just follow it to the other end, remove and replace.

Should be a 10mm bolt holding it down, and to remove the plug, just press the retainer tab and pull out. New plug snaps right in.

Dec 10, 2012 | 2006 Chrysler Pacifica

1 Answer

Why does the air work intermittently in my chrysler pacifica?

Your daughter she can fix everything,you will need a blower resistor3_27_2012_6_55_33_pm.jpg

Mar 27, 2012 | 2005 Chrysler Pacifica

3 Answers

Replaced low beam light buls in 2005 pacifica crysler and lights still wont work. What is the problem

Chrysler/Pacifica 2005
MANUFACTURER: DaimlerChrysler Corporation
COMPONENT: Exterior Lighting: Headlights
Certain sport utility vehicles equipped with Halogen headlamps may experience an intermittent and eventual total loss of headlamp function.
The head lights may not operate properly which could result in intermittent or no headlight function. This could impair a driver's visibility, increasing the risk of a crash.
Dealers will inspect, and replace if necessary, the wiring harness and low beam bulb on both headlamp assemblies. The manufacturer has not yet provided an owner notification schedule for this campaign. Owners should contact DaimlerChrysler at 1-800-853-1403.
DaimlerChrysler Recall No. E04. Customers can also contact The National Highway Traffic Safety Administration's Auto Safety Hotline at 1-888-327-4236

Nov 17, 2011 | 2005 Chrysler Pacifica

1 Answer

I have a 2005 pacifica touring AWD. I had the rear tires replaced when i bought the car 3 months ago. the wear compared to the front tires was awful. the new tires began wearing on the outside and within...

It is adjustable and a lot of these have bad bushings and some have oval holes in the aluminum parts in the rear end. Until that is fixed you can't align it go to dealer or another dealer and have it looked at

Aug 15, 2011 | 2005 Chrysler Pacifica

1 Answer

My 2005 Chrysler Pacifica makes a ticking sound when I try to start it. Do you think it's the starter or something else?

Leave the door open interior lights on turn key to start if lights go out or real dim. Battery bad or posts dirty. Lights bright starter

Aug 09, 2011 | 2005 Chrysler Pacifica

2 Answers

Where is the MAP sensor on 2005 Pacifica Touring?

the map sensor is located at the top front of engine, it has a square plug with a wire lock, mounted at top end of intake manifold.

Feb 08, 2011 | 2005 Chrysler Pacifica

6 Answers

I have a 2004 pacifica, fwd. I had just gotton my front brakes and rotors done, as well as all tie rods. I am still a wierd knocking noise in the front end (sounds like the right wheel well mostly) Almost...

In this order stabilizer links, stabilizer bar bushings, control arm bushings, engine cradle bushings or bad struts mine have 160,000 and don't clunk but do need replacement

Aug 11, 2010 | 2004 Chrysler Pacifica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides