Question about Nissan Frontier

Open Question

2000 Nissan frontier vibration when accelerating btween45-50 mph causing engine light flashing

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Pattods
  • 116 Answers

SOURCE: 1998 nissan frontier 4x4

Well since the lights are controlled by the OBD (on board diagnostics), you'll have to reset it. You may be able to do this by simply disconnecting the battery for a few hours. However, a lot of newer vehicles have electronically locked radios which require the manual to be able to be re-enabled.

I'd check out the radio before disconnecting the battery.

The only other ways are to physically disconnect the lights in the dash or get someone with an OBD reader to clear the codes.

Posted on Sep 13, 2008

Ad
  • 1 Answer

SOURCE: 1995 nissan quest

Have your engine mounts checked. I was experiencing the same type if things, and it turned out all 5 were cracked! (I also have the 1995).

Posted on Oct 23, 2008

  • 1 Answer

SOURCE: Car stutters at startup

My car did the same thing and I went and had it checked out. They had to replace my mass air flow censor. Cost me a little over $200. The only thing is after I had it fixed, my check engine light kept coming on. They said that my fuel line was running rich because I had ran my car so long with that problem. May want to get that checked out!

Posted on Jun 25, 2009

wracefans24
  • 1985 Answers

SOURCE: Vibration while accelerating from 30 to 45 mph Jeep GrandCherokee

Not a tune up problem,
You need to have all U-joints checked out,They will give you the vibrations only while acceleration

Posted on Dec 04, 2009

Testimonial: "Perfect, Wasn't sure if it was the right solution but I got them fixed and problem stopped. Thanks."

  • 2 Answers

SOURCE: change brake light bulb on a 2000 Nissan Frontier

The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.

Posted on May 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Code for misfire cyl 4. replaced wires, plugs, distributor cap and rotor. at speed of 40 mph check engine light flashes and when decelerate at times will flash also.


When your check engine light flashes, it means there is a serious problem. When you tested the code, is that when you got the misfire code?

Feb 27, 2011 | 1998 Nissan Frontier

2 Answers

My 2004 nissan frontier makes a knocking sound when accelerating or when cold. It has been serviced regularly and has 74,000 miles on it. Does it have anything to do with the knocking sensor?


The knock sensor picks up vibrations from detonation and sends a signal to the engine computer, which then adjusts the igntion timing [ retards advance ] to correct it. You can read the operation of the sensor with a full function scanner, if it's working then you have to look for a physical problem with the motor causing the konck.

Feb 25, 2011 | 2004 Nissan Frontier

1 Answer

There is an excessive vibration during idle. it disappear when i stepped on the accelerator and increase the rpm to 750rpm. im bit worried of it as it cause my dash to rattle too much.


check air filter. may be very dirty or you may have a nest inside of the box causing low air flow into the engine, causing vibration. start there. i have seen cars towed in not running, because they/mice/chipmunk?? had huge nest made out of the carpet underlayment in the air box which is foam and it didnt give the engine enough air to even run , because it was starving for air and car needs air to run. Is the check engine light on?? while engine is running??

Jan 02, 2011 | 2006 Nissan Frontier

1 Answer

Vibration at 60-70 mph 2006 frontier it feels like it is under the cab not in the front end


There is a bearing at the drive shaft ,has a rubber bushing the bushing usually fails then the driveshaft loses it's alignment then
starts to vibrate . that could be your vibration.

Sep 25, 2010 | 2006 Nissan Frontier

1 Answer

2000 Frontier w/ 190,000 miles. Vibration Problem


check cab to chasis mounting rubbers.
can remove one or two bolts and see if change in vibration

Jul 18, 2009 | 2004 Nissan Frontier

1 Answer

2000 NISSAN FRONTIER VIBRATION


Check tire balance, rear wheel bearings and i would replace u joints front and back, anyway if they have never been repaced.

Jan 12, 2009 | 2001 Nissan Frontier Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...