Question about 2011 Nissan Murano 3.5

Open Question

How to replace front driverside turn signal bulb on nissan murano 2011

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: Replace rear wiper on 2005 Murano

You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.

The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:

88b7c7f.jpg

moz-screenshot-61.jpg9b7da18.jpg








Posted on Jun 29, 2009

Ad
burdfrenzy
  • 348 Answers

SOURCE: Is it hard to replace the front wheel bearing hub

Its a big pain. The hub is rusted on tight and has to be beaten off with a mini sledge. Go to your local AP store and look it up in a repair manual to see what you are in for.

Posted on Oct 15, 2009

  • 228 Answers

SOURCE: I replaced the blown driverside headlight bulb

Try this. right in front of the alternator is a black box. take the cover off and look at it inside and undeneath there is a diagram of fuses and relays. look down at the fuse block you just uncovered anfd you will see the fuses. there should be one labeled on the cover for "Head L/F and Head R/F".

check those and see if that works.

Posted on Jul 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 nissan sentra driverside lights keeps going out after bulb was changed


Hi Suzanne:
You did not tell us if the bulb filaments are broken (burnt out, no continuity) or if they are just not turning on.
If the filaments are broken either there is too much voltage (very unusual) or the bulbs may be loose in that particular socket and vibration is hurting them.
If the filaments are OK then you will have a wiring problem, probably corrosion on the bulb terminals or a bad ground.
Hope this helps.
Cheers.

Feb 10, 2016 | Nissan Cars & Trucks

1 Answer

How to remove front grill on a 2011 murano nissan


alldata.com

log in
read
(remove the screws)

May 18, 2014 | 2006 Nissan Murano

1 Answer

07 Murano headlight went out, replaced bulb, still doesn't work, now what?


If fuses are good, most likely the 'ballast' is at fault.

Dec 24, 2013 | 2007 Nissan Murano SE

1 Answer

How to replace nissan murano 2011 front driver side turn light


Lift hood, remove grill plastic screws on top, jack car left hand side, remove corner screw on end of bumper, undo lower splash shield screws, slide bumper away from car {about 4 inches}, remove,top bolts on headlight and lift out, the is a locating slot that you will need to manipulate it from, assembly is the reversal. good luck.

Oct 20, 2013 | 2007 Nissan Murano SE

1 Answer

Replace headlight bulb and turn signal bulb


www.youtube.com/watch?v=8tglvV6SlGk

Oct 14, 2012 | 2005 Nissan Murano

1 Answer

2005 Nissan Murano.When I use my turn signal both front and reaer windshield wipers come on and I can't turn it off.


do you have a hitch? installed by someone else other than nissan dealer such as u-haul or others??lets start there

May 24, 2011 | 2005 Nissan Murano

1 Answer

2007 nissan murano tail lites out in rear blinking very fast in front. nissan dealer told me the taillite has to be replaced the don,t service the bulbs


Hello this is correct what the dealer is telling you your tail light is LCD not bulbs so my solution to you is the replacement of tail light.

Jan 03, 2011 | 2007 Nissan Murano SE

1 Answer

The turn signals do not work on 2000 nissan exterra.Fuse was blown. Replaced and blew again after a few seconds.


1.Remove front & Rear turn signal Bulbs.
2.Replace Fuse.
3.Signal on.
4.Fix rear Signal Bulb.
5.Fix Front Signal Bulb.
7.If your Fuse blown.
8.Defect is There.

Jun 11, 2009 | 2000 Nissan Xterra

1 Answer

2006 nissan murano headlight out


Bulb can be replaced. You can buy at Walmart or your local parts store. I recommend replacing both. They are rated for the same amount of run hours and will usually fail within the same month.

You can also buy from this link.
http://www.partsgeek.com/gbproducts/YN/B18919-HEL-P8040.html?utm_source=google&utm_medium=ff&utm_term=06+2006+Nissan+Murano+Headlight+Bulb+Hella+Nissan+Headlight+Bulb&utm_content=YN&utm_campaign=PartsGeek+Google+Base

Nov 18, 2008 | 2006 Nissan Murano

Not finding what you are looking for?
2011 Nissan Murano 3.5 Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...