Question about Cars & Trucks

1 Answer

I had a hole in my intake manifold hose coming from my air filter box. (2001 Mazda MPV) I don't know how long the hole was there. I have replaced the hose. The van has no take off power at all. Now I have a howling sound coming out of my filter box

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 157 Answers

Are you sure you replaced it with the right hose? Is the MAF sensor in correctly or at all? Make sure it is still plugged in.

Posted on Oct 19, 2013

  • Chris Reynolds Oct 23, 2013

    I got the hose from another vehicle dame make,model and year. Also, I have replaced the MAF. I'm still getting the sound and no HP what so ever.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Where is the starter on a 1995 Mazda MPV van?

it is located under the skid plate. you'll need to remove the front drive, the alternator, and power steering pump out to remove the starter. need to remove the bottom cover to see it.

Posted on Dec 02, 2008

  • 840 Answers

SOURCE: power windows on 2001 mazda mpv won't go up?

if you do not here the motor then its the regulator or motor that needs to be replaced/ cif you hear the motor check the control switch on the trim panle coould be just a five dollar part to replace/ Please rate my response thank you very much

Posted on Jan 31, 2009

  • 1 Answer

SOURCE: Alternator not charging the battery.. Do you know where the alter

1989 mazda 626 turbo, does not start no electric current?

Posted on Feb 10, 2009

Hrnsly
  • 154 Answers

SOURCE: Intake manifold runner control stuck closed?

you don't have to replaced the manifold just the runner control. see this all the time at work the part is about 175.00 and an hour and a half to install. your local dealer should be able to fix this for you

Posted on Aug 07, 2009

co7196
  • 3433 Answers

SOURCE: 2004 Mazda MPV vacuum line from pcv valve and

You have the wrong type hose on the pcv valvle. It isn't vacuum hose.

Posted on Nov 12, 2009

Testimonial: "thank you you have been very helpful i understand now but the hose that is on the new pcv valve is a vacuum hose "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix p 1518


well its your intake manfold there is a air intake sensor it a silaniod should mount to the side of where the breather hose end replace that air sensor and check the wiring to it

Nov 17, 2012 | 2001 Mazda MPV

1 Answer

Check engine light flashes and car sputters


my MPV has this symptom. in my case it is a hole in the breather hose which is on the back of intake manifold. my mechanic friend helped me diagnose this. codes came up as problems with O2 sensors because of the extra air getting into intake. when we opened the hood with van running we could hear the leak right away. this was causing engine to run very rich... currently looking for part... hope this helps

Sep 07, 2011 | 2003 Mazda MPV

1 Answer

Where is the fuel filter located on a 2000 Mazda MPV?


the 2000 MPV doesn't have a fuel filter. You could try fitting one on the fuel line just before the injector rails. These are located under the the inlet manifold but you have to figure out which one is the inlet pipe and which one is the return pipe. You will need to disconnect the plastic air intake pipe in order for you to access the fuel supply lines. Hope this works.

Dec 27, 2010 | 2000 Mazda MPV

1 Answer

Mazda MPV 2001, code P1518 , and P1512, what is the problem?


After extensive searching and trial and error I found that the cause for the code 1518 on my mazda mpv was caused by the plastic clip that holds the linkage for the intake manifold runner had broke on the fire wall side and the linkage fell out causing the runner to stay open. It is very difficult to see. It is on the front( drivers side) of the engine below the upper intake manifold. Remove the air cleaner box and use a mirror and you can see it. Only about 6 inches long. Replace both clips while you are in there because it is a bear to get to. Check this first before you go through the other items like the egr. Inexpensive repair and my code 1518 and the one for randon miss fire went away never to return. Lots of power again. Good luck. Jim

Aug 30, 2010 | 2001 Mazda MPV

2 Answers

I am getting a P0031, P1512, & P0421 code


P0031 - most likely pointing to a failed O2 sensor (bank 1 sensor 1 is located before the catalytic converter)

P0421 - failed catalytic converter or a failed O2 sensor

P1512 - intake manifold shutter valve is stuck - may be caused by the O2 sensor, but may not

I recommend replacing your O2 sensor first and see what happens

Sep 18, 2009 | 2001 Mazda MPV

3 Answers

I have a fault code of p0108 what has caused this fault and how do i fix it on my mazda mpv


Your map sensor, otherwise known as mass air flow sensor is probably bad. You should replace it. it is normally located between the air filter and the throttle body. It senses how much air is going into the throttle body so the car knows how much fuel to inject.

Jul 07, 2009 | 2002 Mazda MPV

3 Answers

Volvo v40 18si


should be a little single wire connected to the air filter box. located on the clean side of the air filter. if not it will be between the air filter box and the throttle plate usually located on the air duct hose going from the air filter box to the throttle plate.

Apr 10, 2009 | 2001 Volvo V40

3 Answers

2001 mazda protege keeps stalling


my 2001 mazda protege starts hard, idles low and high at various times (never normal) and it acts as though its going to stall at all times. sparks and wires are changed no help, changed air filter no help. any idea on what to do?

Mar 26, 2009 | 2001 Mazda Protege

1 Answer

Does 2004 Mazda MPV ES equip with a cabin air filter?


(cabin filter solution) Their is an cabin airfiliter behind the glove compartment (2004 mazda mpv) which is very easy to take off. Replace the airfilter or clean it with soap and water. Open the glove box and on the bottom left had side of the glove box if you apply enough presure on it by pulling it out towards you and slightly down it should pop off. The right side should slide out immediately following the left side pop. All it is, is a fork like claw holding on to a bar. On the ride side is a bar sliding into a hole. That should do the trick. After the first time its a sinch.

Jan 25, 2009 | 2004 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...