Question about 2001 Mitsubishi Mirage

Open Question

I have a mitsubish RVR 2001 model, I want to know where all the engene sensors are located. My car stops/ cuts engine from running even when I am travelling but when I stop for some time, say an hour, if I start the engine, it will start running again bt stops itself after running a few killometres. if I try to start the engin as soon as it stops or a few minutes after it stops, it will not start.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 74945 Answers

SOURCE: 98 galant motor stalls - dies when gas is pressed

I would take a look at possiable damage to the PCM (powertrain control module)

Posted on Nov 19, 2008

dustyboner
  • 331 Answers

SOURCE: 98 eclipse Engine stall but stars

Sounds like your IAC (idle air control) motor needs to be replaced. If you are driving on the Interstate/freeway/highway for a bit and then get off, the car dies when your coming to a stop right?
ab6c525.jpgb78ae54.jpg

Posted on Nov 25, 2008

  • 114 Answers

SOURCE: 2001 mitsubishi service engine light

this light will come on if you have a problem with the emissions system. Take it to a place like autozone and have them scan it for codes. list the codes here and we can help you out.

Posted on Jan 07, 2009

  • 1 Answer

SOURCE: Mitsubishi Carisma 1997

its a very common fault with the GDi engine, normally first shows a fault after 60k miles. Fault will also make the engine feel slightly juddery on occasions whilst cruising... either/both Accelerator body or Cam sensor are the usual culprit. Both can be rather expensive.

Posted on Mar 13, 2009

  • 1 Answer

SOURCE: gdi 3500 pajero not giving me enough power and throttle

I have mitsubishi Pajero GDI V6 3500, i was on the high way and suddenly the movement became very slugsih. i contacted my Auto mechanic who discovered that one side of the engine is not performing, the left side exhaust was cold while the right side was hot. ie the cold side injection nuzzles does not work , please what could be the possible solution ?

Posted on Oct 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 Mitsubishi rvr 4g64 when diving press the gas pedal down for speed it cut power are shut down mostly up hill.


Cleaning A Mass Air Flow Sensor To Stop Hesitation ...

? 2:57
www.youtube.com/watch?v=xQGSkWEC_u4
Dec 15, 2011 - Uploaded by Scotty Kilmer But when we did that, the engine ran a few seconds and thendied, arrghh! ... +mrwebber35 On all cars the brake peddle overrides the gas factory default ... for a decade) sometimes it lags a lot with the gas pedal depressed then after few ... scotty.. i have 2014 mitsubishi triton. its a vgt diesel engine. is it .

Sep 22, 2015 | Mitsubishi Cars & Trucks

3 Answers

I have a 1985 fiero se v6 that was running fine but cutting off after warm up


Do you know what you are loosing when the engine stops running ?

Jan 16, 2014 | 1985 Pontiac Fiero

1 Answer

Where is the pvc val located on 2001 Mitsubishi Galant


The pcv valve will be on the valve cover. It will have a tube coming to it. You can pull it out to remove it. Shake the pcv valve, if it doesn't rattle, it needs to be replaced.

Apr 10, 2013 | 2001 Mitsubishi Galant

1 Answer

In my kia engen fan run always even when i just start viacle and dosen t have power


one fan should run only when its hot or the AC is on.
sometimes, the fan will run a little after you shut off the engine to cool the system off.

Dec 11, 2012 | 2001 Kia Sportage

2 Answers

How to locate o2 sensor in chrysler town and town 1994


that is your idle air control valve . it is located on the throttle body next to the throttle position sensor

Dec 02, 2012 | 2001 Chrysler Town & Country

1 Answer

Locating maf sensor


I think it may be the battery or the alternator not the maf sensor.Sounds like its not charging thats why it runs rough when you are running multiple things at the same time.Have your battery and alternator checked first.Hope this helps

May 04, 2009 | 2001 Volvo S40

1 Answer

1994 Mistsubishi RVR Problem with engine performance....


mine is also a 4D56, struggles to go above 200rpm, partly due to engine fatigue (at more than 140,000 miles), but the main problem could be the fuel pump, not properly calibrated with the engine fuel intake system. Take the car to a garage and ask them to check the pump. also explains he rattling when idle.

Apr 18, 2009 | 1987 Mitsubishi Passenger

2 Answers

When does one engage the ''L'' gear when driving a mitsubishi rvr c


the L gear is Gear # 1 and likewise 2 is second gear, you utilise this in case you are going down on a slop especially icy or snow condition all it does is runs just on 1 or 2 respectively without changing whichh gieves more traction on the road.

Dec 15, 2008 | 1987 Mitsubishi Passenger

Not finding what you are looking for?
2001 Mitsubishi Mirage Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...