Question about 2000 Ford F250 Super Duty Crew Cabs
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you need to remove door trim panel there are (2) 7mm screws that hold panel on .. 1 is behind the lower red light lens and the other is behind switch panel for the power window switch . remove both screws and remove small black panel above door trim by pulling strait off .(now there are (4) 11mm nuts the hold mirror on 2 are behind the small rubber plugs in front of door that you can see with panel on and the other 2 are under panel that you can see after panel is removed . the wiring need to be disconneced you may have to remove speaker for acess to feed new wiring down into the door good luck
Posted on Mar 11, 2009
You'll have to drain system down when cooled off, remove any brackets in your way such as power steering reservoir holding bracket, then remove 2 bolts holding the housing, and remove it. Rad hose should be o.k. to leave on, but if it creates a problem, remove it as well. I'd install a new thermostat and "o" ring complete,then a new gasket as well. Clean all surfaces well before re-installing. Replace any bracket(s) you removed to access housing, after housing is installed. Remember, air valve on edge of thermostat goes in 3 oclock position when re-installed. Also a reminder as well, spring on thermostat goes down when re-installed. After all is re-assembled, re-fill coolant and start engine and run with heater on to bleed out all air. Leave rad cap off and pay attention to temperature gauge and when you see it getting to normal operating temperature, watch flow in rad for increased flow, indicating thermostat opened and coolant is circulating properly. Wait until you see that flow increase 2 or 3 times, and air should be out of system, and top up coolant in rad, put cap back on, and check that return bottle is at proper level as well. Keep an eye for any leaks, and re-check return bottle periodically for first little while, just to be sure all is good. Note: some only use the "O" ring as a seal, and no gasket is required, but just check that at autoparts place where you get part.
Posted on Dec 28, 2009
my 2005 f250 diesel is all of a sudden not going into 4 x 4, no lights on dash now and cannot engage on wheels manually. Does anyone know where there is a fuse that operates this function that I can check?
Posted on Nov 24, 2010
Tips for a great answer:
Oct 14, 2015 | 2003 Ford F-250 Super Duty
May 03, 2015 | 2003 Ford F-250 Super Duty
Aug 23, 2012 | Ford Cars & Trucks
Aug 20, 2012 | Ford F-350 Cars & Trucks
May 08, 2011 | 1999 Ford F250 Regular Cab
Mar 22, 2010 | 2003 Ford F250 Super Duty Crew Cab
Feb 24, 2010 | 2003 Ford F350 Super Duty DRW SuperCab
Jan 16, 2010 | 2003 Ford F250 Super Duty Crew Cab
Apr 13, 2009 | 2002 Ford F250 Super Duty SuperCab
78 people viewed this question
Usually answered in minutes!