Question about Mercedes-Benz Cars & Trucks

1 Answer

Mercedes benz E200 2006 (E211). My mercedes benz

Mercedes benz E200 2006 (E211). My mercedes benz start lossing power after some time i driving. When I start a car it runs completely normal and after some time it just lose power and kick down wont start. When I stop and restart car it work normal again.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercedes-Benz Master
  • 4,521 Answers

Ekectric components are gittn hot from wear--ignition and fuel pump are common with age--need to do test to confirm

Posted on Oct 19, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: Ignition failing to start -S280 MERCEDES BENZ 1999 MODEL

Crank shaft position sensor is bad. This is the most common failure. Its location is on the rear drivers side of engine, where the transmission bell housing mates to the engine, only one small bolt and a two prong electrical connector hold it on. Usually will not throw a trouble code. If you remove it you can test it with an ohm meter, will have an erratic reading or read open loop, can malfunction intermittently or permanently after parking vehicle and won't restart. Applying some heat source to it during ohm testing with a hot air heat gun will usually cause the sensor to read open loop if your not sure if its bad or not. This reply is probably way to late, but I just happened to come accross it while online. Harry (master certified MBZ diagnostic tech)

Posted on Dec 06, 2008

  • 43 Answers

SOURCE: 1999 Mercedes Benz ML 430 periodically stalls at idle

Hi, Joe here The problem sounds like a faulty crankshaft position sensor. The sensor is located on the transmission bell housing on the left side. Can be accessed threw the top of the engine near the firewall.

Posted on Apr 06, 2009

  • 14 Answers

SOURCE: switch to 4 wheel drive in Mercedes Benz GL450

You have permanent all wheel drive dude. The system is always ready to go. If you want to do some offroading, activate the "off road" button that looks like a vehicle climbing uphill on the lower, center dash panel. This will allow more slip for the traction control system and hold lower gears longer in the trans

Posted on Apr 13, 2009

  • 1619 Answers

SOURCE: My mercedes Benz C 220 stalls when I come to a stop or in park .

Is the AC on? The compressor can take alot of power and make it lope. Engine mounts can make it shake. coils, cap, rotor and wires for tune up at a minimum. EZL if you can find one cheap. MAF also can cause issue. If it is a 1991-1995 check the engine wiring harness as they get brittle and degrade.

Posted on Jun 15, 2009

  • 165 Answers

SOURCE: my car mercedes C200 model year 2000 the esp , bas lite up twice

replace the brake switch

Posted on Apr 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to reset the check engine light on a 2008 Mercedes Benz S550


The best way to reset it is to have the problem repaired that caused it to come on. Another way is to disconnect the battery negative cable for a few minutes and then reconnect it. This may cause other problems - loss of presets on the radio, and possibly loss of radio functionality if you don't have the appropriate code. And, depending on what caused the light to come on initially, it may just come back on soon after you start driving again.

Nov 28, 2016 | 2008 Mercedes-Benz S 550

1 Answer

Loss of power when passing


diesel filter is serviced? still you might have water in the system - get a new filter to start with

Apr 18, 2014 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

Loss of power


I can think of two possibilities.
1) The air mass meter could be defective, or covered in dirt, and not providing the right fuel mix under a load heavier than normal driving.
2) The monolith in the Cat may be breaking up and blocking the exhaust system, which would again be more noticeable under load.
Both possibilities are usually accompanied by reduced acceleration and a drop in performance but when the problem starts these things may not be detectable.

Mar 25, 2014 | 1990 Mercedes-Benz Mercedes Benz C Class

2 Answers

1992 300se mercedes benz lossing power when step on gas pedel


This car has a pretty reliable inline 6 cyl. The car also has TWO fuel pumps .. if one pump is bad the car will not produce full power. this is to keep you from being stranded if you have a fuel pump failure. What you really need to do is check the fuel pressure and see if thats up to spec. Check your air filter too.. Do you have black smoke when you step on the gas? or just poor power. ?

May 01, 2011 | 1992 Mercedes-Benz Mercedes Benz S Class

1 Answer

Where can i get a free look at the timing manual book for a 1987 230ge mercedes benz gasoline right hand drive


Check internet explorer--Type in "setting timing for '87 -230ge mercedes benz--right hand drive--need also to include engine size.

Feb 04, 2011 | Mercedes-Benz G-Class Cars & Trucks

1 Answer

How do you troubleshoot heater control valve in a 1992 Mercedes Benz 400SE?


put 12vdc to the two pins at the heater solenoid and listen for a click sound. that will test the solenoid motor. Unscrew the four screw and pull apart to check the rubber diaphram. Clamp off the hoses to minimize coolant loss. Sometimes they get stuck and the manual power that you put to them will free them up and start working again. The insert is available separately.

Oct 24, 2010 | 1992 Mercedes-Benz Mercedes Benz S Class

1 Answer

I have a mercedes c180 (98) and have serious loss of acceleration and power when driving any ideas please


I had my air flow meter replaced for similar problems. Mechanic said it was quite difficult to diagnose it. Drives well since then.

Aug 30, 2010 | 1998 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...