Question about 2005 Buick LaCrosse

Open Question

2005 Buick Lacrosse windshield washer pump ....where is it located?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: how do you add power steering fluid. 2005 buick lacrosse

It is very hard to see, its back and underneath the altenator, use a flashlight to find it buried under wires and tubes.

Posted on May 03, 2009

Ad
  • 192 Answers

SOURCE: lowbeams headlamp won,t work on 2005 buick

Start simple. Investigate your fuses, since it is unlikely, but not unheard of, for both low beams to fail simultaneously.

Do you know where your fuses are?

Posted on Aug 17, 2009

  • 7 Answers

SOURCE: how do you access the windshield washer pump on

The washer pump is located on the bottom of the wash fluid bootle. you can access it by removing the front passanger fender liner..

Posted on Jan 12, 2010

  • 3 Answers

SOURCE: how to install/change complete headlight assembly

Buick Lacrosse - The bright light fitting is the same as the dim so take it apart first to see how the cover screws off/on and the light comes out. Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. If not, then you need to release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. To remove these locking pins, pull or pry up the little tab in the center of the pin just like you were pulling a nail by the head. That should give you more space.

Posted on Apr 03, 2010

kapishtech
  • 2272 Answers

SOURCE: Replace headight assembly on 2005 buick lacrosse

The procedure to replace head light assembly on buick lacrosse is as follows:--- 1)To remove and replace the headlight assembly you will need to remove 1 retaining bolt on the top of the headlamp assembly and 2 sliding retainers at the rear. 2) The carefully Pull up the retainers and that will release the headlight assembly and allow you to pull it out the front. 3) When installing the new headlight assembly make sure you have it lined up correctly before trying to install the retainers, don't force them it may get cracked . 4) Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. 5) Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. 6) On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. 7) Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. 8) Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. Note:-- The turn signal is part of the headlight assembly on your 2005 Buick LaCross. 9) To replace the headlight bulb you need to remove the front bumper cover. 10)To release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. 11)To remove these locking pins, pull or pry up the little tab in the center of the pin. Thanks.

Posted on May 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Adding windshield washer fluid to Buick Lacrosse 2005


When the windshield washer fluid is low, a low washer fluid light may appear on the instrument panel cluster. In addition, if your vehicle is equipped with a Driver Information Center (DIC), the LOW WASHER FLUID message will appear when the fluid level is low. When you need windshield washer fluid, be sure to read the manufactures instructions before use. If you will be operating your vehicle in an area where the temperature may fall bellow freezing, use a fluid that has sufficient protection against freezing.

on Oct 08, 2010 | Buick LaCrosse Cars & Trucks

2 Answers

Where is the windshield wiper pump located on dodge caravan 2005


The washer pump is located in the bottom of the washer fluid tank

May 24, 2015 | 2005 Dodge Caravan

1 Answer

Fuse box diagram


Driver's side under dashboard above feet area

Oct 04, 2014 | 2006 Buick LaCrosse

1 Answer

Where to get instructions for replacing windshield washer pump in 2005 buick lacross


the washer pump for my 2005 bulick alluer will not work, it will work now and then. but i have not be albe to get it to work for the past 2 weeks now.

i have tryed swicthing the fuses but nothing did noting anybody have any ideas?

or could tell me where the wire conetction is?

aslo thanks for the help :)

Dec 10, 2010 | 2005 Buick LaCrosse

1 Answer

Where is the buick lacrosse 2005, steer power reservior located?


passenger side of engine compartment roughly and to the rear of the P/S pump, black plastic reservoir with cap about the about 1" in diameter which is marked "power steering fluid"

Oct 08, 2010 | 2005 Buick LaCrosse

2 Answers

Can't find the fuel filter!


I have a 2002 Lesabre but suspect it is in the same vicinity. Look under the car, drivers side under the passenger door towards the middle of the car.

Mar 14, 2010 | 2005 Buick LaCrosse

1 Answer

HOW DO YOU CHANGE THE SECONDARY AIR INJECTOR PUMP ON 2005 BUICK LACROSSE


Good chance that it's in the wheel well. Do some research and make sure there's no text service bulletins on the vehicle.

Oct 27, 2009 | 2005 Buick LaCrosse

3 Answers

I cant find the fuel filter on my 05 buick lacrosse


The problem more than likely is not a fuel filter problem,Its sounds more like an ignition problem.

May 26, 2009 | 2005 Buick LaCrosse

Not finding what you are looking for?
2005 Buick LaCrosse Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...