Question about Jeep Grand Cherokee
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Sorry brother, it is in the gas tank with the pump. they used filters that are suppose to be good for the life of the vechicle. you can see the plug if you lift up your spare. hope you dont HAVE TO go in there.
Posted on Mar 23, 2009
If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.
Posted on Apr 05, 2009
oil pressure problem should be checked independently of other problems...Use a good accurate mechanical gauge to check. If pressure is good (no less than 15psi at idle hot (I prefer to see at least 20) check dash grounding, block ground and if OK, change sending unit. Dash and body ground can influence operation of shift and body control modules so indirectly your problem may or may not be related, depending upon what you find while testing. And it could turn out to be a defective module! They are expensive and just plugging new ones in may work, but then again, it might not. I might be totally incorrect on this...that's the value of actually being there instead of doing this by "remote control".
If you read the numerous posts pertaining to all vehicles, you will see that you are not alone with electrical problems...As long as the engineers who design this stuff, keep using "modules" to replace ordinary simple and reliable systems, we will continue to have these problems. Do some testing and I'm sure you will find a solution! (I'm still waiting for someone to make a program for a PC that will give a complete readout of every system in a vehicle, including exact faults instead of general system "suggestions")
Posted on Apr 07, 2009
P0700 means there is a transmission fault code in the transmission controller. Since the transmission controller doesn't have a light attached, it tells the engine controller to turn the light on using this code. You'll have to access the transmission controller to further diagnose the problem.
Posted on Jun 14, 2009
If you haven't changed the plugs or had the fuel system cleaned, now would be a good time to do it. The number 1 culprit for rough idles is dirty injectors or plugs. You can try an injector cleaner in a can (or bottle) for under $10 and see if it helps, and then work from there. If there isn't any improvement then if you are able to, check the plugs for any gunky buildup and if you find a bad plug, make sure you replace them all (or have them replaced) at the same time.
Posted on Aug 03, 2009
Tips for a great answer:
May 26, 2015 | 2000 Jeep Grand Cherokee
Aug 31, 2014 | 2000 Jeep Grand Cherokee Limited
Jan 12, 2014 | 2000 Jeep Grand Cherokee
Dec 03, 2011 | 2000 Jeep Grand Cherokee
Feb 12, 2010 | 2000 Jeep Grand Cherokee
Nov 09, 2009 | 2000 Jeep Cherokee
Jun 29, 2009 | 2000 Jeep Grand Cherokee
Mar 21, 2009 | 2000 Jeep Grand Cherokee
Mar 18, 2009 | 2000 Jeep Grand Cherokee
14 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: