Question about Ford Cars & Trucks

Open Question

1982 ford f100 wipers wont turn off while key is on

Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 116 Answers

SOURCE: Why no juice from the

Ignition switch may be bad check see if there is power to switch at large yellow wire if power does not go thru switch to yellow/gray (run power)wire and red/lt blue(starter power). If it does sw good if not switch is bad

Posted on Jan 12, 2011

  • 6826 Answers

SOURCE: I have a 1981 ford f100 but each time i turn off

Anytime the windshield wiper blades do not park themselves normally, the windshield wiper motor should be replaced.

Posted on Jan 17, 2011

  • 3 Answers

SOURCE: i have a 1982 f100

had this problem once and it was a wire inside the electronic distributor. would bend when it got hot and break contact. when the engine cuts out check if there is spark.

Posted on Mar 22, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1982 ford f100 300-6. transmission shifts late and jerks in the gear when it engages. has a throttle cable to the transmission.

that throttle cable is for the passing gear , how is your fluid , ck for a vacuum leak to the modulator that will do it

Dec 03, 2014 | Ford Cars & Trucks

1 Answer

Ford F100 brake diagram

I have a 2004 kia sedona that will not start been told its immobilzer in key

Jul 26, 2013 | Cars & Trucks

1 Answer

1981 F100 wiper motor replace instructions

simply unbolt it from the firewall and replace it.

Mar 03, 2013 | 1981 Ford F 100

1 Answer

I have a 1982 f100 cranks runs 5min an cuts off wont start until get cold

had this problem once and it was a wire inside the electronic distributor. would bend when it got hot and break contact. when the engine cuts out check if there is spark.

Mar 22, 2011 | 1981 Ford F 100

1 Answer

Will my 1970 f100 body fit on a 1981 f250 frame?

It is probably going to require special mounts to be fabricated. Be prepared. It can be done with patience, time and money

Nov 03, 2009 | 1982 Ford F 250

1 Answer


It is possible that you do have bad rings and is causing an excess amount of crankcase pressure. Since you just have a hose hooked up now. Try running it to the big port vacuum fitting on the base of the carb.

Apr 26, 2009 | 1981 Ford F 100

2 Answers

Engine wiring Diagram for a 351 cleveland

have you gotten an answer for the wiring on your 82 ford bronco w a 351C? i have the same problem putting a 351C into my 81 ford bronco

Mar 13, 2009 | 1981 Ford Bronco

1 Answer

1982 F100 vacuum modulator, C5 trans

Adjust your linkage sounds like your half way in gear

Nov 09, 2008 | 1982 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides