Question about Cars & Trucks

Open Question

Iveco daily head lights not working - full beam ok & side lights ok. have checked the fuses

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chrischronic
  • 235 Answers

SOURCE: turn head lights on every light works except low beams

thare is a high beam relay and a low beam relay in the fuse box find the low beam relay and replace it. if this dont work its probabley the switch

Posted on Jan 13, 2009

Ad
MsMithra
  • 79 Answers

SOURCE: Headlights not working

If all fuses and bulbs are fine, it's probably a problem with the wiring harness. Take it to the dealer. Wiring harnesses are not something to do by yourself unless you're experienced with wiring on the specific car.

Posted on Feb 05, 2009

  • 1 Answer

SOURCE: low beams on head lights not working

Hi,

I had this problem.
In Canada all cars come with daytime running lights- (DRL) My 2004 Kia Sedona had this problem and it was the DRL Module.

Serach internet to find it's location. ( I think it is under the centre console, but dealer changed under warranty)

It should not be hard to find and change - It is usually just a small plastic box... plus or minus the size of a fist.

I don't know if DRL is required in the USA but it may be standard on Kias

Posted on Mar 06, 2009

  • 1 Answer

SOURCE: reprogramming blank key iveco daily

Unfortunately there is no solution to this except to take it back to Iveco for reprogramming.

I am led to believe from my locksmith that there are two types of transponders generally put into cars and vans.

The first is a simple chip wtih a code which matches a code in the car / Van

The second is a chip which has a set of codes. They are read in order and the car / van remembers which one was used last. If you use the wrong code in the sequence then the car / van will ignore it and not let you start the engine.

The Iveco is unfortunately in the second group. If, like me, you snap your key, you can superglue a new key to the old and it works fine. The chip doesn't need to be "too" close to the barrel. Yes, it looks ugly, but it's much cheaper!

Posted on Apr 19, 2009

co7196
  • 3433 Answers

SOURCE: Rav 4 headlight wont work

Headlamp doors are vacuum operated. Chk for a vacuum leak.

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Headlights wont go on all other lights work. Just high beam and low beam and the blue high beam indicator light on dash. changed headlight switch checked battery ground cable and ground wire to body.


check the fuse block under the hood, drivers side . head lights have fuses there may look ok but check with continuity tester to make sure. test wires at the head lights as well. best bet is the fuses

Oct 06, 2013 | 1996 Dodge Neon

1 Answer

Low beam head lights don't work 1999 Lexus LX470


Don't forget to check the Relays.... Black boxes associated with the fuses... Also there are usually two fuse blocks ONE inside of the car on the drivers side: Under the dash, or on the side of it. TWO is under the hood in the engine compartment area either on the firewall or on one of the fenders usually close to, same side as the battery.

Feb 25, 2012 | 1999 Lexus LX470

2 Answers

2003 GMC Envoy low beam head lights will not come on. The bulbs are not blown, fuse's ok, no power coming to the head light connector. minimal power to the fuse compartment with fuse removed. 9 to 10...


The problem is a Headlight module. Fuse box under the hood has two black modules side by side, the one on your right is the headlight module the one on the left is the fan module. Try swapping them, if the headlights work replace bad module, don't drive vehicle with the bad module in the fan slot. Mine kept going bad because I had a high intensity bulb on one side.

Oct 02, 2011 | 2003 GMC Envoy

3 Answers

I have a 2006 ford escape and the passenger head light low beam will not work. Tried replacing the bulb, and check fuses nothing is working.. what else can I try?


Both your low beam and your high beam is protected by the same fuse, so it makes sense that the fuse is OK if the high beam is working on the passenger side. There are 3 fuses for the headlamps. Fuse #13 in the Battery Junction Box (20 Amp). If this fuse is blown, the headlamp relay will not have any power and neither high nor low beam on either side will work (you will have no headlamps at all) Then there is Fuses #2 and #3 (15 Amp) in the Battery Junction Box. #2 goes to the left low and high beam and #3 goes to the right low and high beam.
The headlamp switch uses a SINGLE CIRCUIT to control BOTH sides at the same time, so if one side works, the switch cannot be the problem. The headlamp relay provides power for fuses #2 and #3 and we already ascertained that these fuses must have power since we have working lights on both sides, so the relay cannot be the problem. A replacement bulb has already been tried, so that pretty much leaves us with a bad lamp socket. (Most likely cause) or a bad connection at splice #S122, which is located in the main wiring harness near the breakout for the left headlamp. (RED/BLACK wire)

May 16, 2011 | 2003 Ford Escape

1 Answer

I have aproblem with my Buick Allure both low beam stoped working.The high beam works OK. Checked the fuses and there OK can you help


suspect low beam head light fuse, check fuse if ok suspect that both low beam head lights are burned out ( it happens) ,if ok suspect headlight dimmer switch.

Nov 16, 2010 | Chevrolet Avalanche Cars & Trucks

1 Answer

No low beams bulbs are ok fuses look good


There may be a relay that operates the low beam lights, check the owners manual to see if there is a relay, you should be able to hear it go "click" if there is one.

Dec 26, 2009 | 2006 Hyundai Sonata

1 Answer

I own a 1995 honda odyssey minivan and the drivers front head light is not working because of the wire connection? what do i do to fix this problem because I got stop for having only one headlight? thank...


hello annette from uk you think it may be connection ?? is head light not working on dipped beam? but high beam ok ? if so it may well be the low beam element in h/light bulb has blown however you could also check the fuse as each side head and sidelights have their own fuse check handbook for position of fusein box if ok then you can try the other head light bulb from other side into the plug connector of drivers side and if this works on high+low beams ? your old bulb is blown feel sure you can do these checks !? approx price of new bulb in uk £4 -50 but carry out above checks !st b 4 you buy bulb ? if it is a bad connection on plug ? another bulb will have same problem hope you understand all above ? and wish you good luck from n/west uk

Oct 30, 2009 | 1995 Honda Odyssey

2 Answers

Head lights not coming on. Only day time running lights on. this car has two sets of head lights. I see other jaguar drive by with the out side head lights on but my only lights that come on are very dim...


The daytime running lights are usually the high beams, running at about 80% intensity. Your outer lights are the low beams. Check your fuse box and make sure you don't have blown fuses for the low beams. If the fuses are OK, check to be sure the bulbs are OK. If they are, I'd suspect either a dead or stuck headlight relay, or a bad lightswitch. Check the fuses and bulbs and post your results, and we can take it from there.

Jul 21, 2008 | 2002 Jaguar X-Type

4 Answers

Low beam headlights do not work, but high beam headlights do


Clyde,

I've been troubleshooting this same problem on a different vehicle this week, and I can give you the steps I'd take.

1. If both sides went out at the same time, the problem is *NOT* likely to be the bulbs.

2. Check the fuses to see if both low beam lights are on the same fuse. Many cars have one fuse for low beam and another for high beam, so both lights out at the same time typically means fuse blown.

3. If the headlights are OK and the fuses are OK, then the problem is *LIKELY* the headlight switch. In my case, AutoZone has one and it can be installed easily; but in your case, that may not be as simple.

Please post your findings or comments.

Jul 16, 2008 | 1991 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

569 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...