Question about Cars & Trucks

1 Answer

2001 CHEVY TAHO REPLACE WATERPUMP / NO HEAT

AFTER REPLACING WATERPUMP&THERMO NO HEAT

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 27 Answers

Did the heat work before? I need you to be more specific but you can try removing the hoses to the heater core and flushing it out.

Posted on Oct 19, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 490 Answers

SOURCE: is replacing the waterpump and thermo hard

NO. the top radiator hose is where the thermostat is,r&r the bolts set the hose and the goose neck to the side remove the gasket and the thermostat,replace the new one in the reverse order.(pay attention to the direction of the thermostat when you install it.
The water pump loosen the belts, drain the radiator using the pet **** under the radiator,or you may use the bottom radiator hose,take it off the water pump and drain into your pan.r&r the bolts from your pump and remove the pump.Clean your gasket area and installl new one in reverse order.

Posted on Aug 01, 2009

  • 242 Answers

SOURCE: why dosent my rear heat work in my 2003 chevy taho

check fuse,wiring on back of heater or relay

Posted on Dec 24, 2009

  • 5 Answers

SOURCE: heat not working after replacing thermostat two times? in 2001 chevy 2001 silverado

try to blow out your heater core lines with about 15lbs of air and see what happens. loosen both sides just in case somthin yucky comes out.

Posted on Oct 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 s10 chevy blazer taho 4.3l v-6 replaced the distributor cap rotoe and the Ignition control module now it wont start at all


what was the reason for replacing cap rotor and module? any loose or corroded connectors?

Oct 13, 2013 | Cars & Trucks

1 Answer

I just bought a 1995 jetta and it's running at 260 degrees. Is this too high, and if it is then what would be causing this?


CHECK TO SEE IF BOTH COOLING FANS RUNNING ARE RUNNING WHEN ENGINE RUNNING START OVERHEATING IF COOLING FANS NOT WORKING CHECK COOLING FANS LARGE FUSES IN THE ENGINE COMPARTMENT OR YOU COULD FAULTY COOLING FANS THERMO SWITCH BOTTOM LEFT SIDE OR RADIATOR.IF COOLING FANS IS WORKING WHILE ENGINE RUNNING.RADIATOR CORES AND HEATER CORE COULD BE CLOGGED.COOLANT SYSTEM NEED FLUSHING. THE THERMOSTAT PARTIALLY CLOSED CAUSE ENGINE OVER HEAT.CHECK WATERPUMP WEEP HOLE IF LEAKING WATER PUMP NEED REPLACING.

Jul 21, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

Car over heating.... changed water pump,raditor, milled heads,replace computer, flush block, thermo still over heats


YOU HAVE A THERMOSTAT THAT IS OPENING AT 195 (TO HIGH) TRY REPLACING IT WITH A 160 DEGREE IT WILL ALLOW THE SYSTEM TO FLOW MORE FREELY, ALTHOUGH THE HEAT WILL TAKE A BIT LONGER TO HEAT UP, THE ENGINE WILL STOP OVER HEATING. YOU SHOULD HAVE DONE THAT FROM BEGINNING.

Sep 12, 2010 | 2001 Pontiac Grand Am SE

1 Answer

I have a 2001 chevy 5.3 engine running hot change thermstat,had to bypass heater coil because line broke off


have you started truck and seen if there is flow in the radiator? If not replace the waterpump, Although it may not leak it can still be bad....

Jun 14, 2010 | 2001 Chevrolet Silverado

1 Answer

97 chevy taho cant find the blower motor relay


Look under the pass side of the dash. It should be at about 7 o'clock to the blower motor. It is not hard to replace.

Hope this helps

Feb 10, 2010 | 1984 Chevrolet Chevy

1 Answer

Why dosent my rear heat work in my 2003 chevy taho


check fuse,wiring on back of heater or relay

Dec 24, 2009 | 2003 Chevrolet Tahoe

2 Answers

How to replace 2001 Chevy Taho fuel filter


the fuel filter is located down under the middle of the frame rail, on the drivers side,remove the lines from the filter, look out b/c some fuel will come out after diconecting the line. replace with the new filter make sure you get the "FLOW" "should be marked on the filter" pointing to the front of the car

Sep 27, 2009 | 2001 Chevrolet Tahoe

1 Answer

How to replace the thermostat on 2001cadillac deville


4.6 Northstar V8. It is located on the rear of engine (driver side) in front. It is 1n the the waterpump housing cover. Remove airbox and intake tube and bottom radiator hose. 2 bolts(believe 10mm) on thermo housing. These systems are a lil finiky about air pockets....so fill slowly and let run at idle until operating temp and let cool and chk level.....fill as needed and repeat if needed.

Jul 06, 2009 | 2001 Cadillac DeVille

1 Answer

Electrical problem


Check your trailer plugin wires at back of veh.

Dec 01, 2008 | 1996 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...