- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
po141, may be a bad o2 sensor, rear sensor after converter. the po 141 is low voltage to tps, try replacing the oyxgen sensor first and then reset the codes and drive if the po141 comes back then replace the tps,
Ideally You need a Spacial tool That Holds the Flywheel But My Guess is you Dint Have that tool So You Need to Expose the Flywheel And Use a Extra Large FLATHEAD SCREWDRIVER , you must Poke it into the teeth of it and let it Rest against the Trans Case at the Same time Easier to do with a Helper Just Long Enough to Break the Pulley Bolt Loose. This Method Can Be Used Also to Tighten the Bolt. Good Luck on your Project
×