Question about 2006 Acura RSX

1 Answer

High beams dont work

I am wondering why both high beams don't work. I have no issues with low beam/running lights, however neither R/L high beam works. I replaced one today, but no luck. Any help would be greatly appreciated!!

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

There is a relay in the power block/ fuse box under the hood.

Posted on Oct 18, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
bobjrdns
  • 84 Answers

SOURCE: 2002 acura tl headlight issue

MAKE SHURE YOUR GROUNDED AND THE BULB IS IN RIGHT SOME BULBS YOU CAN NOT TOUCH WITH YOUR FINGERS BECAUSE OF MISTURE ON SKIN

Posted on Oct 18, 2008

  • 1 Answer

SOURCE: Low Bean Lights Inoperative on 1997 Acura TL

If your car is running daytime running light system .. there is a DTR relay that goes defective and needs replacing ... I had the identical problem that was fixed with this replacement. The DTR relay is behind the glovebox.

Posted on Feb 08, 2009

  • 104 Answers

SOURCE: Right headlamp doesn't work on low beam only

in this case make sure you have voltage going to the low beam lights. 12 volts. you need a volt meter. if you do not have volatge you have to check and make sure power is going through the fuse. a bad fuse will be broke, but you can have a good fuse with no power going through it. if you have power going through the fuse you have a wiring open somewhere between fuse and whatever is between the headlight connecter.

plz check and get back i will keep checking on here on and off.

Michael
ASE certified
PLZ rate

Posted on Feb 09, 2009

  • 1 Answer

SOURCE: 2002 Acura RSX low beam headlights dont work. All

The same thing happended to my Acura RSX and now they are saying that it is an electrical problem. I put new bulbs and both of them are fused

Posted on Mar 17, 2010

  • 1 Answer

SOURCE: 2002 Acura TL low beam headlight

How to Shift my headlight beam from position.
from I replace my headlight it's spatting directly on the ground..What can i do to change it from position

Posted on Feb 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there any fuses or relays that are not in the fuse box on a 2002 buick rendezvousfor the bright lights


The high and low beam lights use the same power source, so if the low beams work the high beams have power.
There is a low and high beam relay controlled by the dimmer switch.
If the low beams work and the high beams don't, and the bulbs are good, check the dimmer switch and the high beam relay.

Aug 04, 2012 | Buick Rendezvous Cars & Trucks

1 Answer

GMC Envoy 2003 SLT only the parking lights and fog lights work. The low beam and high beam don't work. Please help


Well, the problem is that I dont know the reason, you should investigate. There could be issues with lamps (must get new) or electricity problems (must head to auto-service)

Jun 29, 2012 | 2003 GMC Envoy

1 Answer

Low beams don't work on 1997 Honda Civic


If your high beams work and your low beams do not work... try changing the light bulbs first. The low beams can burn out and the high beams still work.

May 01, 2012 | 1997 Honda Civic

2 Answers

2005 Ford Focus ZX3 SES, the blue high beam indicator in the dash comes on with low beams, and goes off with high beams. The indicator is on at the wrong time! I have tried the following: The turn signal...


It sounds like you are confused about how your headlamp system is supposed to work. The DRL does not run on the High beam circuit, it runs on the low beam circuit. The fog lamps are supposed operate with the park lamps and also with the low beams, not the high beams. From your description, I would say that your system is operating as designed and you are having trouble telling High from Low. (Don't feel bad, that is why high beam indicators were invented in the first place.)

May 08, 2011 | 2005 Ford Focus

1 Answer

My headlights went out dont know what the problem is low beam dont work high beams works


it may be the dimmer switch located on the base of the steering colume that is not working on the low beam side.also the headlights themselves may need changing if the low beam filament is burnt out and you didn`t realize one was burnt out then the other one burnt out.if that`s not the case then it could be a bad connection at the plug connector for the low beam or for some reason power is lost between the switch and the headlight.you don`t say if this has day time running lights,if it does then it could be the drl relay that is bad.

Apr 21, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

I have a 2005 dodge caravan. the headlights have


On the van you have a high beam fuse and relay. On the low beam you also have a fuse and relay. Check the fuse/relay panel for a blown fuse controlling the low beam lights. If you do not find a blown fuse have some one to turn the key on and turn on the high beam lights> During this time locate the low beam headlight relay and place your finger on top of relay, have the other person to switch from high beam to low beam lights. You should feel a click in the relay when they make the switch from high to low beam. If not replace the relay and the problem should go away. Hope this will help you.

May 28, 2010 | 2005 Dodge Caravan

1 Answer

HIGH BEAM DONT WORK BUT LOW BEAMS DO I HAVE A MONTE CARLO 07 AND I AM WONDERING IF ANYONE HAS THE PROBLEM WHERE THE RUNNING LIGHT WORK BUT THE HIGH BEAMS DONT. iT WORKED FINE THIS MORNING AND WORKS FINE IF...


hiya, it sounds like a problem with either the stalk for the lights high beam or the relay isnt latching properly. id start with the relay as some relays on cars are interchangable. swap one over for another that is the same then try it. if this doesnt work try a new stalk. hope i helped :0)

Jan 28, 2010 | 1996 Toyota Tacoma

1 Answer

Low beam not work !!


replace the headlight bulbs. Usually when the bulbs blow out the low beam blows out first, but the high beams still work. If you want and need both low and high beams to work then replace the headlight bulbs with brand new ones and I garauntee that both low and high beams will work

Mar 27, 2009 | 1999 Dodge Caravan

Not finding what you are looking for?
2006 Acura RSX Logo

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...