Question about 2000 Ford Mustang

1 Answer

2000 ford mustang gt Turn on key and no power, no

2000 ford mustang gt Turn on key and no power, no dash lights no headlights no horn truck switch or remote doesn't work put 12 volt tester on + battery cable and engine, tester lights up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 310 Answers

If its a handchiffted gearbox put in highest gear.
puch the car to the front and back till you hear a click.
if he starts .check the ignition.if this is not correct the car have a death spot.

Posted on Oct 18, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 58 Answers

SOURCE: 2000 ford focus.car won't start

The first thing you should do is remove the cables from the battery and clean both the clamps and the battery posts until the surfaces look bright.
I apply a protective coating before I replace the cables but it's not necessary to find out if you have found the problem. After you tighten the battery clamps, try to twist the clamp with your hand. If it moves it is not tight enough.
I've often see cars with battery post to small for the clamps.
If it's loose and you can't tighten it any more, you can purchase lead cups that fit over the post.
Remove the clamp and back the nut up as far as it will go, then use a screw driver to spread the clamp. Put the lead cup over the post and press the clamp down until the post is flush with the top of the clamp and tighten it.

Posted on Jan 09, 2009

smartr10U
  • 1305 Answers

SOURCE: i have no headlights on 1988 mustang gt

Check headlight lamps... then follow the wiring from the bulb connections back and make sure you're getting a good solid ground connection. It may have a loose, broken, severed grounding wire.. it's usually attached to the car body at some location not far from the headlights.

Posted on Oct 14, 2009

  • 1 Answer

SOURCE: 2000 ford windstar won't start

also check to see if anti theft light is flashing some of them will disingage the starter

Posted on Mar 04, 2010

  • 1 Answer

SOURCE: F150 ford truck 1990 key wont turn over engine new ign. switch

we have 1998 ford f15 we replaced the ignition and it still wont start the truck,, the key turns over now and the radio and everything comes on but it wont start, what is wrong???

Posted on May 09, 2010

  • 58 Answers

SOURCE: 94 MUSTANG GT,STARTER CLICKS BUT WONT CRANK, NEW

When you installed the starter you may have inadvertently put the gears in a bind. Make sure the bendix meshes properly with the flywheel. The bendix is the small gear on the starter that slides out and connects with the flywheel when the ignition key is turned.

Posted on Oct 09, 2010

Testimonial: "thanks"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 caravan headlights stay on. And no tail lites but brake lites and turn signals still work and horn beeps randomly on its own.


Replace the turn signal switch. All exterior lights run threw it, except the high mount brake light. The horn also. If the head light switch is on the handle, this should take of it also. If the headlight switch is in the dash, you might have to replace it also if they stay on.

Sep 27, 2016 | 2000 Dodge Caravan

1 Answer

While driving on the interstate, my 2011 Mustang GT suffered a complete electrical shut down. The car died and nothing electrical will work. Twelve hours later i still do not have any electrical powe


ck the back of your alternator , ck the wires , also the same for the starter sounds like a wire broke of or shorted out , look good you will find it or your alterantor went bad and will kill the battery for sure , ck that too,

Dec 15, 2014 | 2011 Ford Mustang GT

1 Answer

Hello i have a 1995 ford mustang gt and i need a diagram for the electricle cluster that sits in the dash board that controlls the hd lights, tail lights, break lights etc thank you


im not sure what your talking about, it sounds like you want the wiring for the cluster, but this doesnt control brake,tail or headlights, the brake lights operate through the brake light switch and go through the signal light switch to power those up. the headlights and tail lights work through the head light switch, what system do you need, or what doesnt work.

Apr 06, 2010 | 1995 Ford Mustang

1 Answer

My dash lights quit working on my 98 Ford Mustang GT. I checked the fuse and my tail lights and brake lights work. everything else works. What else could it be.


the headlight knob is also a dimmer for the lights on the dash. try turning it all the way one side, then check fuse if still not working.

Mar 29, 2010 | 1998 Ford Mustang

1 Answer

I have no headlights on 1988 mustang gt turn signals brake lights and parking lights and dash lights all work but the head lights wont come on checked all fuses and relays there all good thanks


Check headlight lamps... then follow the wiring from the bulb connections back and make sure you're getting a good solid ground connection. It may have a loose, broken, severed grounding wire.. it's usually attached to the car body at some location not far from the headlights.

Oct 14, 2009 | 1988 Ford Mustang

2 Answers

On my 1996 Mustang GT, when I turn on my headlights, my dashboard lights go out. Is that a fuse, ground or some other issue?


The proposed problem sounds like the problem I had with a 95 Mustang. Check the tail lights as well as the dash lights. If both are out when the headlights are switched on, the problem more than likely is with the headlight switch. The 95 had a poorly designed wire and plug configuration going into the switch. The wiring was too small and the plug would literally melt. The headlight switch and plug has to be replaced in this case. The problem was supposed to have been cleared with the 96 Mustang; however, a persistent problem may suggest checking the plug/switch combination.

Aug 29, 2009 | Ford Mustang Cars & Trucks

Not finding what you are looking for?
2000 Ford Mustang Logo

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...