Question about 2008 Nissan Versa

Open Question

How to replace blower motor resistor on 2008

How to replace blower motor resistor on 2008 Nissan versa

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 45 Answers

SOURCE: 2004 Nissan Altima Blower Resistor

there is a blower resistor located near blower motor and housing under glove box area it is one connector with about 5 wires to it and looks thin, held by two screws this resistor controls fan speeds - possibly it will look burned may even be hot to the touch so be carefully it is the most probable cause since you obviously have power to it and ground only being the fan speeds the problem.

Posted on Aug 28, 2008

  • 82 Answers

SOURCE: AC blower motor resistor Nissan Maxima 2000

yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,

Posted on Apr 19, 2009

  • 21 Answers

SOURCE: My AC quit in my 2007 Nissan Versa. The fuses are

You have to remove the dash to get to the blower motor on this vehicle if memory serves me right. It's a substantial job. Take it to dealer should still be under warranty.

Posted on Jun 17, 2009

cj2176
  • 520 Answers

SOURCE: Where is the blower resistor on a 2001 Nissan Sentra?

Its actually not that bad to change. If you open the glove box and remove the screws then the screws along the bottom of the glove box at the bottom of the dash the box will slide out. Remember to disconnect the light if it has one. Now you will be able to see the underside of the dash. You can see a large black box that has wires and vacuum lines all over. You need to locate a small flat plate with two screws and a plug in the middle. Disconnect the plug and remove the screws. The resistor will come straight out. The back side will look like small coiled up springs of different sizes. Install in reverse.Hope this helps. Good luck. Please re-post with updates. Thanks cj2176.

Posted on Jul 13, 2009

NismoMaster
  • 146 Answers

SOURCE: I bought the new blower motor resistor for my 95

The blower resistor should look like a credit card if it is manual air and it is located near the blower motor. Remove connector and then two screws and it should slide out. Replace with the new one. If you have auto air then the blower motor is regulated by a fan control amp which is located behind the glove box.

Posted on Jul 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan versa 2007 the fan and ac light stop?


No power passing through the switch to activate the fanin the heater box. First point is to check for a blown fuse. Next point is to see if the motor resistor are not burnt out

Jan 26, 2013 | 2008 Nissan Versa

1 Answer

Nissan rogue blower motor resistor


On the 2009 Rouge I have the blower motor resistor is located behind the cabin filter on the drivers side near the gas pedal. Followed the suggestion above and had to reinstall the glovebox as ipart was located on the opposite side. thx for that

Jul 02, 2012 | 2008 Nissan Rogue

1 Answer

Heater is on high will not change to a/c or lower speeds


The blower motor resistor is bad. First, determine if the resistor is separate from the blower motor. Most resistors are built into the blower motor. If separate, replace resistor. If not replace blower motor.

Jun 14, 2011 | 2007 Nissan Armada LE

1 Answer

2001 nissan maxima se--trouble shooting for blower motor resistor


if your blower motro only works on the #4 setting you need a resistor.cheap and easy to change.located next to blower motor under pass. side of dash.two phillips screws secure it.if it fails again replace blower motor as it is drawing too much current and overheating resistors.let me know how it turns out.

Feb 20, 2011 | 2001 Nissan Maxima

1 Answer

Nissan versa heater fan removal ,mice nest in heater box, need to clean. how do i remove the box/or fan


2008 nissan versa mice nest in heater fan box. how do i remove heater fan blower?

Jul 14, 2010 | 2008 Nissan Versa

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...