Question about 2005 Toyota Highlander

1 Answer

Vsc and trac light on after taking battery cable loose

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 91 Answers

You probably just need to go up to autozone or oreilly's and clear the code. It sounds like it is just a misread.

Posted on Oct 18, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
mecanica03
  • 905 Answers

SOURCE: Why is the vsc light check engine light and trac

to reset for a momentany malfuntion,disconnect the negative battery terminal few minutes, reconnect,start engine and drive to check

Posted on May 03, 2009

Murphybanton
  • 2004 Answers

SOURCE: What does the VSC light on the dash mean

VSC means Vehicle Stability Control. Take the car for a scan to ease your mind.

Posted on May 20, 2009

  • 1861 Answers

SOURCE: 2004 Sequoia. VSC TRAC, TRAC OFF, and Check

It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.

Posted on Jul 23, 2009

  • 21 Answers

SOURCE: 2004 Toyota 4Runner, Regarding The VSC TRAC and VSC OFF lights

Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.

Posted on Aug 04, 2009

  • 2 Answers

SOURCE: 2001 Toyota Sequoia VSC and TRAC OFF lights are on

I did research on line and all indicates that is caused by the YAW RATE SENSOR. It nedds to be replace and adjust. I have the same problem but havent find the time to get to it. When I do I will post it. If you do it before I do please email me with the result at solrako@yahoo.com
Good luck

Posted on Sep 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why are VSC, Engine, & TRC Off lights always on? I've tried to change the air filter with a new one. Now the car can accelerate only until 50 km/h, then car will stop. It seems that the car is choking


Check engine light, VSC TRAC & TRAC OFF lights - Toyota ...

www.toyota-4runner.org/.../4164-check-engine-light-vsc-trac-trac-off-li...
Jun 6, 2004 - I just bought it, and a few days later the check engine light, VSC TRAC, and TRAC OFF lights all came on. I took it to a dealership and was told ...

VSC and TRAC OFF lights came on? - Scion xB Forum


Nov 25, 2015 | Toyota Cars & Trucks

1 Answer

I have a 2001 Sequoia replaced connectors to battery. Now E brake light ABS light Trac Off and VSC Trac light are on. I disconnected ground and let it sit. Had code ran and it said open closed circuit abs?...


More than likley its your VSC computer (VSC Trac, VSC Off, E brake and ABS brake lights all lit). This problem has been sited on other Sequoias that had the TSB brake caliper/rotor upgrade (recall) and that more than likely the VSC software or computer was not updated to meet the demands of the newly installed brake upgrade.

Nov 19, 2013 | Cars & Trucks

1 Answer

VSC light came on, why?


Most of the time the VSC light will come on with check engine and trac off light. (picture of veh with squiggle lines behind it) Whatever triggers a Check eng turns the vsc and trac systems off. could be a loose gas cap or something related to emissions system. Most times it will have to be diagnosed. Veh maybe equipped to turn vsc off, there would be a button for it.

Feb 24, 2011 | 2004 Lexus RX 330

2 Answers

Toyota Camry V6 2003 with Check Engine, Trac Off and VSC lights on. Went to AutoZone and got code P0430. Can anyone assist with what to do next? Thanks in advance.


hey man sorry to tell you this but u will need a cat bank 2 its easy to take out it should only be 5 12mm nuts on the top and 2 14mm bolts on the bottom and some that r holding on to the trans.

Dec 13, 2010 | 2003 Toyota Camry

2 Answers

Trac off, trac vsc and check engine engine lights


Battery was diconnected for 1 minute and then reconnected. All lights are off.

Mar 24, 2010 | 2002 Toyota 4Runner

2 Answers

2002 toyota 4runner with the engine,vsc off,vsc trac lights on


NEED TO HAVE COMPUTER CHECK FIND WHAT CODE MADE THE ENGINE KLIGHT COME ON.. AND HAVE IT FIXED,, VSC LIGHTS COME ON BECAUSE THE COMPUTER DEACTIVATES THE VSC AS A SAFETY FEATURE WHEN CK ENGINE LIGHT IS ON

Jul 30, 2009 | 2002 Toyota 4Runner

2 Answers

VSC TRAC, TRAC OFF and CHECk ENGINE lights


You have to know what code is stored to fix the problem. Toyota's will generally display a Check Engine light, VSC and TRAC light all at the same time, even if it's a simple problem with an oxygen sensor (for example). You can disconnect the negative battery cable for a few minutes, even though you should a scan tool should be used, to clear out the code.

Jul 18, 2009 | 2006 Toyota Sequoia

1 Answer

Shaking with engine light and VSC Off lights turned on


If just found this on another forum:

A few days ago I started the Cruiser and had 4 indicators stay lit.
They were the CHECK ENGINE...SLIP INDICATOR..VSC TRAC..VSC OFF.
Didnt noticed any change in driving and 4-wheel drive is still working.
I removed the negative cable from the battery and the same indicator lights have NOT come back. Everything is back to normal as far as warning lights go. Should I take it in to the service center and have it checked.
Or should I wait to take it in, if it does it again?

Aug 16, 2008 | 2007 Toyota FJ Cruiser

Not finding what you are looking for?
2005 Toyota Highlander Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...