Question about 2004 Ford F150

Open Question

2004 f150 5.4 triton runs good until engine gets warmed up then it runs rough computer says #1 bank running lean

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 99 Answers

SOURCE: Check engine light comes on. p0171 and p0351 codes found

From Lusty Kid:

I know the economy is bad, but change all of the plugs. Check your PCV Valve hose, 150 rottens them out allowing air to be sucked in, thus all kinds of codes.

Depending on mileage. Dismount the EGR valve and clean passages. If you are really good dismount the throtle position sensor body and clean out passages with Choke Cleaner., dismount where the EGR valves connects to the engine, clean out passages. Also check the hose thats behind this mounting to ensure is not clogged. If clogged clean it out. If not replace it. Is about 1.5 ft. long, connects to the PCV Valve Hose.

When is the last time you change your harness. Can't remember??? Replace it. Good Luck

Posted on Dec 26, 2008

csmock132
  • 4669 Answers

SOURCE: check engine light on,idols rough,fine at all other speeds.

It either has a vacuum leak or a dirty MAF. To test for vac leaks spray the engine with carb cleaner to see if the engine speed changes., if it does you fond the leak. The most common leak is pcv line coming straight off the back of the throttle body. Check there first. Also check to make sure there are no air leaks between the throttle body and the mass air flow. Don't replace the idle speed motor or the tps, they won't fix it. It is possible the o2 is the problem, but it usually isn't. P0107 Is usually always from the stuff i listed above.

Posted on Mar 01, 2009

fingaz22
  • 1068 Answers

SOURCE: TOO LEAN CODES

yes very very common code for these motors i get them all the time. now the first thing i do is listen to the pcv valve for noise if it is rattling this is the problem and is the most common of all. another thing is the intakes leak from cracks in them but the only way to find it is with a smoke machine. now the one other thing i have seen before is debre like a leaf in the mass air flow sensor but you have replaced it so most likely no that.

do your self a favor and change the pcv valve it only cost under 5 dollars. if this is not it you will need to find the leak in and around the intake or a vacuum hose.

because you have two lean banks this mean if it is a leak then it has to be in common with both banks and that is the vacuum line system intake etc...

let mew know if you have any more question. good luck man

Posted on Oct 21, 2009

  • 1 Answer

SOURCE: system too lean bank 1 and bank 2

to fix your problem , you need a set of islator bolts , located inside the plastic plantam the seals are bad on yours,this is a postive fix ,just fixed same problem on my 2001 windstar codes 171&174,Jerry in Orlando

Posted on Jan 30, 2010

SOURCE: Engine codes run on 2004 Freestar

Make sure you have all the vacuum leaks repaired.
Disconnect the battery for two mins,codes my clear.
The codes you got are O2 Sensors,because of the vacuum leak,which leaned out the readings and set the codes.

Posted on May 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 chevy silverado 5.3L V8 runs rough and stalls


Well, code 336 is for a problem with the crank sensor, and code 171 is for fuel system too lean bank one which is the side with cylinder one. Since you have checked fuel pressure and I will assume fuel volume is good, the crank sensor or circuit could be at fault.

Jul 09, 2013 | Cars & Trucks

3 Answers

What causes the computer to read bank 1 to lean, bank 2 to lean. It also idles rough and will stall out while stopped. Runs great at operating speeds. It's on a 2004 F150, 4x4, 5.4 vin code 5.


More than likely you have a vaccume leak.Check arround the intake looking for any broken vac.hoses(especally the PCV hose) all the way up to where it connects to the intake.Could be a bad mass airflow sensor, but more likely a vac. leak.

Apr 21, 2011 | 2004 Ford F150

1 Answer

I have a 2000 Hyundai Sonata that runs rough when you start it up. I hooked a code reader to it and it said that system was lean on bank 1 and multi misfire and not reading 02 sensor on bank one. I have...


time to get the engine properly scanned, real time not code scanner, then you will have the readings from sensore and actuators, diagnose from there

Dec 14, 2010 | Hyundai Motor 2004 Sonata

2 Answers

Check engine light flashing runs rough not firing on all cylinder2000 lincoln navigator with large triton engine Hooked up diagnnostic and it said 1. system too lean bank #2 2. Unable to bleed up fuel tank...


you may try your rotor button and distributor cap. and spark plug wires. try your map sensor also they tend to cause a lot of misfiring if they go bad.hope this helps.

Apr 20, 2010 | Lincoln Navigator Cars & Trucks

1 Answer

Check engine light flashing runs rough not firing on all cylinder


take of the fuel filter and blow it out. i had the same problem with a 2008 ford f150 5.4 v8.

Apr 19, 2010 | 2003 Lincoln Navigator

1 Answer

I have a 2003 gmc yukon 5.3 the engine idles rough sometimes the idle will get so low the engine will shut off.(the engine runs good while driving) hooked to scaner po101 maf/vaf (dont know what vaf is),...


you have a vacume leak somewhere.check all of your vacume hoses for leaks.Injector seals can cause this too.Also intake gaskets could be leaking.Running to lean usually means the car is getting to much air coming in.To check leaks spray brake cleaner around the hoses and the bottom of your intake if the rpms change then you found a leak.

Feb 21, 2010 | 2003 GMC Yukon XL

1 Answer

I have a 2004 GMC Yukon. The engine light keeps


Check for vacuum leaks, especially the intake gaskets. Does it run rough on a cold start for a few seconds and then smooth out and run fine until the next cold start?

Mar 12, 2009 | 2003 Saturn VUE

Not finding what you are looking for?
2004 Ford F150 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...