Question about 2006 Chevrolet Equinox LT

Open Question

Remove center cup holder - 2006 Chevrolet Equinox LT

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: 2006 uplander. How do you remove the lower center

i had to remove this due to my wife pushing the center cup holder off of the track. to remove it you need to remove both side panels of the console. you can do this by pulling on the sides, they have clips holding them. i also had to unscrew the front of the console door to gain access. take your time and dont pull too hard and you should be able to get it. before doing that, try reaching your hand around the back of the console to see if you can reach. it is hollow back there. good luck

Posted on Nov 06, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the lower center console on a 2000 Olds Intrique


Item Part Number Description 1 060024 Floor console armrest 2 06010 Floor console storage bin 3 04338D Floor console finish panel (front) 4 044D90 Floor console finish panel (center) 5 - Floor console cup holder screws (2 required) 6 13562 Floor console cup holder 7 - Floor console front screws (2 required) 8 - Floor console rear screws (3 required) 9 - Floor console nut 10 045A36 Floor console Removal and Installation
  1. Position the seats as needed to remove the console.
  1. Disconnect the battery. For additional information, refer to Section 414-01 .
  1. Remove the floor console storage bin.
    1. Remove the 3 screws and the armrest.
    1. Remove the floor console storage bin screw.
    1. Remove the pin-type retainer.
    • Disonnect the electrical connectors.
  1. Remove the floor console front finish panel.
    • Pull upward from the front of the trim panel to release the retainers.
    • Disconnect the electrical connectors.
  1. Remove the floor console center finish panel.
  1. If necessary, remove the 2 screws and the floor console cup holder.
  1. Remove the 2 floor console front screws.
  1. Remove the 3 floor console rear screws.
    • To install, tighten to 4 Nm (35 lb-in).
  1. NOTE: Lift the console from the rear and slide it rearward to release the rear seat heater ducts from the instrument panel. Remove the nut and the floor console.
    • Disconnect the electrical connector.
    • To install, tighten to 8 Nm (71 lb-in ).
  1. To install, reverse the removal procedure.

Jun 10, 2015 | 2000 Oldsmobile Intrigue

1 Answer

How do I remove cup holder in center of dash?


There should be a rubber mat in the bottom of the cupholder that is removable for cleaning. The housing itself should be able to be washed with a warm soapy water solution then re-install the rubber mat.

Aug 23, 2014 | 2010 Chrysler Town and Country

1 Answer

I AM TRYING TO TAKEOUT A CENTER CONSOLE OUT OF A 2000 CHRYSLER INTREPID


Hi Ken, I'm glad to help! Ken I have removed so many of the center consoles on Intrepids, heck I can do it in my sleep. I'm not sure how far you have gotten removing it. But there are some hidden screws under the rear cup holder. Pull the rear seat cup holder out and there is one in the very front and 2 down inside the slot. Those are the only ones you need to remove the other screws simply hold the cup holder in. The rest of the removal is very easy. Hope this helps and have an awesome day Ken!

Apr 18, 2014 | 2000 Chrysler Concorde

1 Answer

Replacing cup holder


I assume you mean the one that flips up in the center console?

If so, there are three likely issues.

1) did you slide out the retainer from the upper screw? the top screw had a cover that had to be pried off. you then took the screw out. Lastly you have to slide out the plastic retainer that the screw went into. It slides out towards the opening.

2) you have to have the cup holder partially open to remove it. the hinged part that folds up is stored in the cavity under the console when closed. you have to open the cup holder and keep pushing until the front of the cup holder lip comes up. Work the cup holder up and down until it comes out.

3) the cup holder is stuck in place due to years of spilled liquid. If you've done the above, then you can either spray soapy water on the creases around the opening and let it set, or you can apply strategic brute force.
Be aware through. if this is the center console cup holder just behind the gear shifter. There are two screws and nothing else to hold it in. Just be carefull....

Mar 17, 2014 | Volvo S80 Cars & Trucks

1 Answer

I have an '08 TL with a very annoying object sliding back and forth when I brake and accelerate. Sounds like it is under the cup holder. I removed the trim on both sides. That is where I am stumped. Is...


the center console will prob. have to be removed , there are hiden screws, be patiant and thuroly look before just ripping out cup holder.

Feb 11, 2011 | 2008 Acura Tl

1 Answer

How do I remove the center front console, where coffee cup holder hood is?


Loosen the hex head set screw from the front of the Shifter knob. Pull it off, then remove the screws on the lower sides, as well as the ones hiding under the rubber cup holder. The entire assemble will now lift off.

Oct 29, 2010 | 2004 Chrysler Pacifica

1 Answer

Buick Regal cup holder problem


Yes absolutely you can my friend. and you are correct this will fit 1997 to 2004 actually!

Jul 10, 2009 | 1996 Buick Regal Olympic Gold

2 Answers

Remove the door that covers cup holder in the center console of a 2007 hyundai sonata


I dropped a card in between there a few months ago and had to retrieve it. Don't waste your time trying to fish it out..it's almost impossible and very time consuming. All you have to do is pull the rubber out from around the shifter and pry the entire plastic covering up. Be as gentle as possible. It should pop right off. Make sure the pull on the E brake so that you can remove the cover, as well. Hope it works for ya!

Apr 28, 2009 | Hyundai Sonata Cars & Trucks

2 Answers

Replacing cup holder unit on a 1997 toyota 4runner


Despite the other persons advice. on this part you cannot simply yank it out. You must remove the center console (where the stereo is). This is done by removing screws from behind the thin piece of plastic that has your temp controls etc. there may be other screws, but they are easy to find. pull the whole unit forward and then you will have access to the back of the cup holder. there are two "clips" that you can get to. depress them both and the old cup holder will come out. installing the new one may invovled a good shove from the front to engage the new clips. good luck!

Mar 30, 2009 | 1997 Toyota 4Runner

2 Answers

Broken cup holder in 2000 BMW 740iL


unfortuantly the whol center councle needs taken apart it is harder than it looks sorry for the bad news, an easy fix is to just replace the front part of the cup holder

Mar 24, 2009 | 2000 BMW Z8

Not finding what you are looking for?
2006 Chevrolet Equinox LT Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...