Question about GMC Sierra

Open Question

6.5 litre turbo diesel repair manual

I have a 1996 Chevrolet Silverado 3500 1 ton dually that doesn't rev up but it just barks when you step on it slowly. what do i do?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fyrebyrd1
  • 121 Answers

SOURCE: replacing starter 02 silverado 6.6

  1. Remove or disconnect the following:
    • Negative battery cables
    • Right front wheel and fender splash shield, on 6.6L engines
    • Turbocharger exhaust pipe, on 6.6L engines
    • Mounting bolts/nuts and shim, if used
    • Starter
    • Wires
    • Heat shield and bracket 0900c152801cad96.jpgExploded view of the starter motor-6.5L engine shown
To install:
  1. Install or connect the following:
    • Heat shield and bracket. Torque the bolts to 13 ft lbs. (17 Nm).
    • Wires.Torque battery wire nut to 89 inch lbs. (10 Nm), and ignition nut to 18inch lbs. (2 Nm) on 6.5L engines. On 6.6L engines, tighten the solenoidnut to 30 inch lbs. (3.4 Nm) and the positive battery cable nut to 80inch lbs. (9 Nm).
    • Starter
    • Mounting bolts/nuts and shim,if used. Torque the bolts to 33 ft lbs. (45 Nm) and the nut to 75 inchlbs. (8.5 Nm) for 6.5L engines. For 6.6L engines tighten the starterbolts to 58 ft. lbs. (78 Nm).
    • Turbocharger exhaust pipe, on 6.6L engines
    • Right front fender splash shield and wheel, on 6.6L engines
    • Negative battery cables

Posted on Nov 05, 2008

  • 341 Answers

SOURCE: 1991 CHEVROLET SILVERADO 2500HD 7.4 Litre 4x4 tow capacity

you can pull the boat no problem. as putting in a 6.2 for the 454 you will need to change wire harness inside and out..im the brake booster...... the gear ratio in the rear ends ..fuel pump ..im guessing you have a truck you will be using for parts.. if you are doing for fuel mileage you will be disappointed you will only gain a couple of mpg .. hopes this helps

Posted on Dec 08, 2008

redbeard00
  • 957 Answers

SOURCE: i have a 94' chevy 3500 dually with the 6.5 turbo diesel.

If it was the trani I would be waiting to hear you say something like it slams into gear or the RPM's go up but the speed doesn't follow. you can try to shift it in low and manually shift it up as needed. It could be that your truck is not starting out in first but rather second. Am I on the right track, is this what your trying to describe.

Posted on May 03, 2009

  • 29 Answers

SOURCE: Charging problem on 1996 Dodge Ram 3500 Cummins Turbo Diesel

I had the same problem on a 94 dodge with the cummins. It seems the crank sensor that reads from a notch on the harmonic balancer was the problem Without this sensor reading that the engine is running the alternator wont charge. Possibly the same problem with yours

Posted on May 03, 2009

Mike258
  • 1498 Answers

SOURCE: I need a color diagram for a 7 pin plug on my 2000

Hello,


Columns are Color, Function, Mark on the plug.

Seven wire Trailer plugs
:

Horse, stock or utility trailers:
White = Ground - 1
Blue = Electric Brakes - 2
Brown = Tail and clearance lights - 3
Black = Battery, aux power - 4
Yellow = Left turn/Brake - 5
Green = Right turn Brake - 6
Orange or Purple (not both) = Auxilliary or Reverse - 7

Recreational Vehicle:
White = Ground - 1
Blue = Electric Brakes - 2
Green = Tail and clearance lights - 3
Black = Battery, aux power - 4
Red = Left turn/Brake - 5
Brown = Right turn Brake - 6
Yellow = Auxilliary or Reverse - 7

Ground should be 10ga.
Others 14 ga

Best regards
Mike

Posted on Sep 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 one ton Chevrolet Silverado Dually has two gas tanks that are suppose to syphon together. No switch, but only one tank is working right, the rear tank, the one with the fuel gauge always shows full...


In regard to sender unit. Soak it in vinegar for a couple hours. Works awesome. I did this to my chevy pickup sender unit and now it works awesome. The problem is usually condensation over the years corrodes the brass wiper/rheostat. Vinegar is a mild acid and works excellent.

Sep 04, 2010 | 2003 Chevrolet Silverado 3500

2 Answers

Looking for name of part goes on 94 6.5 diesel bottom of fuel filter reservior connects with screw on ring has shaft that slides in middle of filtr and wires coming out bottom


94 chevy 3500 dually 6.5L turbo diesel - starts fine- then sometimes when hot, turns over but hard to restart, sometimes when driving and I accelerate it hesitates or misses as if not getting fuel I let off of pedal then re-accelerate and smooths out - any idea ?

Jan 17, 2010 | 1994 Chevrolet C/K 3500

1 Answer

Replace brake shoes on rear of 93 Chevrolet dually? I can't find the process for a dually in any of the repair manuals I can find in local part stores.....


1. pull axles apx 6-10 bolts.
2. remove large holding nut
3. remove keeper\
4. remove 2nd nut
5. should now be able to pull off brake drum

Dec 13, 2009 | 2001 Chevrolet Silverado 3500

2 Answers

I own a 2003 chevy silverado diesel dullay 4x4 and none of the controls work for the passenger side window, I need a wiring diagram.


Hi I have a 4x4 2003 chevy 3500 silverado dually with dual tanks
rear tank stoped pumping into front tank and was full . I siphoned the fuel out of rear tank and fuel gauge reads 9/16 full . is there a way to reset the fuel sending units so they can calculate the fuel readings. I always filled the two tanks with the same amount of fuel
until now ? I'm thinking there is a inkine fuel pump

Aug 31, 2009 | 2003 Chevrolet Silverado 3500

1 Answer

2008 3500 HD dually diesel. Check engine light


there are a couple of hunderd diff things that can turn this light on, u need to have the system tested to determine what the code is that was stored with the when the light came on.

Jun 28, 2009 | 2008 Chevrolet Silverado 3500HD 2WD

1 Answer

I have a 94' chevy 3500 dually with the 6.5 turbo diesel.


If it was the trani I would be waiting to hear you say something like it slams into gear or the RPM's go up but the speed doesn't follow. you can try to shift it in low and manually shift it up as needed. It could be that your truck is not starting out in first but rather second. Am I on the right track, is this what your trying to describe.

May 03, 2009 | 1994 Chevrolet C/K 3500

1 Answer

Serious understeer with 96 Dodge Ram 3500 Dually


Are the tie rod ends tight? Is the trac bar (frame end) tight? The steering boxes on these trucks require more input that a 1/2 ton truck or a car. How is the alignment? The caster on these should be set to about 5 degrees, the original specs allow a lot of wandering.

Apr 05, 2009 | 1996 Dodge Ram 3500 Club Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...