Question about Cars & Trucks

1 Answer

Manual sliding door on 1999 oldsmobile silhouette barely opens

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 818 Answers

CHECK THE LOWER TRACK FOR JUNK THAT HAS FALLEN INTO IT-CLEAN IT OUT AND SPRAY SOME WD-40 ON ALL THE TRACKS, THERE ARE THREE UPPER MIDDLE AND LOWER-CHEERS DENNY

Posted on Oct 18, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 98 Answers

SOURCE: My 1999 pontiac montana rear sliding power door will not work

I went to bulldogsecurity.com and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.

Posted on Mar 02, 2009

keeperoffire
  • 106 Answers

SOURCE: 2002 Oldsmobile Silhouette ABS Light is on and

The first thing i would check is all 4 abs sensors at the wheels.You can do this with a volt meter set on ac voltage and spin the wheel if it generates voltage at all on the meter its good.

Posted on Mar 06, 2009

  • 15 Answers

SOURCE: Dead battery in 1999 Oldsmobile silhouette

you have to take the fuse box out. unhook the hot wire from the front of the fuse box.then there is a little black holder with which you can take a flat head screwdriver and lift the little peg in the middle of it which will then come out. then just pull the fuse box off to the side and u should be to the battery.hope this helps

Posted on Mar 28, 2009

  • 1 Answer

SOURCE: 2002 Old Silhouette Driver Power Sliding Door will not open

Look in your owners manual there is a procedure to reset the door controls. If that dosen't work maybe the motor is burnt out, it's in the left rear access panel.

Posted on Apr 16, 2009

  • 27 Answers

SOURCE: 2001 Oldsmobile Silhouette....Power lock on my

From the back of the front door slide your hand in the sliding door crack and find the child-safety-lever. Push the lever up and/or down while moving the sliding door manual lock/unlock button to the up position. Also works on the non-powered sliding door.

Posted on Jul 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 OLDS SILHOUETTE BACK HATCH DOOR WONT STAY OPEN


Must replace both hatch struts..."Mighty Arm" on line great...snap on snap off...also available at most parts store for a few dollars more...

Oct 03, 2014 | 1999 Oldsmobile Silhouette

1 Answer

Can't open the sliding door, tried all the buttons and tried manualy on a 1997 oldsmobile minivan


I had the same problem, if you reset the door it may start working. The instructions on how to do that is in the owner's manual. If you don't have one i will post instructions.

Jun 07, 2011 | 1997 Oldsmobile Silhouette

1 Answer

Power sliding door does not open


Check the buttons on the ceiling. There's one that locks the sliding doors from opening from the back. I hit it all the time by accident.

Jan 14, 2011 | 2000 Oldsmobile Silhouette

2 Answers

The power sliding side door on my oldsmobile 2002 silhouette keep opening and shutting continuously. I changed the fuse as it wasn't closing before. help


i had the same problem with mine, on the door there is a metal contact that gets coroded. i wire brushed the plate then it closed and opened fine.

May 25, 2010 | 2002 Oldsmobile Silhouette

1 Answer

Beeping when in drive


sounds like the audio warning for the slider door
that sound is made to tell you the sliding door is open

Nov 27, 2009 | 1999 Oldsmobile Silhouette

2 Answers

2001 Oldsmobile Silhouette....Power lock on my power door doesn't come up completely and the door doesn't open with or without the button. What can I do? I also believe my van has other electrical issues...


From the back of the front door slide your hand in the sliding door crack and find the child-safety-lever. Push the lever up and/or down while moving the sliding door manual lock/unlock button to the up position. Also works on the non-powered sliding door.

Jul 15, 2009 | 2001 Oldsmobile Silhouette

1 Answer

05 caravan passenger power sliding door will lock but not open


READ YOUR MANUAL. THERE IS A SEQUENCE INVOLVING REMOVING A FUSE WHICH RESETS THE ELECTRIC DOOR OPENER. IT IS DESCRIBED IN THE MANUAL. EASY TO DO ONE YOU HAVE THE BOOK IN HAND.

Apr 15, 2009 | 1997 Oldsmobile Silhouette

1 Answer

2002 Old Silhouette Driver Power Sliding Door will not open


Look in your owners manual there is a procedure to reset the door controls. If that dosen't work maybe the motor is burnt out, it's in the left rear access panel.

Mar 25, 2009 | 2002 Oldsmobile Silhouette

1 Answer

My driver side mirror broke off on 1999 olds silhouette can't get door panel off found 2 bolts anything else or just force loose?


If you removed the 2 bolts near the handle (1 you reach by removing the lock & pwr windows control panel by prying it up, it will pop loose) there are plastic bolts/clips that press in through openings around the edge of the door panel. Just pry out slowly and they should pop out. Work your way around the door. It should slide off over the release handle which you may want to pull outward so it slides over it easier. I just did this 2 days ago to replace my passenger mirror.

Mar 08, 2009 | 1999 Oldsmobile Silhouette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...