Question about 2002 Hyundai Accent

1 Answer

How to fix the aerial on a 2002 Hyundai accent as the rubber has worn off around the aerial and just a hole now?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 135 Answers

You'll have to purchase the part from the dealer and I believe it isn't that expensive. One word of warning though, make sure you paint the rubber with a good quality automotive touch-up paint or the sun will destroy the new part rather quickly, I learned the hard way! If I remember correctly, I believe I had to remove the trunk liner panel near the antenna and the boot comes off with 1 (?) screw. And while you are at the dealer, you might want to pick up the brake pedal stop switch urethane button, under $2, as these fail and when they do your brake lights will stay on causing a dead battery situation. The button is on the brake pedal arm just below it's pivot point and contacts the brake light switch. What usually happens is you find the urethane button laying on the drivers floor mat in pieces, then you discover the dead battery because the brake lights stay on several hours.

Posted on Oct 26, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: 2002 throttle position sensor

The sensor is on the side of the throttle body, it has three wires going to it, it is connected to the throttle blade so when the throttle is opened it reads that info and sends it to the PCM.

Posted on Sep 02, 2008

fastboyz
  • 674 Answers

SOURCE: 2002 Hyundai Accent Problem

first thing i need to know is did the timing belt break?
second is are you sure you aligned the timing marks and after the belt tensioner was tight you rechecked to make sure the timing stayed where you had it.
next step would be a compression check to if a valve was bent whenchanging the belt
i have seen this happen and this engine is an interferance engine.
later paul

Posted on Sep 28, 2008

  • 566 Answers

SOURCE: 2002 hyundai accent needs brakes

hi from uk to renew front disc(rotors) and brake pads on the accent are not beyond the mech minded diy er and can easilly be done if you follow instructions on the haynes manual etc and would save$$$$s in dealer charges ? if you diy as for the rear brakes they are drum brakes with shoes that are auto adjust but again can be done by diy with help of manual ? as for cost of parts ? you can obtain/price of all parts from good auto shop/superstore also a manual ? then by all means obtain a quote ? for local garage to do the brakes with cost of labour and parts ? then consider option of diy? i am sure you will be tempted/inspired if you browse the work involved hope this helps? contact again if you feel lucky? will be glad to assist if you get stuck? or req info ? merry xmas from uk

Posted on Dec 19, 2008

jmassengill
  • 345 Answers

SOURCE: 2002 hyundai accent codes p1529 and p0734

P1529 means nothing more than the TCM (transmission control module) has requested that the ECM (engine control module) turn on the check engine lamp.
P0734 basically indicates that your transmission is slipping.
You need to take this car to an authorized repair center for hyundai cars. Replacing the filter and fluid on the transmission might save this transmission but I would be willing to bet that a total transmission rebuild is in order.

Good Luck

Posted on Jan 02, 2009

  • 740 Answers

SOURCE: timing belt on my 2002 hyundai accent 1.6 liter 4cyl

DID THE BELT BREAK AND THEN IT WAS CHANGED. If so then you may have bent valve. IF NOT then vehicle may be timed wrong. Here is a diagram of your timing marks, http://www.2carpros.com/car_repair_information/tec_info/2002/hyundai/accent/2002_hyundai_accent_timing_belt_diagram_marks.htm contact if you need more help. Thanks for using FIX YA

Posted on Jan 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have noticed that in really wet weather (moved to Vancouver recently), my 2002 Hyundai Accent GSI starts to smell bad (like wet carpet). Upon inspection, the back seats feel damp to touch and when I lift...


Check the trunk rubber for damage and/or improper mounting. There will ordinarily be drain holes in the area where the tail light assemblies mount to the back of the car. If they are plugged up, the water will have nowhere to go when it rains, and will seep through the gasket between the tail light housings and the body metal. If unable to find the problem, have someone soak the back of the car in the trunk / tail light area with a garden hose, and watch for water intrusion from inside the trunk with a flashlight (hopefully, the rear seat backs flip down so you can gain access to the trunk from inside the car). Good luck!

Jan 10, 2011 | 2002 Hyundai Accent

1 Answer

My code for my 2000 hyundai accent is: P0442 Evap system small leak im sure that the gas cap is on all the way.


may have a leaky vacuum line somewhere. The rubber seal on the gas cap could be cracked or worn out. they are easily replaced.

Oct 02, 2010 | 2000 Hyundai Accent

1 Answer

Where is the fuel reset button on a 2002 hyaundai accent?


the reset button on accent is located on the side of inner wing just tucked under the bulkhead it is a square unit with a rubber top this is the reset button so just press the rubber/button and try restart on uk models it is on drivers side so i assume if you have LHD your switch may be on right hand/drivers side ??

Apr 24, 2010 | 2002 Hyundai Accent

3 Answers

I have water collecting in the well in the boot around the spare wheel. the plugs in the boot seem perished (cracked rubber...old)...could this be the problem?


hi yes that would help but rember they are for you to drain with please check the seal rubbers around the boot also there are drain holes in the gully where the rubbers seal make sure they are not blocked check the rubbers are not perished or cracked

Nov 18, 2009 | 1997 Hyundai Accent

1 Answer

I can't find the transmission fluid container in my 1998 Hyundai Accent


accent cars come with a seal transmission meaning you can not add or remove oil the only place you can add oil to are your cv-joints trow a rubber cap locate around the cv housing.

Sep 27, 2009 | Hyundai Motor 1998 Accent

1 Answer

2002 Hyundai Accent 1.6 Check engine code


Take/Tow your vehicle to an authorized Hyundai dealership and pay the diagnostic fee... they will tell you exactly what the problem is and the cost of parts/labor to fix it... at least this way you'll know what the problem is and what's required to fix it.Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Aug 27, 2009 | Hyundai Accent Cars & Trucks

1 Answer

I have hyundai accent GVS make 2002. My car has ran only 57000 kms however it has started consuming engine oil since sumtime now. If we think about any engine effeciency its perfect like a new car but when...


The valve stem oil seals sound like theyre worn and oil is getting past the vlaves and been burnt in the combustion chamber,once the valve stem oil seals are replaced it should cure your problem as with only 57k kms the piston rings shouldnt be worn yet.

Jul 09, 2009 | 2002 Hyundai Accent

1 Answer

How do ireamove ierial on hyundai accent 2001


undo the nut on top of wing,weither its electric or manual its the same ,behind the panel is the body and normally their is another fixing their,if you dont have a plug for the cable then what i do is cut the wire and join it with the new aereal ariel arial aieral aerial got it right in the end ,please dont tell my old teacher as we got the slipper for every word we spelt wrong,swearing was three across the buttocks in assembly with trousers around your ankles.

Jan 28, 2009 | 2001 Hyundai Accent

1 Answer

Electric car aerial


Open the bonnet (hood) and prop open with a golf umbrella, remove three bolts holding the wing onto the engine compartment and one bolt in the middle of the door frame (with the door open), you can then pull the wing off enough to be able to remove / change the aerial.
The fixing at the bottom of the aerial unit to a bracket on the wing can be difficult to undo; I just broke it off and fitted the new aerial without the bottom bracket fixing.

Aug 16, 2008 | Hyundai Motor 1998 Accent

Not finding what you are looking for?
2002 Hyundai Accent Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...