Question about Mitsubishi Cars & Trucks

1 Answer

Heater fan problems/steering wheel

AC/Heat works fine but only when I turn the nob to level 3 or higher. when it is on 1 or 2 I don't hear nor feel anything. Also when my car gets past 65 miles/perhr the steering wheel vibrates/shakes a little. Could this be a bad bearing, wheel alignment?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Teacher:

    An expert who has written 2 tips or uploaded 1 video tip.

  • Expert
  • 138 Answers

There are several cause: wheel alignment, ball joint, wear out wheel. You have to check it, this ball joint must not wig to much and if wig then replace it life spam of this joint only 5 years or 4 years old,

Posted on Oct 18, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: high frequency vibration coming from the right front end at 65-70mph?

Check Four Things:

  1. Tires, Balance, and Alignment ($100)
  2. Tie Rods, Stabilizers, and Struts (known to be bad)(do the work your self) ($1,200)
  3. Rack and Pinion (know to be bad) ($1,500)
  4. Axle / CV Joints (High mileage 100,000+) ($900)
Good Luck I have done all three according to the dealerships suggestion, It solved some of it. Do it yourself buy harbor freight tools, rent some from Advanced Auto. Then buy your parts from NAPA which are better than originals it will save you $500-1,000. Or just Sell it to a scrape yard.

Posted on Oct 22, 2008

dsacco86
  • 1077 Answers

SOURCE: front end and steering wheel shakes

Most common problem would be tires are out a balance. Or, the tires are out of round ( meaning the tires have a hop to it; not completely round ).

Posted on May 22, 2009

  • 532 Answers

SOURCE: 2004 expedition, when brakes applied steering wheel vibrates

check the idler arm on the steering drag link

Posted on Nov 15, 2009

Testimonial: "Thanks I been busy I'll check it out this weekend and get back to you."

Molson02536
  • 3854 Answers

SOURCE: 2005 malibu - heat/ac has 4 levels for fsn, level

Your blower speed resistor has gone bad and needs to be replaced. You can pick one up at Auto Zone or Parts Source with the step by step instructions to getting the resistor replaced with common tools.

It is located under the glove box, way in the back of the passenger foot area. You'll need to remove 2 screws with a 7mm socket, and remove the plastic cover that covers the blower motor and another component box that I think controls the passenger airbag. After removing the plastic cover you'll need to side that passenger airbag module to the right so it pop off its mounting bracket and move it out of the way. That will give a better view of the blower motor. I highly recommend you also remove the blower motor itself because the Blower Motor Resistor is located behind it. I think you'll need a 5mm or 5.5mm socket to remove the 3 screws that hold in place the blower motor and 2 more screws for the Blower Motor Resistor... It's a cramped location to work in but if you have all the tools and enough lighting then it shouldn't take more than 30-60 minutes to do. The Blower Motor Resistor costs about $19-$25. Good luck

Posted on Nov 30, 2009

  • 277 Answers

SOURCE: I have a 2002 Nissan Sentra GXE, 1.8 Engine. When

could be a wheel is out of balance.
maybe you had a wheel weight come off and it's not in balance now.

Posted on Jul 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Heater temp on high only bows luke warm air after driving. A/C works just fine.Plenty of cold air from it


heater blows cold air idle chrysler 300 Questions & Answers ...

www.fixya.com > Forum > Tags
Find solutions to your heater blows cold air idle chrysler 300 question. ... blow warmair for a few mins then back to luke warm. i replaced thermostat ... HEAT BLOWSCOLD AIR WHEN IDLING ONLY GETS HOT WHEN START DRIVING ... About 15 minutes after driving the diver side vents start blowing straight cold air but the ...

Heater only works when pressing the gas? - DoItYourself.com ...

www.doityourself.com/...repairs.../459521-heater-only-works-when-pres...
Nov 3, 2011 - When I press the gas, the air from the vents is nice and hot. .... So am Idriving a car with a ton of problems, or could the power steering ... Just anotherquestion, when warmed up does the engine temperature ... When the heater is on and I'm not pressing the gas pedal, luke warm air blows from the vents.

Heater blows cool air when stopped and warm air while ...

https://www.reddit.com/.../heater_blows_cool_air_when_stopped_...

RedditFeb 12, 2014 - Heater blows cool air when stopped and warm air while driving 2008 Kia Spectra (self. ... just fine but appears to blow cool air when I was stopped at a stoplight. ... My temp gauge would also be pegged high when at idle / low RPM. ...thermostat only blocks coolant going to the radiator, and the heater core, ...Missing: 300m ‎luke

Why is My Car AC Blowing Hot Air? - BlueDevil Products

gobdp.com/blog/car-ac-blowing-hot-air/

Jan 27, 2016 | 2000 Chrysler 300M

1 Answer

A/c and heat dash vents won't work but all others are fine


check the actuator motor on the heater sounds like the motor is not directing the air as it should. The motor is in the center of the truck inside attached to the heater and has arms on it to move the heater and ac doors.

Jul 05, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

Blower motor doesn't pump well even the fan switch on high


sounds like blower bearings are dried out and will eventually lock up the blower..sometimes you can spray wd40 in the blower bearings and it will work fine for a while.. also check vacuum controls to the baffle dors in the ductwork..may have some leaks there.. should hear a slight hissing if really bad..repost findings

Feb 09, 2013 | 2005 BMW 545i

2 Answers

Heater blasts extra hot air when turning steering wheel


Check to see if your heater control valve in the engine bay is resting on the inner tie rods. You could be opening the valve and closing it when you turn the wheel and the inner tie rod moves.

Dec 03, 2012 | Cars & Trucks

2 Answers

I have a 2001 monte carlo v6 and it makes a horrible grinding sound when I turn the wheel... and also makes sorta like a loud winding up sound when I crank the engine and when I'm driving. The engine...


Low on power steering fluid, probably a leaking seal or hose, make sure you have enough, it will now proably be foaming because of the air in there. If fluid level is OK, your power steering pump is going out; or both...

Dec 05, 2011 | 2001 Chevrolet Monte Carlo

2 Answers

2002 ford focus fan knob not working at all 1 2 3 or 4 to turn heat on, although you can feel minimal heat coming from the vents.


Probably a blown fuse? Does the AC light come on when it's turned to MAX setting and the fan is on 1 thru 4 speed?It should.
Check all fuses. don-ohio

Sep 27, 2011 | 2000 Ford Focus

1 Answer

Heater not working


I would check if your vent to the outside is open. If it is I would check the vacum hose that controls the vent to open and close.

Jan 27, 2009 | 2001 Saturn SL

2 Answers

Only getting lukewarm air from heater even with new thermostat


1. maybe your ac condenser blower is not working properly
2. slipping ac belt
3. air con compressor hub is sliding due to oil leak

Dec 10, 2008 | 1994 Subaru Legacy Outdoor

2 Answers

Squealing NOISE possibly from fan belt


If the noise going away every time u turning off the ac it's probably your ac compressor belt.however i will suggest to take some vaseline and rub it all over the exposed parts of your drive belt.

Jun 22, 2008 | 1998 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...