Question about 2002 Suzuki XL-7

1 Answer

How to replace bulb on fog lamps suzuki xl7 2003

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 20,706 Answers

This info is in the operators guide, lost that? in the glove box.
my 07 manual shows no fog , lamp instructions
it says contact dealer and as you know they are DOA. Chapter 11.
any mech can do this..
some fogs are optional added lamps to some years, and makes and in some countries (not stated)
but in general its 3 ways.
Look at the lamp , see it?
does the front have screws on the lens. , remove it.
if not its a rear access lamp
gain access to the rear and remove the socket, and replace the lamp,
if all this is too hard, and still a wana DIY,
you could go to alldata.com and read how. under lighting,.
or post a photo of said fog lamp.. my 04 has no such lamp. BTW.
if the lamp need body panel removal. then in the FSM (or above link) you'd read the section under body. for how todo that.

Posted on Oct 20, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Rear fog light not working.; good earth,& switch lamp is lit up, 2006 Suzuki Grand Vitara. bulb tested ok


Take out the bulb. Run some fine emery cloth inside the socket and the bulb contacts. Reseat & try it again.

Sep 04, 2015 | 2006 Suzuki Grand Vitara

1 Answer

How to replace a front fog lamp


  • If your fog lamp is connected to or behind a grille, pop it out. This can be done by first removing the clips or screws connecting it to the car and gently pulling it out. (If your fog lights are not connected to a grille, proceed to step 2.)Find the bolts that hold the fog lamp in place; you may have to get underneath the automobile to do so.Using your ratchet wrench, remove the bolts.4Grab the connector on the back of the fog lamp, turn it counter-clockwise and pull it out. This should remove the actual light bulb from the lamp fixture.Remove the fog lamp from the car and place the new one in.6Place the light bulb into the new fog light and turn clockwise to lock into place.Bolt the fog lamp back into place, if you had to remove the grille, put it back now and screw/clip it back into place.Turn on the fog lights and make sure everything is working properly


  • Oct 02, 2010 | 2004 Ford Explorer

    1 Answer

    I need to replace a foglamp bulb right side.I have fairly easy access to & can see the rubber housing for the bulb,but cannot figure out how to remove it.Do I need to rermove the entire assembly in...


    Typically the fog lamp is located in the front bumper assembly. It's usually fairly easy to access and replace these.

    Place the car is park, secure parking brake. Use a creeper to scoot under the front end of the car, look up into the bumper. Located the backside of the fog lamp holder. You would usually grab and twist counter clockwise about an inch, then pull straight out. Push in on the bulb while turning counter clockwise until it pulls out of the lamp holder.

    These fog lamps usually have a little bit of cushioning grease in the socket. Do not remove the grease or connectivity problems will result with the new fog lamp. Push the new bulb in, turn clockwise until bulb stops turning, release hand pressure.

    Installation is the reverse of removal.

    May 25, 2010 | 1999 Oldsmobile Eighty Eight

    1 Answer

    How to replace fog light bulb on an '03 Jeep


    There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose.

    Feb 11, 2010 | 2003 Jeep Wrangler

    1 Answer

    How do I replace the fog light assembly on a 2000 Olds Alero?


    you replace the fog lamps by going under front bumper fascia.remove the pushpins and take down the splash shield to access the back of the fog lamps.then you remove two bolts retaining the fog lamp to the back of front bumper.besure to wear clean gloves.because fog lamps is halogen bulbs.if you touch with bare hands the oils from hands will make the bulbs over heat and blow out.

    Dec 03, 2009 | 1999 Oldsmobile Alero

    1 Answer

    How do you replace the fog light bulbs on a 2004 buick regal?


    Notes FOG LAMP BULB REPLACEMENT - FRONT

    REMOVAL PROCEDURE
    f98bf40.gif
    1. Remove the front bumper fascia deflector.
    2. Disconnect the electrical connector from the front fog lamp bulb/socket. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
    01c84b0.gif
    1. Rotate the front fog lamp bulb/socket counterclockwise to release.
    2. Remove the fog lamp bulb/socket from the front fog lamp assembly.
    4065803.gif


    1. Install the fog lamp bulb/socket to the fog lamp rotating clockwise until fully seated. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
    b182709.gif
    1. Connect the electrical connector to the front fog lamp bulb/socket.
    2. Install the front bumper fascia deflector.

    Jun 16, 2009 | Buick Regal Cars & Trucks

    1 Answer

    How to replace a fog lamp with replacement bulb only on 2002 toyota 4runner sport edition???? the three screws on the bottom?


    Well, these are the steps and I will post the pic here in a second...looks like 2 screws...but like I said, you can see the picture for direction on this.


    Remove or disconnect the following:

    Front turn signal lamp
  • Connector
  • 2 screws
  • 2 claw fittings
  • Fog lamp assembly
  • Fog lamp bulb as shown
  • Fog light unit

  • To Install
    1. Install or connect the following:
      • Fog light unit
      • Fog lamp bulb as shown
      • Fog lamp assembly latch the 2 claw fittings and 2 screws
      • Connector
      • Front turn signal lamp
    Trying to post the pics now....

    May 14, 2009 | 2002 Toyota 4Runner

    1 Answer

    Fog Lamp Bulb Replacement


    there are a couple of screws in the front of the fog light that will remove the lense so you can replace the bulb.

    May 11, 2009 | 2004 Chrysler Sebring

    1 Answer

    2002 Pontoiac Gran Prix 2002 GTP


    Yes, you can replace just the bulb. A local auto parts store may be able tell you which bulb you need or you'll have to pull the bulb out and take it in.

    Oct 18, 2008 | 2002 Pontiac Grand Prix

    1 Answer

    HOW TO REPLACE HEADLIGHTS ON 2000 CHRYSLER LHS


    ATTN: NIKKICARROLL

    here is how to replace the bulb in your vehicle


    1. Release the hood latch and open the hood.
    2. Remove the radiator closure panel sight shield as necessary to gain access to the headlamp.
    3. Remove the screws holding the headlamp module halves together.
    4. Separate the module halves.
    5. Disengage the wiring from the headlamp bulb.
    6. Remove the retaining ring from the back of the headlamp bulb.
    7. Pull the bulb from the lamp.
    To install:
    1. Push the bulb into the lamp.
    2. Install the retaining ring to hold the bulb in the lamp.
    3. Engage the wire connector to the back of the headlamp bulb.
    4. Place the module into position on the vehicle.
    5. Install the screws to hold the module to the vehicle.
    6. Install the radiator closure panel sight shield.
    7. Check the headlamp alignment and operation.
    88176gb1.gif Exploded view of the fog lamp with the bulb removed
    Click to Enlarge

    1. Release the hood latch and open the hood.
    2. Remove the radiator closure panel sight shield as needed to gain access to the headlamps.
    3. Remove the screws holding the headlamp module halves together.
    4. Separate the halves.
    5. Remove the fog lamp wire connector cover.
    6. Disconnect the wires from the fog lamp bulb.
    7. Disengage the retainer clip holding the bulb to the fog lamp.
    8. Remove the bulb from the fog lamp.
    To install:
    1. Place the bulb into position in the fog lamp.
    2. Engage the retainer clip to hold the bulb to the fog lamp assembly.
    3. Attach the wire connectors to the fog lamp bulb.
    4. Install the fog lamp wires connector cover.
    5. Place the module halves together.
    6. Install the screws to hold the headlamp module halves together.
    7. Install the radiator closure panel sight shield.
    8. Verify the fog lamp operation and alignment

    ATTN: WDSNEED1

    Removal & Installation 88176g87.gif Remove the screws retaining the headlamp module to the mount adapter
    Click to Enlarge

    1. Release the hood latch and open the hood.
    2. Remove the radiator closure panel sight shield as necessary to gain access to the headlamp fasteners.
    3. Remove the screws holding the headlamp module to the mount adapter.
    4. Separate the headlamp module from the mount adapter.
    5. Disengage the wiring from the headlamp and foglamp.
    6. Remove the headlamp from the vehicle.
    To install:
    1. Attach the wires to the headlamp and foglamp assembly.
    2. Place the headlamp module into position on the mount adapter.
    3. Install the screws to hold the headlamp module to the mount adapter.
    4. Install the radiator closure panel sight shield.
    5. Check the headlamp alignment and operation.

    Jul 28, 2008 | 1994 Chrysler New Yorker

    Not finding what you are looking for?
    2002 Suzuki XL-7 Logo

    182 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Suzuki Experts

    yadayada
    yadayada

    Level 3 Expert

    75797 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22114 Answers

    Boyet Soriano
    Boyet Soriano

    Level 2 Expert

    293 Answers

    Are you a Suzuki Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...