Question about Cars & Trucks

1 Answer

Where is the knock sensor on my 96 tahoe 5.7 - Cars & Trucks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

Should be on pass. side of engine. about half wayup and over.

Posted on Oct 17, 2013

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22095 Answers

SOURCE: how do i know if my knock sensoris bad on my 1999 chev tahoe

no it will not cause a misfire it just will not start

Posted on Jan 08, 2010

  • 752 Answers

SOURCE: where are the knock sensors located on a 02 chevy

It is usually below the the cylinder head on the passenger side towards the back of the engine. It has a white single mushroom shaped connector.

Posted on Jan 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 96 tahoe ive replaced the vehicle speed sensor an the 1-2 an 3-4 solenoids an it still willn't shift out of 1st any ideas?


does it have a vacumn pipe from manifold to the gearbox ?? have a look and if it has then make sure this pipe doesnt leak and loose vacumn

Nov 23, 2011 | 1996 Chevrolet Tahoe

1 Answer

Will a knock senscor cause lack of power on a1995chevy tahoe


Yes. The knock sensor is located in the engine block, the knock sensor retards ignition timing during a spark knock condition to allow the E.C.M. ( electronic control module) to maintain maximum timing advance under most conditions.

Oct 14, 2011 | 1995 Chevrolet Tahoe

1 Answer

Where are the knock sensors located on my 05 Tahoe?


THE KNOCK sensors are located below the intake in the valley of the engine. to replace them you will need to remove intake assembly to gain access. this vehicle has two knock sensors i recommend replacing both of them while in there.

Jan 17, 2011 | 2005 Chevrolet Tahoe

1 Answer

How do you replace the knock sensor on a 2005 chevy tahoe,and what exactly do you have to remove? ?


The knock sensor should be on each side of the engine block. These are single wire connectors and require no special tools or tricks. Simply unscrew and install.

Mar 25, 2010 | 2005 Chevrolet Tahoe

1 Answer

My tahoe wont pass emissions test, because of the knock sensor


true it wont because it is part of the emissions system and when bad sets off check engine light which alone fails a vehicle gm v8 have two knock sensors which sad to say are under the intake manifold

Jan 15, 2010 | 2003 Chevrolet Tahoe

2 Answers

How do i know if my knock sensoris bad on my 1999 chev tahoe


no it will not cause a misfire it just will not start

Jan 08, 2010 | 1999 Chevrolet Tahoe

1 Answer

P0442 dtc for 2004 chevy tahoe gas cap or knock sensor 2??


common problem. replce the gas cap first easy and cheap. if you drive where it is wet alot and or you get pine needles on your truck the knock sensor rust. it is under the intake manifold. not an easy job but can be done in 4 hours. replace both as a set.

Dec 30, 2009 | 2004 Chevrolet Tahoe

1 Answer

96' Tahoe 5.7 low oil pressure


i would not try a synthetic oil.additve wise try out engine honey. this may get a few more miles

Sep 16, 2009 | 1996 Chevrolet Tahoe

2 Answers

WHERE ARE THE KNOCK SENSORS LOCATED AT ON AN 03 CHEVY TAHOE 5.3 2WD ?


Knock sensor can be found on top of the engine block, there are two you ´d have to remove the intake manifold to get to them,

Aug 05, 2009 | 2003 Chevrolet Tahoe

1 Answer

Find part location


There are two knock sensors on your vehicle. Both are located under the intake manifold. I would replace both if going to do the work yourself. There is also a wiring harness kit for the sensors you should replace. It is a difficult job.

Apr 11, 2009 | 2002 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...