Question about 2008 Hummer H3

1 Answer

Climate control fan not working - 2008 Hummer H3

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

You will need to replace the fan blower motor switch resistor as well as the blower motor resistor harness.

The resistor can be located under the glove box (directly above where you passengers right foot wood be pointing if sitting in truck.

This is a common problem much has been written about it. You can find a detealied fix on youtube.,

Posted on Oct 21, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my a/c or heater fan come on?


When the blower works only on the high setting its usually a bad blower resistor which is right near the blower motor. now you say it would always blow high regardless of the fan speed setting that would indicate probably the climate control unit or a connector problem somewhere. finally it not working at all may be the climate control unit or connection went bad even further. it might have a blown fuse or a bad blower motor in addition to the climate control unit or connector problem .check for power and ground at the blower motor. the power is supplied from fuses and may have a relay also. the ground is supplied from the climate control unit and goes through the resistor to control the fan speed. good luck

Oct 30, 2011 | 1997 Lincoln Continental

1 Answer

2005 Crown Vic climat contr fan not working Fuses good Motor good


does it have a digital control panel? As this uses an electronic blower speed controller located at the engine compartment (rear engine block) fix on ac phlenum try to shake the connector or wire while the system is on.

Jan 31, 2010 | 2005 Ford Crown Victoria

1 Answer

Prius climate control fan doesn't blow


check for fuse compartament and look under cluster controls or interior climate controls see if any of them are burn out, check for blower fan and test motor or replace motor.

Jan 08, 2010 | 2006 Toyota Prius

1 Answer

A/c heater climat control switch


Check the relais module located inside under the rh side of the heather box you can see the connector most of them need to be replaced as they burn out you may need to replace the blower motor as well,high amp draw caused by faulty bearings will overload the blower motor controller

Jan 16, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Blower fan does not work on low or medium only on high. Lx model has auto climate control. wondering if it is blower motor, blower resister, or control (bad contacts). All buttons work on climate control....


Sounds like the problem is more with the blower motor assembly itself. The blower motor have micro-proccers built itnto them which comunicate with the control heads and do the actual regulating of the fan motor. Dealers have computers with diagnostic software which allows them to monitor what is happening in the eletronic controls of the vehicle. Electronic diagnostics without the diagnostic software makes it very diffecult to pinpoint the actual item causing the problem.

Jan 01, 2009 | Hyundai Motor 2003 Sonata

1 Answer

Climate fan works only when I touch it


I would go with a fan motor, but would like to see this myself first.

Nov 29, 2008 | 1993 Mercedes-Benz Mercedes Benz 400 Class

1 Answer

Fan for climate control is not working


Well thanks for your offert I'll think it
So already a could to solve my problem by changing a bearing of the fan it one was damage due to corrosion inside it

Thanks for your comments!

Nov 23, 2008 | 1998 Chrysler Town & Country

Not finding what you are looking for?
2008 Hummer H3 Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...