Question about Cars & Trucks

1 Answer

Want start after replacing fuel pump - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 89 Answers

Check all your connections on the pump

Posted on Oct 17, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1995 trans sport van new fuel pump, won't start


If the pump continued to run after shutting off the car you fuel pump relay was probably staying latched. I would replace the relay as well based on your info. Along with the pump the fuel filter should be replaced too and fuel pressure should be checked. Make sure your ground is good also.

Apr 13, 2014 | 1994 Pontiac Trans Sport

2 Answers

2010 f150 wont start will turnover but no start cant hear the fuel pump start either


sounds like either the fuel pump relay or the fuel pump itself has gone out. check fuse panel first then check fuel pump relay. if those are good then check power leads to pump at tank and if you have power there then the pump has probably failed. hope this helps. Chris

Mar 20, 2014 | 2010 Ford F-150 Regular

1 Answer

1989 f250 460 engine fuel problem


if the fuel lines have any rubber fuel lines they could be sucking air. also try replacing the fuel caps, it may not be venting

Dec 02, 2013 | 1989 Ford F 250

2 Answers

Will not start. turns over when i spray starting


First you need to verify that the pump is getting power. Did you check the Inertia Switch? Power goes through that switch to the fuel pump. If the switch is good, and getting power,the fuel pump is most likely bad, the fuel tank must be lowered to replace the fuel pump.

May 24, 2010 | 2000 Ford Expedition

1 Answer

1995 s10 pickup 4wd just replaced fuel pump, won't start.


replace the wireing harnes to the fuel pump gm had problems with them cost around $15 to 26 at autozone

Nov 18, 2009 | 1995 Chevrolet S-10 CA Edition

2 Answers

Intermittent fuel pump engagement when turning key - 2001 Taurus


try cleaning the connector that goes to the fuel pump, sometimes they corrode on inside. If that does not fix, test the wires feeding fuel pump with a multi meter until the condition shows itself again, if voltage drops to zero or very low then wiring problem, if voltage is unchanged with problem and fuel pump is not working and connectors are all clean, try replacement of fuel pump.

Oct 09, 2009 | 2001 Ford Taurus

3 Answers

96s10 starting problems replaced throdle position sensor,fuelpump relay,no start shot of starting fluid fires right up and runs


Check the fuel pressure at the shredder valve. You should have 60psi to 65psi with the fuel pump primed and engine not running. Once the engine has been started, there should be a 5psi drop. Make sure the fuel filter has been replaced and that the fuel pump is making at least 60psi. Anything less or more then 65psi will not activate the fuel injectors, the other thing to is that the spider injection system on the vortec are know to go bad and you may have to replace the system. Good luck and keep me posted, be glad to help you get your S-10 running 100% again. 

Aug 23, 2009 | Chevrolet S 10 Cars & Trucks

2 Answers

02 yukon denali xl wont start, i replaced battery, alternaor and starter are both good truck still wont start


Did you try to replace the starter cable? is the Truck turning over or just clicking.? If it's turning over and not starting. Best guess would be one of two things. Knock sensors Located under intake manifold. they get wet and deteriorate or the fuel pump. I've replaced all three on mine. 233k still running strong...

Aug 15, 2008 | 2002 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...