Question about 2004 Jeep Grand Cherokee
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I have a 2000 Jeep Grand Cherokee the power windows,power seat , door would not lock , and the inside lights would stay one ..i thought it was a fuse problem but no fuses for that ... in the rubber boot between the door and frame ..the was the ground wire was split ... put a **** connector on it everything works great now ....
Posted on Aug 25, 2008
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
Posted on Dec 07, 2008
I agree, these vehicles have a problem with the blend doors and since the accuators hit the door when it opens and closes, it breaks the doors. and it's a huge job to replace them.
Posted on Mar 12, 2009
you need to check wiring between lf door and body..peel back rubber boot and pull on wires..you will find 1 or more broken wires..can be repaired
Posted on May 17, 2009
Tips for a great answer:
Jul 13, 2014 | 2004 Jeep Grand Cherokee
Dec 22, 2013 | 2004 Jeep Grand Cherokee
Feb 21, 2013 | 2004 Jeep Grand Cherokee
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
Feb 11, 2013 | 1996 Jeep Grand Cherokee
Dec 31, 2010 | 2004 Jeep Grand Cherokee
Apr 16, 2010 | 2004 Jeep Grand Cherokee
Mar 21, 2009 | 2004 Jeep Grand Cherokee
Jan 16, 2009 | 2004 Jeep Grand Cherokee
Dec 14, 2008 | 2004 Jeep Grand Cherokee
Nov 25, 2008 | 2004 Jeep Grand Cherokee
126 people viewed this question
Usually answered in minutes!