Question about 2008 Nissan Sentra
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
did you receive the Nissan Service and Maintenance Guide, when you purchased your vehicle? if not go to www.nissanusa.com/pdf/techpubs/2006/2006_N_SMG.pdf
to get the 2006 manual it should be the same, or go to www.nissanusa.com use the "for owners" tab top right and you can download your specfic mileage service
Posted on Mar 30, 2009
SOURCE: brake light, 2008 Nissan Sentra
Open the trunk and locate the trim door that covers the back of the drivers side tail light assembly. Open the door and locate the bulb holder. The bulb holder can be removed from the tail light assembly housing by turning counter clockwise 1/4 turn. Holding the bulb holder in one hand, press gently on the bulb and turn then bulb counter clockwise to remove. Replace with a combo bulb and reverse proceedure to re-install.
Posted on Jun 21, 2009
the diagram should be on the outside or inside of the fuse panel cover. Not there? You can go to autozone or advance auto and look at there books for free, or you can ask them to print it for you. If you're not happy with that you can stop at a nissan dealer (used) and look at one of their 2005 models, or ask them to help. They will try to get you to trade in though lol.
Posted on Jul 03, 2009
Just unscrew the screws holding down the black tabs on top of the
headlights and you have to gently pull the headlight out , be careful
because the bottom of the headlight has a tab holding it in place (be
patient might have to move it around to release the bottom tab). And do
the opposite when putting the new headlights on. Even if the bottom tab breaks. the tabs on the top will old the headlight in place. Once it's changed, you'll need to re-aim the headlights...
The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Oct 20, 2009
Tips for a great answer:
Mar 29, 2016 | 2005 Nissan Sentra
Jun 12, 2010 | 2005 Nissan Sentra
Jul 03, 2009 | 2005 Nissan Sentra
May 12, 2009 | 2002 Nissan Sentra
Jul 28, 2008 | 2005 Nissan Sentra
229 people viewed this question
Usually answered in minutes!