Question about 2004 Audi A4

1 Answer

Left front window does not close if only goes halfway up and then down

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Could be something restricting the window's travel, it's a safety feature to stop people from getting their fingers trapped in it. Check that the grooves that the glass runs in are clear of foreign objects.

Posted on Oct 17, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Window on drivers side only goes down halfway. it will go back up but only goes down halfway.


while running the window down, push on top to see if it continues down. I so it may only need lubrication, if not, the motor track may be bad.

Apr 19, 2017 | Cars & Trucks

1 Answer

How to reset windows on is 350 lexus 2007


(a) Turn the engine switch on (IG).

(b) Halfway open the power window by pressing the power window switch.

(c) Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 1 second after the power window is fully closed.

(d) Check that the AUTO UP/DOWN function operates normally.

If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time. If not normal, follow the steps below.

(1) Disconnect the negative battery terminal for 10 seconds.

(2) Connect the battery terminal.

(3) Turn the engine switch on (IG).

(4) Halfway open the power window by pressing the power window switch.

(5) If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time.

If not normal, follow the steps below.

(6) Turn the engine switch on (IG).

(7) Halfway open the power window by pressing the power window switch.

(8) Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 12 seconds after the power window is fully closed.

(9) Check that the AUTO UP/DOWN function operates normally.

Feb 05, 2017 | 2007 Lexus IS 350

1 Answer

95 Buick ParkAve Power Window Stops HalfWay


you have bad place in scew track replace it. Check to see if something has fell down in track line. roll window down use flashlite to check track.

Sep 10, 2017 | Buick Park Avenue Cars & Trucks

1 Answer

On my 2001 kia sportage the back two windows won't go down and the right front window is stuck halfway up


make sure power windows lock out switch on driver side not on position, that will cause power windows not work or you have faulty power window relay.

Sep 11, 2012 | 2001 Ford Explorer Sport Trac

1 Answer

The power window autowinds up and then halfway down


seems to be an electrical problem or there's something wrong with your power window console.

Feb 11, 2010 | 1992 Toyota Corolla

1 Answer

Left front door window goes up crooket,plastic


unfortinatly the plastic piece you found is part of the regulator. more than likley the whole thing needs replacement. usually around 120 at the parts store

Feb 06, 2010 | 1997 Chevrolet Venture

1 Answer

Left front door window sometimes will not go back up! When I use either the left front door, window up/down switch, or the driver side up/down control, for the left front door, I can hear the switch...


USUALLY POWER WINDOW PROBLEMS ARE ONE OF THREE THINGS. 1. SWITCH 2. MOTOR 3. WINDOW REGULATOR. THE MOST COMMON PROBLEM THE LEXUS HAS IS THE MASTER SWITCH IN THE DRIVERS DOOR. IT CAN ALSO AFFECT THE OPERATION OF THE PASSENGER DOOR SWITCH....IF WINDOW REGULATOR IS BAD YOU WILL HEAR SOME CRAZY NOISES COMING OUT OF DOOR PANEL...VERY OBVIOUS.... FOLLOW THIS CLOSELY...STARE AT A LITE DOME LIGHT USUALLY WITH DOOR OPEN...WHEN YOU PRESS WINDOW SWITCH, IF THERE IS ANY DIMING OF DOME LIGHT....MOTOR IS BAD. IF DOME LIGHT STAYS THE SAME BRIGHTNESS... SWITCH IS BAD... EXCEPT IN THE CASE SOME HACKER HAS BEEN IN THE DOOR PANEL BEFORE ...IT DOES TAKE A SPECIAL TALENT TO REMOVE DOOR PANELS WITHOUT BREAKING THINGS AND EVEN MORE TALENT TO REPLACE WINDOW REGULATORS

Aug 21, 2009 | 2003 Lexus RX 300

1 Answer

My 1990 ford bronco rear window will not go up all the way. it goes down fine but when it starts to roll up it stops halfway up.


Your window fuse, relay or motor may be dying and no longer powerful enough to close your window all the way up. So as not to be repetitive, for the failure of your power driver side window and rear window, review this handy diagnostic article, which identifies the possible causes, from a bad fuse, relay to window motor, etc.:
http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Vehicle_Car_Zone_Cars_Trucks_Vans_Windshield_Windows_Window_Does_Not_Roll_Up_Down.htm

This should help narrow down your particular cause.
Brad

Jun 07, 2009 | 1990 Ford Bronco

1 Answer

How to take out the light assy on a 2004 Toytota sienna van.RH side. Do you have to take off the front cap (bumper)


Yes....herer is the steps to replacing it:

Headlight Assembly Removal & Installation Standard Headlights To Remove:
  1. Disconnect the battery ground cable.
  2. Remove the left and right front inner fenders. Fog light & headlight assembly (exploded view) toyota-06-00-5662.gif

  3. Remove the 8 screws and separate the front splash shield from the front bumper fascia.
  4. Remove the 5 push-pins from the top of the fascia grille.
  5. Release the retainers on the left and right sides of the front bumper fascia and pull the fascia toward the front of the vehicle.
  6. Disconnect the headlight assembly connectors.
  7. Remove the mounting bolt, 3 screws and headlight assembly.
  8. Turn all bulb sockets counterclockwise to remove.
To Install:
  1. Turn all bulb sockets clockwise to install.
  2. Align the retainers with the slots and install the front fascia.
  3. Install the 5 push-pins on top of the fascia grille.
  4. Install the front splash shield on the front bumper fascia with the 8 screws.
  5. Install the left and right front inner fenders.
  6. Connect the battery ground cable.
  7. Vehicles with power windows perform the following steps:
    • Turn the ignition switch on.
    • Open the power window halfway.
    • Close the window and continue to hold the switch up for at least 1 second after the window is closed.
    • Ensure that the auto up/down circuit is operating properly.
    • If the auto up/down circuit does not operate, disconnect the battery ground cable for 10 seconds.
    • Connect the battery ground cable.
    • Turn the ignition switch on.
    • Open the power window halfway.
    • Ensure that the auto up/down circuit is operating properly.
    • If the auto up/down circuit does not operate, turn the ignition switch on.
    • Open the power window halfway.
    • Close the window and continue to hold the switch up for at least 12 second after the window is closed.
  8. Vehicles with sliding roof system perform the following steps:
    • Turn the ignition switch on.
    • Press and hold the TILT UP switch until the glass tilts to the full up position. The glass will automatically tilt slightly down after it reaches the up position.
    • Release the switch.
    • If the sliding roof does not operate properly, replace the sliding roof ECU.

May 07, 2009 | 2004 Toyota Sienna

1 Answer

Sunroof on 1990 maxima will not close


My '91 does the same thing. There is a thin metal wind deflector (about one inch wide with holes in it across the front edge of the sunroof opening. It should flip down to allow the glass to close all the way but sometimes it doesn't flip down all the way. Use something flat and thin like a credit card to hold it down while you close the roof. Works for me.

May 06, 2009 | 1990 Nissan Maxima

Not finding what you are looking for?
2004 Audi A4 Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...