Question about Cars & Trucks

Open Question

Electrical wiring of the inside of the samsung AQ24FCN

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2000 chevy venture power mirror fuse keeps blowing when trying to ajust mirrors replaced swicth still blows fuse


The most common issue is a wire is grounding out. I can not tell yo how many times i have found a broken wire in the boot between the door and the body, the wires are found in the 1.5" rubber that you can see when opening the door. You will have to pull it out of the door and the body to expose the wires, it is a real pain to fix once you find the bad wire or wires after it is repaired double shrink seal it for a bit more rigidity. only twice have i found the issue was the switch itself, be prepared for a very time consuming task, after the repair be sure to push both of the ends of the rubber sleeve all the way back in. Be sure you check for rough or sharp edges before putting the boot back in place. Good luck, hope this helps.

Apr 25, 2017 | Cars & Trucks

1 Answer

Power ports inside vehicle stopped working; I changed all the power port fuses inside vehicle; still not working.. what do I do?


Check for B+ voltage at the power outlets with volt meter . Go to http://bbbind.com/free_tsb.html free wiring diagrams ! Go on youtube watch videos on basic electrical trouble shooting , how to use a DVOM digital volt ohm meter , how to read a wiring diagram ,voltage drop testing ! Then test the circuit for power an grounds . http://www.autoshop101.com/ go here to lean about different type electrical circuits. Series , parallel an series parallel !

May 10, 2016 | 2004 Kia Sorento EX

1 Answer

How do I remove main electrical wiring from front drivers door through chassis. I want to just remove the door


ther door harness is normally connected to the inside harness just inside the cabin
remove the kick panel and then unplug the connection
push/pull the rubber grommet around the harness out of the hole in the frame and pull the wires clear of the opening

Apr 28, 2016 | 2001 Cadillac Seville STS

1 Answer

96ply grand voyager enine turns over but wont start,had battery charged,now lights flashing in dash,ac,rear wiper,4lights total,cam sensor wires old breaking off at connecter,


You 1st need to determine if you have a fuel problem or an electrical problem. 1st pull one of your spark plug wires and find an old plug to stick inside the wire. If you don't have one, remove the plug from the engine and use it. 2nd, with the plug inside the wire, place it someplace on the metal portion of the engine so that it is grounded. Then as you spin the engine over, have someone watch the end of the plug to see if there is a spark or not. If there is, then more than likely you have a fuel problem. If no spark, you have an electrical problem. Check that and them repost your message.

Nov 05, 2014 | 1996 Plymouth Grand Voyager

1 Answer

How to change a window switch on 2008 mercedes benz vito


You have to pull the inside door panel to get to it then there are 2 electrical connectors, connecting the wires to the switch(be careful to use needle nose pliers and grab the connector and not the wire) remove wires from switch, replace switch, replace wires on new switch(as long as there is only 1 wire on each side of switch don't worry about polarity), and replace inside door panel. To test new swich turn ignition on and actuate switch on inside door panel.

Aug 30, 2014 | 2006 Mercedes-Benz Vito 112

1 Answer

1996 izusu rodeo new battery new alternator new terminals Still wont charge battery light and break light are on Getting an electrical current to the back of the alternator but not to the side mounted...


Hi, you need to inspect the plug wires carefully.it look ok from outside but damaged or break inside.also check for earth wire connections.
good luck.

Jan 11, 2014 | Cars & Trucks

1 Answer

Loss of turn signals, power windows, fan control


check the mini fuses inside to make sure none are blown also check outside under the hood in the fuse there if thats no help worse comes worse you have an electrical problem in the wiring harness a burnt wire or link fuse electrical can be tough sometimes.good luck

Aug 27, 2011 | 1994 Jeep Grand Cherokee

1 Answer

I have 1993 geo prizm that the turn lights won't work, but the hazards and stop light do.


Inside the turning light bulb there is total of TWO electrical lighting wires (filaments).
One of the two wire inside the bulb is broken.
You need to replace the bulb.

Jan 31, 2011 | Geo Prizm Cars & Trucks

1 Answer

Need a wiring electrical diagram for 98 cadilac


The Auto Parts stores here carry Chilton's or Haynes repair manuals that usually have wiring diagrams in the back.

Jan 28, 2010 | 1998 Cadillac DeVille

2 Answers

Tripping fuses


find what fuse is, You have to follow the wires with patience, from the fuse box to the item, you have a short circuit look if the horn + wire is not touching metal outside or inside the steering column, have You replaced the steering wheel? if the same fuse covers the dome light, take it a part and see if the + wire is touching the inside of the roof, plastic melted, or look at the on and off Dome switches at both doors, look for the positive wire on radio, antenna and main light switch, yo can disconnect every item and check any time hot wiring that fuse with copper wire every time, to You are sure

Jan 21, 2009 | 1987 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...