Question about Cars & Trucks

Open Question

Ssangyong rexton fault codes b1667 - Cars & Trucks

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 341 Answers

SOURCE: Orange Warning light on dash board check

It means you have a computerized system management problem. An electronic sensor component has either failed, or a condition has occurred that has put a sensor out of normal range and the onboard computer is letting you know of it. Any time that light comes on it sets a code that can be read with a special code reader.Most auto parts stores will retrieve the code/ codes for you at no cost. Be very cautious interpreting the codes meaning, because various engine conditions will set a code as well, because the condition will affect what the sensor measures. If you spend the money for the replacement sensor(never cheap) it won't shut the light off.Once installed auto parts stores will not take it back.Also 90 percent of the time it is defective wiring running to the sensor or bad grounding that causes the codes/codes.So unless you have a ton of high priced testing equipment and a lot of electronic engine control troubleshooting experience,you best take in in for service. One more thing. The most common reason the light comes on is a loose or defective gas cap.The computer monitors that too.

Posted on Nov 30, 2008

Ad
  • 1 Answer

SOURCE: i have a ssangyong rexton and it wont start it

There's a number of possible reasons.
You don't mention if the engine turns over in the attempt, and you don't say which light is on.
A SsangYong service person can plug in a diagnostic tool to see what error codes are present.

Posted on Jan 26, 2010

  • 1 Answer

SOURCE: cant engage 4 wheel drive on ssangyong rexton 2.7 diesel

ho un problema sul rexton si accesa spia cheak ,cosa devo fare ???????????

Posted on Jan 02, 2013

ercupa190
  • 12223 Answers

SOURCE: intermittent esp light coming on when driving

rUN the scanner and computer for easy diagnostic, some sensor(s) can be faulty. or PCM or ECC or IC .
God bless you

Posted on Oct 02, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2007 ssangyong rexton, it cuts out when hot? theres a few fault codes come up, p1677, po675, po335 po372, any help would be much appreciated...


1677 may be Drive by Wire - MIL Circ. Short to B + Ssanyon is not listed as they use OEM parts.
0675 Cylinder 5 Glow Plug Circuit/Open
0335 Crankshaft position (CKP) sensor - circuit malfunction
0372 Timing reference, high resolution signal A - too few pulses

Jun 26, 2017 | SsangYong Cars & Trucks

1 Answer

Why doesn't the cruise control work?


run the fault codes
cruise control needs the following to work together as one or more will stop it from working.
VSS sensor, (road speed /speedo)
engine rpms/tacho
brake switch sensor/
clutch switch sensor
cruise control switch

Jun 06, 2015 | 2005 SsangYong Rexton RX

2 Answers

My 2005 Rexton 270 xdi will not start till slightly mobbed with aerosol.


I'm wondering why the guy who is holding the code reader can't tell you what it means ?
He is obviously not a Ssangyong specialist - or is it not a Ssangyong Scan100 gauge ??
I'm prepared to get you answers if I know it was done at a Ssangyong dealership on a genuine Scan100 gauge :)

This will take 24 hrs once I read your reply

Nov 07, 2014 | 2005 SsangYong Rexton RX

1 Answer

Engine belt diagram ssangyong rexton


look under the hood for diagram....

May 27, 2014 | 2005 SsangYong Rexton

1 Answer

Ssangyong rexton engine check light


Check engine light comes on when computer detects an engine fault code. Light is to let you know that a fault code is stored in the ECM. You will need a diagnostic scan-tool to retreive stored codes. Hope that helps a bit.

Mar 07, 2014 | Cars & Trucks

2 Answers

Where is the oils filter located on a Diesel Sangyong Texton 2005 Merc DXi270


The oil filter for the diesel Rexton is behind the engine block on the passengers side. If you remove the plastic engine cover and stand next to the passengers mirror, you will see the casing next to the firewall.

Aug 17, 2012 | 2006 SsangYong Rexton 270

1 Answer

I have a 3.2 lt ssangyon and it cut off. after 10minutes of drive


Have you chceked the engine computer fro fault codes, this is done with a scanner.

Feb 13, 2012 | 2005 SsangYong Rexton EL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...