Question about Ford Five Hundred

Open Question

Cars wath code p2106 p0122 ford 500 in coputer in 2006

Hello

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: wath is the code p2106 in the coputer in a 2006

Replace all the Ignition Coils & the code will be gone

Forget the P2106--- no problem related to that code

Ignition coils are bad & spike the PCM (computer)
drivers ---eg:-- don't ground out correctly & you loose the
TPS Sensor signal,go into failsafe & get the P2106

Posted on Sep 20, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have code p0352,p0102 p0113, p2106 on myford 500,#2coil primary/secondary unit malf.circuit low input intake air temperature sensor circuit hi input throttle actuator control sytm forced lmtd pw


P2106 Ford Throttle Actuator Control System Forced Limited Power

Did you replace the coil #2 ? still have the code ? Have seen this be the coil driver inside the PCM . A transistor supply's a ground for the coil , Coil breaks down inside an sends 40 K volts to the pcm . Video's on youtube ,checking PCM dirvers , #2coil primary/secondary unit malf.circuit low input . How to test computer transistor driver without scan tool


How to test Ford MAF sensor
IAT Intake Air Temperature Sensor Diagnosis P1111 P1112 P0113


Mar 20, 2017 | Cars & Trucks

1 Answer

What is code p2106 p2135 on a 2006 crown vic


Code is P2106, throttle Actuator Control System - Forced Limited

Mar 13, 2015 | 2006 Ford Crown Victoria

1 Answer

What is p2106 code on a 2006 crown vic


Throttle actuator control system is in FMEM mode of forced limited power.
http://engine-codes.com/p2106_ford.html

Mar 13, 2015 | 2006 Ford Crown Victoria

1 Answer

Wath is the code p2106 in the coputer in a 2006 ford 500


Replace all the Ignition Coils & the code will be gone

Forget the P2106--- no problem related to that code

Ignition coils are bad & spike the PCM (computer)
drivers ---eg:-- don't ground out correctly & you loose the
TPS Sensor signal,go into failsafe & get the P2106

Sep 20, 2013 | Cars & Trucks

1 Answer

Codes- P0171, P0174, P2106, P0351, P0355 and P061C the car is a 2006 ford five hundred. The car runs good at times. any suggestions?


P0171 System too Lean (Bank 1)
P0174 System too Lean (Bank 2)
P2106 Throttle Actuator Control System - Forced Limited Power
P0355 Ignition Coil "F" Primary/Secondary Circuit
May be your car run normally now, but you must check and repair the fault in advance.
____________
MaxiDiag Elite MD802

Mar 21, 2013 | 2006 Ford Five Hundred

1 Answer

2006 v-6 sonata trouble codes


P2106 is throttle actuator control system-forced limited power
P2135 is throttle / padel position sensor A/B voltage correction

as for the last code well i have never seen it

Jan 22, 2013 | 2006 Hyundai Sonata

1 Answer

I have a 2006 Ford 500 that went into limp mode. Pulled up codes P061B and P2106. Erased codes with scanner but car won't tach above 3g. Inspected throttle body and it is dirty. Anything else I should...


olook in you fuse pannel. there should be a fuse for your tranny and engine pull one out wait ten seconds then try it to see if it will kick out of limp mode. i had the same problem with a buddys chev.

Dec 14, 2012 | Cars & Trucks

1 Answer

Codes p2106


I think you'll find it's a problem with your throttle you might need to talk to you local ford dealer but don't get talked into getting bit's replaced! I've been tld that you can put a recommended cleaner into your fuel tank and this can sometimes cure the problem - worth a go................

Jun 26, 2010 | 2006 Ford Five Hundred

1 Answer

2005 Ford 500 engine speed problem


all codes point towards a throttle body malfunction. try cleaning the throttle body first. check for loose wires. if problem persists. replace throttle body.

Jun 26, 2009 | 2005 Ford Five Hundred

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...