Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That light sounds like a differential lock or 4-wheel drive. This is usually found in 4-wheel drive and all-wheel drive vehicles. Being the light is "GREEN" and not amber or red tells me that it's not an abnormal problem.
Look around your dashboard or gearshifter for a button labeled 4x4 HI, 4x4 LO, 4x2 HI. sport/off road button, or a second, smaller shifter. Switch them around a little, and if it is a 4x4 selector, be sure when you drive on paved roads to have it set to 4x2 HI. 4x4 HI should only be used if you get stuck to help you get out (snow/mud) and 4x4 LO is only for off road driving (trail blazing/rock climbing/4-wheeling/mud bogging,etc.)
Also, check for any switches labled "DIFF LOCK" or 'AXLE LOCK". In most cars a green light is normal operations.
I hope I could help you find a solution to your problem.
Posted on Jan 05, 2009
This is just a consequential event. the ABS sensor module was probably going out and decide the trigger the alarm at the same time you initiated the hard brake during travel. replacing or resetting this sensor module Will fix this issue. the light will go off as well.
Please rate and god bless.
Posted on Mar 17, 2009
Check the rear wheel cylinders if you have drum brakes on the rear. Check the master cylinder cap to be sure it's on right & snug. Use D.O.T. 3 fluid,not synthetic. If you're losing fluid there's a reason. Check the front brake pads & slides for the calipers,could be frozen with rust & eating up the pads. Fluid would seem low if the pads are shot.
Posted on Jun 28, 2009
No it is not that big of a deal. It is normally 2-3 nuts and your brake lines. The things to make sure of is that brake fluid does not get on any of the electronics below the cylinder by using a towel. Also make sure to bleed the cylinder before hooking the brake lines in all the way. Basically you can do this by screwing in the brake lines about half way and hitting the brake pedal about half way down. Make sure the reservoir does not get empty. Bleed it until there is nothing but fluid coming out of both lines. Obviously this is best done with two people. Have them hold the pedal down while you tighten the lines fully and you should be good.
Posted on Nov 06, 2009
Testimonial: "Straight up to the point and very nice. Thanks."
Tips for a great answer:
Jul 14, 2017 | Kia Cars & Trucks
Mar 02, 2015 | 2010 Kia Sportage 2.0
Jan 03, 2013 | 1996 Kia Sportage
Oct 25, 2012 | 1998 Kia Sportage
Jan 21, 2011 | 2002 Kia Sportage
If brake and abs light come on check the brake fluid level first
Dec 01, 2010 | 2002 Kia Sportage
Jun 11, 2010 | 2002 Kia Sportage
Mar 03, 2010 | 2002 Kia Sportage
Mar 17, 2009 | 2000 Kia Sportage
57 people viewed this question
Usually answered in minutes!