Question about Chevrolet Colorado

Open Question

How to replace fuel injectors 2005 chevy colorado z71

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 51 Answers

SOURCE: 2005 chevy colorado runs rough and gets bad gas mileage.

Sounds like it needs spark plugs and wires, and a fuel system treatment.

Posted on Oct 08, 2008

Ad
  • 1596 Answers

SOURCE: Were is the fuel Filter

LOCATION OF FILTER IS DRIVER SIDE FRAME RAIL ABOUT AT DRIVER DOOR HARD TO SEE BUT FALLOW FUEL LINE ITS THERE. hOPE THIS HELPS PLEASE RATE ME !! THANK YOU AND GOOD LUCK

TOOLS Are Simple and inexpensive local Parts Store like AutoZone will Have it

FUEL FILTER REPLACEMENT

TOOLS REQUIRED
J-46363 Fuel Line Release Tool

REMOVAL PROCEDURE

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
  2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
  3. Remove the fuel composition sensor bracket nuts.Reposition the fuel composition sensor/bracket off to the side
    1. Using a flare nut wrench and backup wrench disconnect the fuel line fitting from the fuel filter.
    2. Pull the quick connect fitting back until the internal retainers hit the filter stop.
    3. Twist one end of J-46363 and insert it between the fitting and the filter.
    4. Twist the opposite end of J-46363 and insert it between the fitting and filter.
    5. Once J-46363 is inserted, ensure that J-46363 is parallel to the filter and fitting.
      1. While holding the filter, push the fitting towards the filter in order to disconnect the quick connect fitting.
      2. Remove the fitting from the filter.
      3. Remove J-46363 from the filter.
        1. Remove the fuel filter from the bracket.
        INSTALLATION PROCEDURE
      4. Install the NEW fuel filter to the bracket.While holding the filter, push the fitting towards the filter in order to connect the quick connect fitting
      5. Using a flare nut wrench and backup wrench connect the fuel line fitting to the fuel filter.
        1. Position the fuel composition sensor/bracket into place. NOTE: Refer to Fastener Notice in Service Precautions.
        2. Install the fuel composition sensor bracket nuts. Tighten the nuts to 17 N.m (13 lb ft) .
        3. Lower the vehicle.

Posted on Apr 07, 2009

polarcycle
  • 1392 Answers

SOURCE: 2005 chevy colorado abs fault

Sounds like water getting in one of the connectors. You will need to see what fault code is in there when the light comes on, then look at that sensor.

Posted on Jun 05, 2009

  • 73 Answers

SOURCE: how to replace spark plugs on 2005 chevy silverado

spark plug wrench and alot of patients with the very back ones hard to get to

Posted on Oct 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace a thermostat in a 2005 z71 4x4 chevy colorado


Disconnect upper radiator hose from engine and the thermostat should be there. I have worked on vehicle that had thermostat underneath so if it is not located in upper radiator hose it will be in the bottom hose

Jun 12, 2017 | Cars & Trucks

1 Answer

How do you replace fuel injectors in 2005 Chevy


remove the bolts that hold the fuel rail. Lift the fuel rail, pulling the injectors out carefully. Make sure the rubber seal comes out with the injector. Remove the electrical clip for the injectors you want to change. Clip in the new injector, and replace the fuel rail and the injectors.

Oct 06, 2014 | 2005 Chevrolet Colorado

1 Answer

Need installation instructions for gm fuel injector part for 2005 chevy colorado


take old one off put new one in ? its that simple .....like putting an eraser on a mechanical pencil

Jan 05, 2014 | 2005 Chevrolet Colorado

1 Answer

SEES LIKE ITS NOT GETTING FUEL HESITATES AND ALMOST STALLS


check fuel filter..pump and fuel lines...i have an 05 z71 colorado..i had same issue..had to replace fuel pump

Apr 22, 2010 | 2005 Chevrolet Colorado

1 Answer

Pulling engine out and replacing it


Why don't you just pull the one head and have it surfaced and check the valves, fix the problem, put on a new gasket and see what happens. It is a lot easier than pulling the motor.

Mar 01, 2010 | 2005 Chevrolet Colorado

1 Answer

I need a schematic of the ignition switch replacement on a 2005 chevy colorado


I have an 05 Chevy Colorado and it won't start , I replaced the fuel filter the air filter and even replaced the fuel pump , then I put on a diagnostics check and it said there is no error code , the truck turns over but still will start it seems to be a fuel problem to me.
signed frustrated

Nov 07, 2009 | 2005 Chevrolet Colorado

2 Answers

2005 chevy colorado runs rough and gets bad gas mileage.


Sounds like it needs spark plugs and wires, and a fuel system treatment.

Aug 13, 2008 | 2005 Chevrolet Colorado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...