Question about Cars & Trucks

Open Question

P0833 ion 2007 clutch pedal swich B what is the location of this swich

Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 49 Answers

SOURCE: where is the transmission drain plug located in a 2007 saturn ion

There is some sealed units with no drain or fill. Or it could be on the driver side bottem of the transmission but is not accessable because it is too close to the frame. Hope you find it and its accessable.

Posted on Apr 20, 2010

  • 3267 Answers

SOURCE: I have a 2007 Saturn Ion-2. The engine light came

for P0102 replace MAF 'cos what cause the maf to fail is, over the year the oil contaminate the mass air sensor. THere is psb for the v-6, clean the oil separator hose, and replace maf. and make sure you don't add more than 4.3L of oil. anymore it will contaminate the oil separator hose cause the same problem again. This was the easy part. The rest could simply disappear after changing the maf 'cos the other two are directly linked to the failure of maf.

Posted on Dec 02, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2007 Saturn Ion 2 that the cruise control has been intermittent but rarely works any more. Checked all 3 plunger switches and all are ok. If you kick the floor under the clutch pedal it sometimes will...

Cruise control also uses clutch switch. If you have already checked that switch, you'll need to look for any wiring harness issue in the area where you kick it.

Aug 16, 2017 | Saturn Cars & Trucks

1 Answer

Clutch pedal has no pressure and goes to floor

The pressure plate is worn out...usually a transmission shop service...sorry

Sep 09, 2015 | 2007 Saturn ION-2 Quad Coupe

2 Answers

Where's the fusebox located

INSIDE BY THE GAS PEDAL to the right behind the trim panel

Jun 03, 2015 | 2003 Saturn ION

2 Answers

Clutch pedal retainer for a 2004 saturn ion

Your clutch pedal attaches directly to the master cyclinder. There is a ball on the end that comes through the firewall. It's made of plastic check that.

Feb 19, 2015 | 2004 Saturn ION

1 Answer

How to bleed clutch slave in vehicle 2004 saturn ion

Make sure reservoir is full, locate bleeder. Have someone press clutch Pedal. While clutch pedal is depressed, loosen bleeder screw and allow air to escape. Tighten bleeder(careful, they're easy to break) then repeat...Often! It helps if you have a clear tube that fits on the bleeder, run it to a small container. When you think you have removed all air from line, lower car from stands and give it a whirl. If it still seems spongy, or doesn't want to go into gear, bleed it a few more times and see how it does. Check fluid in reservoir often...they are small and don't hold a lot. They usually require regular dot3 fluid, but check lid and owners manual if not specified... it DOES matter.

Jun 02, 2014 | 2004 Saturn ION

2 Answers

What fuse box and location is the power windows fuse at on a 2006 saturn ion

The fuse box in the 06 ion is under the floor covering on the drivers side seat. Just move the seat all the way to the rear and then starting in the front near the pedals pull up the floor covering which is attached by velcro.
Regards, Joe

Nov 20, 2009 | 2006 Saturn ION

2 Answers

My 2004 stick shift Saturn Ion has a problem getting into gear. I step on the clutch and the car turns on fine, but when I step on the clutch and try to shift it inot first gear it doesn't let me. Some...

you have a clutch hydraulic problem. have the clutch master cylinder replaced and the linkage adjusted if neccessary. you will be money ahead to have them replace the slave cylinder at the same time.

Sep 23, 2009 | 2004 Saturn ION

1 Answer

Engine light is on and the code is p0833

Clutch pedal switch B circuit is what the code is.

Apr 05, 2009 | 2005 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15314 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides