Question about 2001 Chevrolet Silverado

Open Question

Where is the knock sensor on a 93 Taurus sho 3.2l

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Where is the crank sensor on a 1994 ford taurus gl


What engine? 3.0 DOHC 3.0 OHV 3.8 liter

Apr 10, 2013 | 1994 Ford Taurus

1 Answer

My 1996 Taurus sho cranks but won'tstart up change


Try replacing the camshaft position sensor usually solves the problem.

Jul 03, 2012 | Cars & Trucks

2 Answers

93 FORD TAURUS SHO 3.2 ENG WHERE IS THE OIL PRESSURE SENSOR?


If you're in front of the car facing the engine, it's on the front upper right side of the engine just to the
right of the temp. sensor. Hope this helps.

Nov 20, 2010 | Ford Taurus Cars & Trucks

1 Answer

I have a 93 taurus sho. it was running fine and now it won't start. any advice would help, also need to find where i can get a owners manual so i know what fuses go where on the fuse box.


try hitting the gas tank with a piece of wood,the fuel pump may have started going bad and by hitting it loosens up the pump so it might work a little enough to start it.Then you will know if thats the problem for sure.I had this problem on a friends 1991 SHO

Feb 22, 2010 | 1993 Ford Taurus

2 Answers

1995 Ford Taurus SHO Where is knock sensor located? Thanks


Under hood, passenger side, lower engine area, above engine mount, mounted in engine block .This what it looks like hope this helps d52f852.jpg

Nov 20, 2009 | 1995 Ford Taurus

2 Answers

Taurus SHO wont pass emissions: 95 Taurus SHO 3.2L Failed emissions badly- hydrocarbons in grams/mile=1.68 where .80 is pass carbon monoxide in grams/mile=44.80 where 12.00 pass. oxides of nitrogen in...


If the fuel regulator is seeping gas, replace it first. There is a good chance the diaphragm has a hole in it and is feeding fuel through the vacuum line directly to the intake, causing extremely rich fuel mixture. (Hence the strong exhaust and burning eyes) As a matter of fact, if you pull the vac line off and turn on the key, I bet fuel sprays out. Be careful not to start a fire on a hot engine. Once you get this repaired, erase the codes and retest. You could find yourself with only one code, maybe even none. I wish you luck. Emissions can make you pull your hair out.

Sep 16, 2009 | 1995 Ford Taurus

1 Answer

I have a 1995 Ford Taurus SHO 3.0 liters. I


Hi did you do a continuity check check if there's a wire shorted or open you'll need a volt meter check if the wires on the crank sensor going to the control module and also the one from the coil to the module there has to be a shorted or open wire check this and get back to me good luck

Sep 04, 2009 | 1995 Ford Taurus

1 Answer

Diagram of where the speed sensor of a 1993 ford taurus


i Have 96 Taurus, may help you. May be a little different on 93. good luck. please rate if this is what you need.
-----------------------------------------------------------------------------
3.0L (2V) and 3.0L (4V) Engine
The vehicle speed sensor (VSS) (9E731) is:
  • a Hall-effect pickup that sends a signal to the powertrain control module (PCM) (12A650).
  • able to provide the VSS signal which tells the powertrain control module vehicle speed.
bef24ce.gif
Vehicle Speed Sensor (VSS) (Except SHO) Removal and Installation
  1. Disconnect battery ground cable (14301) and positive battery cable.
  1. Raise and suitably support vehicle on hoist. Refer to Section 00-02 .
  1. Remove three bolts, seven nuts and Y-pipe assembly from vehicle.
  1. Disconnect vehicle speed sensor electrical connector.
  1. Remove vehicle speed sensor retaining bolt and vehicle speed sensor (VSS) (9E731) from transaxle.
  1. To install, reverse Removal procedure. Tighten VSS retaining bolt to 3.4-4.5 Nm (31-39 lb-in). Tighten Y-pipe assembly nuts and bolts to 34-46 Nm (26-34 lb-ft).
97e3531.gif

Apr 04, 2009 | 1993 Ford Taurus

2 Answers

1995 Ford SHO


your best bet for a diagram is to ask for a suspension printout at your local dealership. Or take a look under any 86-95 Ford Taurus SLO, SHO, or Sable and they use the same design (the SHO just uses slightly different parts. Here is a link though for a SHO parts list with part numbers. Hope this helps.

http://members.bellatlantic.net/~rbruce/SHOParts.htm

Mar 12, 2009 | 1995 Ford Taurus

1 Answer

1993 Ford Taurus - OBD Plug in


the plug is located infront of the passenger seat on the firewall. there is a small square plug and a bigger triangular plug that are connected. i have a taurus 93 sho.

Mar 01, 2009 | 1993 Ford Taurus

Not finding what you are looking for?
2001 Chevrolet Silverado Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...